LD-2131SH
DISHWASHER
Please read this manual carefully before operating your
dishwasher. Retain it for future reference.
OWNER'S MANUAL
MODEL : LD-2130(1)W(S,M)H
LD-2130(1)W(S,M)HB
LD-2130(1)W(S,M)HU
CONTENTS
SAFETY AND CAUTION 3
INSTALLATION INSTRUCTIONS 5
PARTS NAME 9
FUNCTION OF CONTROL BUTTON 10
HOW TO USE AND OPERATE 11
OPERATING SEQUENCE 17
PROGRAM 18
USER MAINTENANCE INSTRUCTIONS 19
TROUBLE SHOOTING GUIDE 20
SPECIFICATION
SAFETY AND CAUTION
• Please read this manual carefully before
using the dishwasher for the first time.
• This manual contains very important
notes regarding the installation, use and
maintenance of your dishwasher.
• The manufacturer can not be
responsible for problems caused by
ignoring these safety and caution
instructions.
• This dishwasher is designed for normal
household use.
• Do not use the dishwasher for industrial
and commercial use, or other purpose.
• The appliance is not intended for use
by young children or infirm persons
without supervision.
During installation
• Electrical connection must be in
accordance with the rating label.
• Electrical safety is only guaranteed
when the earth system of your house is
in accordance with the related local
regulations.(Do not use an extension
cable or cord.)
• If the hot water exceeds 65ºC, adjust
the water heater setting. If the hot water
temperature can not be maintained
below 65ºC, the dishwasher must be
connected to cold water.
• If power supply cord is damaged, it
must only be replaced by the
manufacturer or its service agent or a
similar qualified person in order to
avoid a hazard.
• This appliance must be positioned so
that the plug is accessible.
• The appliance is to be connected to the
water mains using new hose-sets and
that old hose-sets should not be reused.
During use
• Only suitable household utensils should
be placed in the dishwasher.
(Please avoid utensils; that are nonheatresistant, metal decorated, etc.)
• Do not use any kinds of solvent in your
dishwasher. They may cause an
explosion or fire.
• Do not spray water on the appliance.
It may cause the failure of electric parts
or electric shock.
• Do not push down or sit on the inner
door when the door opened. It may
cause the deformation or failure of your
dishwasher.
• Do not use the detergent for hand
washing.
The detergent for dishwasher should be
used for normal operation.
• This appliance is fitted with a safety
function that automatically stops the
operation of the dishwasher when it is
exposed to heavy disturbance on its
mains.
• Dishwasher detergents are strongly
alkaline. They can be extremely
dangerous if swallowed. Avoid contact
with skin and eyes and keep children
away from the dishwasher when the
door is open.
Check that the detergent receptacle is
empty after completion of the wash
cycle.
IMPORTANT SAFETY INSTRUCTIONS
WARNING - When using your dishwasher, follow basic precautions,
including the following:
3
4
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of a malfunction or breakdown,
grounding will reduce the risk of electric shock by providing a path of least
resistance for electric current. This appliance is equipped with a cord having an
equipment-grounding conductor and a grounding plug. The plug must be plugged
into an appropriate outlet that is installed and grounded in accordance with all
local codes and ordinances.
WARNING - Improper connection of the equipment-grounding conductor can
result in a risk of electric shock. Check with a qualified electrician or
service representative if you are in doubt whether the appliance is
properly grounded. Do not modify the plug provided with the
appliance; if it will not fit the outlet have a proper outlet installed by a
qualified electrician.
SAVE THESE INSTRUCTIONS
SAFETY AND CAUTION
Child Safety
• Controls may be locked using “Child Lock” mode to prevent from all the setting from being
changed by a child.
• Keep children away from detergents and rinse-aids.
• Do not allow children to operate the dishwasher.
• Young children should be supervised to ensure that they do not play with the appliance.
concerning the Power Cord
Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet
circuit which powers only that appliance and has no additional outlets or branch circuits. Check
the specification page of this owner's manual to be certain.
Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension
cords, frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these
conditions could result in electric shock or fire. Periodically examine the cord of your appliance,
and if its appearance indicates damage or deterioration, unplug it, discontinue use of the
appliance, and have the cord replaced with an exact replacement part by an authorized servicer.
Protect the power cord from physical or mechanical abuse, such as being twisted, kinked,
pinched, closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and the
point where the cord exits the appliance.
The instructions shall state the substance of the following :
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
CAUTION
CAUTION
Unit:mm
Step 1 :
PREPARE CUPBOARD OPENING
Step 2 :
PREPARATION FOR ELECTICAL WIRING
1
2
3
This appliance must be supplied with
correct rating voltage and hertz as shown
on instruction manual, and connected to
an individual, properly earthed branch
circuit, protected by a minimum 15 amp
circuit breaker or time delay fuse.
Wiring must be 2 wire with Earth.
