JJW8627BAB
www.dexpress.com DIMENSION EXPRESS Fax on Demand (775) 833-3600
This Data Sheet Includes Information On
Jenn-Air
• Product Model Number (s): •
27" Electric Double Ovens:
JJW8627BAB and JJW8627BAW
• Dimensions (Actual Size) •
Cutout width:
Cutout height:
Minimum cabinet width:
Minimum cabinet depth:
Recommended cutout location from floor :
25 1/2"
49 5/8"
27"
24"
4" to 12"
Distance from face of cabinet to
outer edge of open doors (door swing):
20 1/2"
Distance from face of cabinet to
front of closed door handle:
Overall unit width:
Overall unit height:
Penetration into cabinet:
15/16"
26 3/4"
49 15/16"
23 1/2"
Oven overlap distances when using
cutout dimensions listed above:
Top overlap:
Bottom overlap:
Right side overlap:
3/16"
0"
5/8"
Left side overlap: 5/8"
• Additional Information •
• Cutout height and width are ± 1/16".
• Cutout in cabinet should be level and straight. There
are no provisions to level the unit after it is installed.
• Construct 5/8" minimum plywood floor flush with
bottom of opening. Floor must be level and straight and
capable of supporting 250 lbs.
• A three-wire, single phase, A.C. 120/208-240 volt,
60Hz cycle electrical system must be provided (Load
30 amps @ 120/240VAC). 40 amp circuit
recommended. 7/8" O.D. flexible cable 4 feet long is
furnished by manufacturer. Mount junction box in area
under plywood floor if adequate lower cabinet space is
available. Locate 1 1/4" conduit access hole in the
back right hand side of the plywood floor.
• For European style cabinets (flush front) the required
clearance for operation of the oven door is a minimum
spacing of 7/8" between the cutout and the door, hinge
or drawer of the cabinet.
Cabinet Opening
(not to scale)
Mount receptacle on
back wall in the
center of cavity
below oven opening
and within 3" of oven
bottom (shaded
area).
27"
25 1/2"
24"
49 5/8"
4" to 12"
Overall Dimensions
(not to scale)
49 15/16"
23 1/2"
26 3/4"
15/16"
Subject to change without notice. This system is designed to
be updated daily if necessary. Dimension Express is not
responsible for use of superseded, voided, or outdated data
sheets. Because of the difficulty or impracticability of determining actual damages, liability of Dimension Express shall
not exceed $50.00.
Copyright © Dimension Express, 2001.
• NEVER reuse Data Sheets. Data Sheets are subject to change without • Call Dimension Express if you have any questions at (775) 833-3633 •
notice. Dimension Express is a FREE service bureau and is updated daily, • Always refer to a current Code at a Glance or manufacturer directory •
it makes far more sense to spend the time necessary to request new Data • Data Sheet codes change on the first of odd numbered months at 12:01am •
Sheets for each project, as opposed to the problems, time, costs, and risks
associated with reusing old Data Sheets.
239
BN207.5 • A239 • • 011104 • 154251 • 67438
Loading...