LG Electronics LDG3035SB, LDG3035SW, LDG3031ST, LDG3017ST, LDG3037ST User Manual

ENGLISH

ESPAÑOL

INSTALLATION MANUAL

GAS DOUBLE OVEN
RANGE

Please read this guide thoroughly before installation.

LDG3017ST
LDG3016ST
LDG3015ST/SB/SW
LDG3011ST

MFL62177703

(REV.08 150223)

LDG3037ST
LDG3036ST
LDG3035ST/SB/SW
LDG3031ST

LDG3036BD

www.lg.com

2

INSTALLATION INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE INSTALLATION

INSTALLATION SAFETY INSTRUCTIONS

BEFORE YOU BEGIN

Read these instructions completely
and carefully.

Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54,
latest edition. In Canada, installation must
conform with the current Natural Gas Installation
Code, CAN/CGAB149.1 or the current Propane
Installation Code, CAN/CGA-B149.2, and with
local codes where applicable. This range has been
design-certified by CSA International according
to ANSI Z21.1, latest edition and Canadian Gas
Association according to CAN/CGA-1.1 latest
edition.

As with any appliance using gas and generating
heat, there are certain safety precautions you
should follow. You will find these precautions in the
lmportant Safety Information section in your User’s
Guide. Read them carefully.

• IMPORTANT – Save these instructions

for local electrical inspector’s use.

• IMPORTANT– Observe all governing

codes and ordinances.

Note to Installer: Leave these instructions with
the appliance after installation is completed.

Note to Consumer: Keep the User’s Guide and
Installation Instructions for future reference.

NOTE: This appliance must be properly

grounded.

• The electrical diagram is in an envelop attached

to the back of the range.

• Skill level – Installation of this appliance requires

basic mechanical skills.

• Proper installation is the responsibility of

theinstaller.

• Product failure due to improper installation is not

covered under the Warranty.

• Remove all tape and packaging.

• Make sure the burners are properly seated and

level.

• Take the accessory pack out of the oven and/or

drawer.

• Check to be sure that no range parts have come

loose during shipping.

3

ENGLISH

INSTALLATION INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE INSTALLATION

INSTALLATION SAFETY INSTRUCTIONS (continued)

BEFORE YOU BEGIN

Remove all tape and packing materials before using the range. Dispose of all plastic bags after
unpacking the range. Never allow children to play with packing materials.

IMPORTANT SAFETY INSTRUCTIONS

Read these instructions completely and carefully. Improper installation, adjustment, alteration,
service or maintenance can cause injury or property damage. Refer to this manual. For assistance or

additional information, consult a qualified installer, service agency, manufacturer (dealer) or the gas

supplier.

This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or
hurt you and others. All safety messages will follow the safety alert symbol and either the
word “WARNING” or “CAUTION”.

WARNING

CAUTION

WARNING: If the information in

this manual is not followed exactly, a fire or
explosion may result causing property damage,
personal injury or death.

– DO NOT store or use combustible materials,

gasoline or other flammable vapors and liquids

in the vicinity of this or any other appliance.

This symbol will alert you to hazards or unsafe practices which could

cause serious bodily harm or death.

This symbol will alert you to hazards or unsafe practices which could
cause bodily injury or property damage.

WHAT TO DO IF YOU SMELL GAS

• DO NOT try to light any appliance.

• DO NOT touch any electrical switch.

• DO NOT use any phone in your building.

• Immediately call your gas supplier from a

neighbor’s phone. Follow the gas supplier’s
instructions.

• If you cannot reach your gas supplier, call

the fire department.

Installation and service must be performed

by a qualified installer, service agency or

the gas supplier.

4

INSTALLATION INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE INSTALLATION

INSTALLATION SAFETY INSTRUCTIONS (continued)

- If the range is pulled away from the wall for

WARNING!

• ALL RANGES CAN TIP

• INJURY TO PERSONS COULD

RESULT

• INSTALL ANTI-TIP DEVICES
PACKED WITH RANGE

• SEE INSTALLATION
INSTRUCTIONS

• DO NOT step or sit on the door. Install the Anti­Tip Bracket packed with range.

- The range could be tipped and injury might result

from spilled hot liquid, food, or the range itself.

cleaning, service, or any other reason, ensure that
the Anti-Tip Device is properly reengaged when the
range is pushed back against the wall.