The power plug must be in a accessible
location adjacent to and not behind the
dishwasher and within 1.2 meters of the
dishwasher side.(See page 7 Fig.A)
The power plug must be correctly
earthed, if in doubt, have it checked by a
qualified Electrician. No other appliance
should be connected to the same plug
outlet by a double adapter or similar
plug.
CAUTION
For personal safety, remove house fuse
or open circuit breaker before installation.
Do not use an extension cord or adapter
plug with this appliance. Electrical and
earthing connections must comply with
the national electrical code/provincial and
municipal code and/or other local codes.
Any bare wood surrounding the dishwasher
should be sealed with a waterproof paint or
sealant to prevent swelling.
INSTALLATION INSTRUCTIONS
WARNING
A qualified electrician/plumber or
competent person should carry out any
electrical/plumbing work required to
install this appliance.
1
2
3
4
This dishwasher is designed to fit the size
shown as below.
Select a location as close to sink as
possible for ease of connection to the
water and drain pipes.
To ensure good drainage, the dishwasher
should not be installed more than 3 meters
away from the sink.
If dishwasher is installed in a corner, a
minimum of 5cm of space is required
between the washer and an adjacent
cabinet or wall.
5
Dangerous voltage
To indicate hazards arising from
dangerous voltages.
Note – In case of application in a
warning sign the rules according
to ISO 3864 shall be adhered to.
5036
INSTALLATION INSTRUCTIONS
6
Step 3 :
PREPARING THE DISHWASHER
FOR INSTALLATION
1
2
Lay the dishwasher on its back.
Adjust the legs to the required height
as shown in below figure.
Step 4 :
INST ALLING THE DISHW ASHER
IN CUPBOARD
1
2
Before sliding the dishwasher into the
cupboard opening, all necessary height and
balancing adjustments should be made
using a spanner.
Slide the dishwasher into the cabinet
opening carefully. Make sure that the
drain hose inside the cabinet is not
kinked or stretched.
CAUTION
If the height of the cupboard is below 850mm,
you should remove the top table by
unscrewing the 2 screws. (Two of rear)
Step 5 :
DRAIN LINE CONNECTION
1
2
If the end of drain hose does not fit to
the drain line, use a rubber
connector(not supplied) that is
resistant to heat and detergent.
This should be available from a
plumbing shop or DIY merchants.
There are two typical connections as
shown in Figure A, B.
The “S” trap spigot must be drilled out
cleanly and free of obstruction to its
maximum internal diameter, if used for
drainage.
To prevent siphoning, one of the following
methods must be used:
■ When the drain hose is connected to a
sink “s” trap or waste disposal unit, the
hose must be looped up to the underside
of the bench top and secured.
■ When the drain hose is connected to a
separate standpipe, it is essential that an
airtight connection be made.
Refer to Fig.B
Drain hose Extension
Extend drain hose as shown below.
Fig. A
Fig. B : Drainage connection - stand pipe.
INSTALLATION INSTRUCTIONS
CAUTION
When you connect or extend drain hose,
make sure that drain hose is not kinked.
(Bends should have a 40 mm radius.)
7
INSTALLATION INSTRUCTIONS
8
Step 6 :
WATER SUPPLY CONNECTION
1
2
Connect the water supply hose to the
water tap as shown.(Some models consist
of an inlet valve and hose.)
This dishwasher may be fed with either
hot or cold water. If the water can not be
maintained below 65ºC, the dishwasher
must be connected to cold water.
When connecting, the sealant tape or
sealing compound to avoid water leaks.
Make sure that the line is not kinked or
sharply bent.
Water tap
Water supply
hose
Step 7 :
FINAL CHECK AND ASSEMBLING
1
2
Securely hand tighten supply hose to the
water supply .
Plug the power supply cord into an
earthed electrical point and switch on.
After installing and prior to using the
dishwasher with crockery , we
recommend that you use the dishwasher
on
‘Quick’mode to rinse through. At
this stage it is useful to ensure that there
are no operating problems or water leaks.
When the dishwasher is used for the first,
there may be a loud noise, if this
happens, turn off the power and restart
the dishwasher .
Step 8 :
HOW TO LEVEL THE DISHWASHER
After installing the dishwasher, you may notice
a slight sticking of the door to the dishwasher ,
when you open or close the door. If this does
happen you need to adjust the level of the
dishwasher.
• If the door slants to the right, see fig, C and
follow these instructions:
1) Unscrew(counter-clockwise) the left leg of
the back side and correct the level.
2) Check the opening of door and repeat if
necessary until the door opens and closes
properly.
• When the product is correctly leveled, There
should be no slant , stickiness or friction sound.
• If the door slants to the left, see fig. D and
follow these instructions:
1) Check the opening of door if there still
remains sticky or friction sound.
2)
Check the opening of door and repeat if
necessary until the door opens and closes
properly.
• When the product is correctly leveled, There
should be no slant , stickiness or friction
sound.
Fig. C
Fig. D
Case 1. In case the door is slanted to the right
Case 2. In case the door is slanted to the left
Loading...