Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of
the device.
Käännä ennen lukemista kuvallinen sivu esiin ja tutustu seuraavaksi laitteen kaikkiin toimintoihin.
Vik ut bildsidan och ha den till hands när du läser igenom anvisningarna och gör dig bekant med
apparatens / maskinens funktioner.
Før du læser, vend siden med billeder frem og bliv bekendt med alle apparatets funktioner.
IONIC HAIRDRYER SHTD 2200 A1
KOMPERNASS GMBH
Burgstraße 21
D-44867 Bochum
www.kompernass.com
Last Information Update · Tietojen tila · Informationsstatus
Tilstand af information:
12 / 2011 · Ident.-No.: SHTD2200A1112011-1
IONIC HAIRDRYER
Operation and Safety Notes
HÅRTORK
Bruksanvisning och säkerhetsanvisningar
IAN 71808IAN 71808
IONI-HIUSTENKUIVAIN
Käyttö- ja turvaohjeet
ION-HÅRTØRRER
Brugs- og sikkerhedsanvisninger
GB / IE Operation and Safety Notes Page 1
FI Käyttö- ja turvaohjeet Sivu 13
SE Bruksanvisning och säkerhetsanvisningar Sidan 25
DK Brugs- og sikkerhedsanvisninger Side 37
1
2
7
6
5
4
3
8
Index
Information for these operating instructions . . . . . . . . . . . . . . . . . . . . . . . . 2
These operating instructions are a component of the Hair Dryer SHTD 2200 A1
(henceforth designated as the appliance) and they provide you with important
information about the intended use, safety and connection as well as operation
of the appliance.
These operating instructions must be constantly kept available close to the appliance. They are to be read and applied by everyone assigned to operate and
eliminate faults in the appliance.
Keep these operating instructions and hand them over with the appliance to any
future owners.
Copyright
This documentation is copyright protected.
Any copying or reproduction of it, including as extracts, as well as the reproduction
of images, also in an altered state, is only permitted with the written authorisation
of the manufacturer.
Intended use
This hair dryer is intended only for the drying and shaping of human hair, under
no circumstances is it to be used for wigs and hairpieces made of synthetic
material. This hair dryer is intended for domestic use only. Pay heed to all of the
information in this operating manual, especially the safety instructions. This appliance is not designed for use in commercial or industrial applications.
This appliance is not intended for any other use or for uses beyond those mentioned herein. Claims of any kind for damage resulting from unintended use will
not be accepted. The operator alone bears liability.
2
SHTD 2200 A1
Safety instructions
RISK OF ELECTRIC SHOCK
► Connect the hair dryer only to a correctly
installed mains power socket providing electrical energy at the level detailed on the rating
plate.
► Under no circumstances may the hair dryer be
submerged in fl uids, or fl uids be permitted to
enter the appliance housing. Do not expose
the appliance to humidity and do not use it
outdoors. Should liquids enter the housing, disconnect the appliance from the power source
immediately and arrange for it to be repaired
by a qualifi ed technician.
► Disconnect the hair dryer from the mains pow-
er socket if defective operation is apparent
and before cleaning it.
GB
IE
► To disconnect it, pull only on the plug itself,
not on the power cable.
► Do not wrap the power cable around the ap-
pliance and protect the cable from being damaged.
SHTD 2200 A1
3
GB
IE
RISK OF ELECTRIC SHOCK
► Should the power cable of the appliance be
damaged, to avoid potential risks it must be
replaced by the manufacturer, his customer
service or by a qualifi ed technician.
► Do not kink or crush the power cable and lay
it in such a way as to prevent people from
stepping on or tripping over it.
► Do not use extension cables.
► Never touch the hair dryer, the power cable
or the plug with wet hands.
► Disconnect the hair dryer from the power
source immediately after use. The appliance is
completely free of electrical power only when
you unplug it.
► You are not permitted to open or repair the hous-
ing of the hair dryer. Should you do so, appliance safety can no longer be assured and the
warranty will become void. Arrange for the
hair dryer to be serviced and repaired only by
qualifi ed specialists.
4
SHTD 2200 A1
RISK OF ELECTRIC SHOCK
Never use the appliance near water, particularly not near sink
s, baths or other vessels.
The proximity of water presents a risk, even
when the appliance is switched off . After
use, always disconnect the plug from the
mains power socket. As additional protection, the installation of a faulty-current protection unit with an activation power rating
of not more than 30 mA is recommended for
the power circuit in the bathroom. Consult
your electrician for advice.
WARNING!
RISK OF PERSONAL INJURY!
► This appliance can be used by children aged
from 8 years and above and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved.
GB
IE
► Children shall not play with the appliance.
► Cleaning and user maintenance shall not be
made by children without supervision.
SHTD 2200 A1
5
GB
IE
WARNING!
RISK OF PERSONAL INJURY!
► When it is switched on, NEVER lay the hair
dryer down or leave it unsupervised.
► Never place the hair dryer close to sources of
heat and protect the power cable against potential damage.
► Do not take the hair dryer into use if it has fall-
en down or is damaged in any way.
Arrange for the appliance to be checked and/
or repaired by qualifi ed technicians.
► Do not cover the air intake grill while operat-
ing the appliance. Clean the grill at regular
intervals.
► The hair dryer becomes hot when it is in use.
Hold it only by the grip when it is hot.
Items supplied
The appliance is delivered with the following components as standard:
Remove all parts of the appliance and the operating instructions from the
carton.
2) Remove all packaging material.
3) Clean all parts of the appliance as described in the section “Cleaning”.