All ranges can tip and injury could result. To prevent
accidental tipping of the range, attach an approved

Anti-Tip device to the wall. (See “INSTALLING THE
ANTI-TIP DEVICE” in this manual.) To check if the

device is installed and engaged properly, carefully tip
the range forward. The Anti-Tip device should engage
and prevent the range from tipping over.
If you pull the range out from the wall for any reason,
make sure the Anti-Tip device is engaged when you
push the range back against the wall.

WARNING!

• NEVER reuse old flexible connectors. The use of

old flexible connectors can cause gas leaks and
personal injury. Always use NEW flexible connectors
when installing a gas appliance.

• Your range must be installed by a qualified installer.

• Your range should be electrically grounded in

accordance with local codes or, in the absence
of local codes, in accordance with the National

Electrical Code (ANSI/NFPA 70, latest edition). In

Canada, electrical grounding must comply with
the current CSA C22.1 Canadian Electrical Code
Part 1 and/or local codes. See “ELECTRICAL
CONNECTIONS” in this manual.

• Before installing your range on linoleum or any
other synthetic floor covering, make sure the floor

covering can resist 180°F(82°C) without shrinking,

warping or discoloring. Do not install the range over
carpeting unless a sheet of 1/4” thick plywood or
similar insulator is placed between the range and
carpeting.

• Make sure the wall coverings around the range can
resist heat generated by the range up to 200°F

(93°C).

• Leak testing of the appliance shall be conducted
according to the manufacturer’s instructions.

• Avoid placing cabinets above the range. To minimize
the hazard caused by reaching over the open flames
of operating burners, install a ventilation hood over

the range that projects forward at least 5” beyond
the front of the cabinets.

• The ventilation hood must be constructed of sheet
metal not less than 0.0122” thick. Install above

the cooktop with a clearance of not less than
1/4” between the hood and the underside of the
combustible material or metal cabinet.
The hood must be at least as wide as the appliance
and centered over the appliance.
Clearance between the cooking surface and the

ventilation hood surface MUST NEVER BE LESS
THAN 24 INCHES.

EXCEPTION: Installation of a listed microwave oven

or cooking appliance over the cooktop shall conform

to the installation instructions packed with that
appliance.

• If cabinets are placed above the range, allow a

minimum clearance of 30” between the cooking
surface and the bottom of unprotected cabinets.

desprotegidos.

5

ENGLISH

INSTALLATION INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE INSTALLATION

INSTALLATION SAFETY INSTRUCTIONS (continued)

WARNING!

• If a 30” clearance between cooking surface and
overhead combustible material or metal cabinets

cannot be maintained, protect the underside of

the cabinets above the cooktop with not less than
1/4” insulating millboard covered with sheet metal

not less than 0.0122” thick. Clearance between
the cooking surface and protected cabinets MUST

NEVER BE LESS THAN 24 INCHES.

CAUTION

• Items of interest to children should not be stored

in cabinets above a range or on the backsplash of
a range—children climbing on the range to reach
items could be seriously injured.

• The vertical distance from the plane of the cooking
surface to the bottom of adjacent overhead
cabinets extending closer than 1” to the plane of
the range sides must not be less than 18”. (See

the Dimensions and Clearances illustration in this
manual.)

• DO NOT attempt to operate the oven of this range
during a power failure.

IN THE COMMONWEALTH OF MASSACHUSETTS

• This product must be installed by a licensed plumber or
gas fitter.

• When using ball type gas shut-off valves, they shall be

the T-handle type.

• When using a flexible gas connector, it must not exceed
3 feet in length.

PREPARING FOR INSTALLATION

TOOLS YOU WILL NEED MATERIALS YOU MAY NEED

• Gas line shut-off valve

Phillips screwdriver

Flat-blade screwdriver

Pencil and ruler

Open-end or

adjustable wrench

Pipe wrench(2)

(one for support)

Level

• Pipe joint sealant that resists action of natural and LP gases.

• Flexible metal appliance connector (3/4” or 1/2” NPT x 1/2”

I.D.)

Never use an old connector when installing a new range.

• Flare union adapter for connection to gas supply line (3/4” or
1/2” NPT x 1/2” I.D.)

• Flare union adapter for connection to pressure regulator on
range (1/2” NPT x 1/2” I.D.)

• Liquid leak detector or soapy water.

• Lag bolt or 1/2” O.D. sleeve anchor (for concrete floors only).