Precautions
On safety
•Should any solid objects or liquid fall into the CD player, unplug it and have it checked by qualified personnel before operating it any further.
•Do not put any foreign objects in the DC IN 4.5 V (external power input) jack.
On power sources
•When you are not using the CD player for a long time, disconnect all power sources from the CD player.
On the AC power adaptor
•Use only the AC power adaptor supplied. If your player is not supplied with an AC power adaptor, use an AC-E45HG AC power adaptor*. Do not use any other AC power adaptor. It may cause a malfunction.
Polarity of the plug
*Not available in Australia and some other regions. Ask your dealer for detailed information.
•Do not touch the AC power adaptor with wet hands.
•Connect the AC power adaptor to an easily accessible AC outlet. Should you notice an abnormality in the AC power adaptor, disconnect it from the AC outlet immediately.
On dry batteries
•Do not throw the batteries into fire.
•Do not carry the batteries with coins or other metallic objects. It can generate heat if the positive and negative terminals of the battery are accidentally contacted by a metallic object.
•Do not mix new batteries with old ones.
•Do not use different types of batteries together.
•When the batteries are not to be used for a long time, remove them.
•If battery leakage occurs, wipe off any deposit in the battery compartment, and install new batteries. In case the deposit adheres to you, wash it off thoroughly.
On the CD player
•Keep the lens on the CD player clean and do not touch it. If you do so, the lens may be damaged and the CD player will not operate properly.
•Do not put any heavy object on top of the CD player. The CD player and the CD may be damaged.
•Do not leave the CD player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or sand, moisture, rain, mechanical shock, unleveled surface, or in a car with its windows closed.
•If the CD player causes interference to the radio or television reception, turn off the CD player or move it away from the radio or television.
•Discs with non-standard shapes (e.g., heart, square, star) cannot be played on this CD player. Attempting to do so may damage the CD player. Do not use such discs.
On headphones
Road safety
Do not use headphones while driving, cycling, or operating any motorized vehicle. It may create a traffic hazard and is illegal in some areas. It can also be potentially dangerous to play your headsets at high volume while walking, especially at pedestrian crossings.You should exercise extreme caution or discontinue use in potentially hazardous situations.
Preventing hearing damage
Avoid using headphones at high volume. Hearing experts advise against continuous, loud and extended play. If you experience a ringing in your ears, reduce volume or discontinue use.
Consideration for others
Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate to the people around you.
To clean the plugs
If the plugs become dirty, there is no audio or noise is heard. Clean them with a dry soft cloth periodically.
Troubleshooting
Should any problem persist after you have made these checks, consult your nearest Sony dealer.
“Hold” appears in the display when you press a button, and the CD does not play.
The buttons are locked. Slide HOLD back.
The volume does not increase even if you press VOL + repeatedly.
Press and hold SOUND/AVLS until “AVLS” flashes once so that you can cancel the AVLS function.
The CD player does not operate properly.
Moisture condensation has occurred. Leave the player aside for several hours until the moisture evaporates.
Specifications
CD player
System: Compact disc digital audio system
Laser diode properties:
Emission duration: Continuous
Laser output: Less than 44.6 µW (This output is the value measured at a distance of 200 mm from the objective lens surface on the optical pick-up block with 7 mm aperture.)
Radio
Frequency range
• USA/Latin American models
9 kHz step:
FM: 87.5 - 108.0 MHz
AM: 531 - 1 710 kHz 10 kHz step:
FM: 87.5 - 108.0 MHz
AM: 530 - 1 710 kHz
• Other models
9 kHz step:
FM: 87.5 - 108.0 MHz
AM: 531 - 1 602 kHz 10 kHz step:
FM: 87.5 - 108.0 MHz
AM: 530 - 1 710 kHz
Antennas
FM: Headphones cord antenna AM:Built-in ferrite bar antenna
General
Power requirements:
•Two LR6 (size AA) batteries: 1.5 V DC × 2
•AC power adaptor (DC IN 4.5 V jack): 220 V, 50 Hz (Model for China)
120 V, 60 Hz (Model for Mexico)
Dimensions (w/h/d) (without projecting parts and controls):
Approx. 139.8 × 27.9 × 139.8 mm (5 5⁄8 × 1 1⁄8 × 5 5⁄8 in.) Mass (excluding accessories): Approx. 207 g (7.4 oz.)
Operating temperature: 5°C - 35°C (41°F - 95°F)
Design and specifications are subject to change without notice.
Supplied accessories
Headphones (1)
AC power adaptor (1) (Asian models only)
2-631-685-13 (1)
FM/AM
Portable CD Player
Operating Instructions
“WALKMAN” is a registered trademark of Sony Corporation to represent Headphone Stereo products. 
is a trademark of Sony Corporation.
D-FJ003
D-FJ0030
D-FJ003FP 
©2005 Sony Corporation Printed in China
Printed on 100 % recycled paper using VOC (Volatile Organic Compound)-free vegetable oil based ink.
WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.
To prevent fire, do not cover the ventilation of the apparatus with newspapers, tablecloths, curtains, etc. And don’t place lighted candles on the apparatus.
To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus.
CAUTION
The use of optical instruments with this product will increase eye hazard.
Certain countries may regulate disposal of the battery used to power this product. Please consult with your local authority.
For the customers who purchased this product in the USA
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
Loading...