6
SHTD 2200 A1
NOTICE
► Check the contents to make sure everything is there and for visible damage.
► If the contents are not complete or are damaged due to defective packaging
ough transportation, contact the Service Hotline (see section "War-
or thr
ranty and Service").
Disposal of the packaging
The packaging protects the appliance from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material
and reduces the amount of waste generated. Dispose of packaging material that
is no longer needed according to the regionally established regulations.
NOTICE
► If possible preserve the appliance's original packaging during the warranty
period so that, in the e
pliance ideally for its return.
vent of a warranty claim, you can package the ap-
Technical data
Mains voltage230 - 240 V ~, 50 Hz
Nominal power2000 - 2200 W
2) Switch the hair dryer on with the blower level switch 5.
The hair dryer is fi tted with two function switches. With these you can separately
select the strength of the air fl ow ( Blower switch 5) and the level of heat ( Heat
level switch 6):
Blower levels
O The hair dryer is switched off
reduced air fl ow
full power air fl ow
Heat levels
cold air fl ow
low heating level
high heating level
3) After use, switch the appliance off in that you place the blower switch 5 into
position “O”. Then remove the plug from the wall socket.
Cooling level
With the cool level switch 7 ❄ you can produce a cooler air fl ow with every
combination of blower and heat levels.
Ionisation function
With the Ionic switch-in 4 you can additionally add the ionic function to every
combination of blower and heat level.
When drying the hair using a hair dryer, the hair takes on a static charge and
begins to “fl y”.
The ionisation function ensures that this charging of the hair is neutralised and
cancelled. The hair becomes soft, supple, shiny and easier to style.
8
SHTD 2200 A1
Drying and styling hair
■ To quickly dry hair, we recommend fi rst of all using a high blower and heater
setting for a short period. Also, place the Ionic switch-in 4 at the position
“
shape the hairstyle.
■ With the supplied styling jet 1 y
and style your hair. Place the styling jet 1 on the front of the hair dryer such
that it engages and is seated fi rmly into place.
■ If you want to dry your hair very gently, or use the dryer with so-called “air-
dried perms”, attach the fi
it is fi tted, and then attach the fi nger diff usor 8, such that it engages and is
seated fi rmly into place.
■ Before you comb your hair out, allow it to cool so that the shaping and styling
c
■ For cooling the hair you can use the cooling level button 7
of the heat level switch 6.
”. After drying the hair, switch to a lower blower and heat level to
nger diff user 8. First remove the styling jet 1, if
an retain its form.
Cleaning
RISK OF ELECTRIC SHOCK
► Always remove the mains plug from the socket before you clean the appliance.
► Under no circumstances may you immerse the appliance in water or other
liquids when cleaning it!
► After being cleaned, the hair dryer must be completely dry before using it
again.
ou can apply a directed airfl ow to shape
or level
❄
GB
IE
WARNING - RISK OF PHYSICAL INJURY!
► Allow the appliance to cool suffi
CAUTION - PROPERTY DAMAGE!
► Do not use any aggressive cleaning liquids or solvents. They could damage
face.
the sur
Cleaning the housing
■ Use a soft cloth lightly moistened with a mild soap solution to clean the housing
and attachments.
SHTD 2200 A1
ciently before cleaning it.
9
GB
IE
Cleaning the air suction grill
WARNING - RISK OF FIRE!
► Clean the ventilation grill 2 at r
1) Turn the air intake grille 2 slightly so that it can be removed from the hairdryer.
2) Clean the openings of the air intake grill 2 with a soft brush.
3) Replace the air intake grille 2 back onto the hair dryer so that the lugs on
the air intake grille 2 engage in the slots on the housing of the hairdryer.
Turn the air intake grille 2 slightly so that it engages and is fi rmly seated on
the housing.
Storage
CAUTION - PROPERTY DAMAGE!
► First pack and transport the hair dryer when it has completely cooled
wn. Otherwise, it could damage other items.
do
■ Clean the hair dryer as described in the section “Cleaning”.
■ For storage purposes, you can hang the hairdryer up by the suspension
loop 3.
■ Store the hair dryer at a dustfree and dry location.
Troubleshooting
Should your hair dryer not function as expected, fi rst remove the plug from the
mains power socket and allow the appliance to cool down for a few minutes.
The appliance is fi tted with an overheating protector!
Should the appliance still not function, consult the service department detailed
under “Service”.
egular intervals with a soft brush.
Disposal of the device
Do not dispose of this appliance in your normal domestic waste.
This product is subject to the provisions of European Directive
2002/96/EC.
Dispose of the appliance through an approved disposal centre or at your com-
munity waste facility.Pay heed to the currently applicable regulations. In case of
doubt, please contact your waste disposal centre.
10
SHTD 2200 A1
Warranty
A 3-year warranty is given with this device, starting from the date of purchase.
The appliance has been manufactured with care and meticulously examined
before delivery.
Please retain your receipt as proof of purchase. In the case of a warranty claim,
please make contact by telephone with our service department. Only in this way
can a post-free despatch for your goods be assured.
NOTICE
► The warranty covers only claims for material and manufacturing defects, it
This appliance is intended solely for domestic, not commercial, use. If this product
has been subjected to improper or inappropriate handling, abuse, or modifi cations not carried out by one of our authorised service centres, the warranty will
be considered void.
Your statutory rights are not restricted in any way by this warranty. The warranty
period is not extended by repairs made under the warranty. This applies also to
replaced and repaired parts.
Damages and defects extant at the time of purchase must be reported immediately after unpacking, resp. no later than two days after the date of purchase.
Repairs made after the lapse of the warranty period are subject to charge.