Interlogix TVB-1103, TVB-1104, TVD-3101, TVD-3102, TVD-3103 User Manual

TruVision 11/31

Series IP Camera

Installation Guide

P/N 1072857-EN • REV C • ISS 05MAY15

Copyright	© 2015 United Technologies Corporation,
	Interlogix is part of UTC Building & Industrial
	Systems, a unit of United Technologies
	Corporation. All rights reserved.
Trademarks and	Trade names used in this document may be
patents	trademarks or registered trademarks of the
	manufacturers or vendors of the respective
	products.
Manufacturer	Interogix
	2955 Red Hill Avenue, Costa Mesa, CA 92626-5923,
	USA
	Authorized EU manufacturing representative:
	UTC Fire & Security B.V.
	Kelvinstraat 7, 6003 DH Weert, The Netherlands
Certification
	N4131
FCC compliance	Class A: This equipment has been tested and found to
	comply with the limits for a Class A digital device,
	pursuant to part 15 of the FCC Rules. These limits are
	designed to provide reasonable protection against
	harmful interference when the equipment is operated in
	a commercial environment. This equipment generates,
	uses, and can radiate radio frequency energy and, if not
	installed and used in accordance with the instruction
	manual, may cause harmful interference to radio
	communications. Operation of this equipment in a
	residential area is likely to cause harmful interference in
	which case the user will be required to correct the
	interference at his own expense.
ACMA compliance	Notice! This is a Class A product. In a domestic
	environment this product may cause radio interference
	in which case the user may be required to take
	adequate measures.
Canada	This Class A digital apparatus complies with Canadian
	ICES-003.

European Union

directives

Cet appareil numérique de la classe A est conforme à la norme NMB-0330 du Canada.

12004/108/EC (EMC directive): Hereby, UTC Fire & Security declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC.

2002/96/EC (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info.

Contact information For contact information, see www.interlogix.com or www.utcfssecurityproducts.eu.

Content

Introduction 2

Product overview 2

Installation 4
Installation environment		4
Package contents	5
Cable requirements	13
Camera description	14
Setting up the camera		19
Accessing the SD card		20
Mounting the IP mini bullet camera			20
Mounting the IP VF bullet camera			22
Mounting the IP VF dome camera			27
Mounting the IP mini dome camera			31
Mounting the IP wedge dome camera 34
Using the camera with a recorder			36

Using the camera with TruVision Navigator 37

Specifications 37
TruVision IP mini bullet cameras	37
TruVision IP VF bullet cameras	37

TruVision IP mini dome 38

TruVision IP VF mini dome cameras 39 TruVision IP wedge cameras 40

Pin definitions 41

Installation Guide

1

Introduction

Product overview

This is the installation guide for TruVision 11-31 Series IP camera models:

IP mini bullet camera:

TVB-1101 (1.3MPX Bullet, 6mm lens, PAL)

TVB-3101 (1.3MPX Bullet, 6mm lens, NTSC)

TVB-1102 (3MPX Bullet, 6mm lens, PAL)

TVB-3102 (3MPX Bullet, 6mm lens, NTSC)

TVB-1103 (1.3MPX Bullet, 4mm lens, PAL)

TVB-3103 (1.3MPX Bullet, 4mm lens, NTSC)

IP VF bullet camera:

TVB-1104 (1.3MPX Bullet, 2.8 to 12mm VF Lens, PAL)

TVB-3104 (1.3MPX Bullet, 2.8 to 12mm VF Lens, NTSC)

TVB-1105 (3MPX Bullet, 2.8 to 12mm VF Lens, PAL)

TVB-3105 (3MPX Bullet, 2.8 to 12mm VF Lens, NTSC)

IP mini dome camera:

TVD-1101 (1.3MPX Plastic Mini Dome, PoE, PAL)

TVD-3101 (1.3MPX Plastic Mini Dome, PoE, NTSC)

TVD-1102 (3MPX Plastic Mini Dome, PoE, PAL)

TVD-3102 (3MPX Plastic Mini Dome, PoE, NTSC)

2	Installation Guide

TVD-1105 (1.3MPX IP IR Outdoor Mini Dome, PoE/12VDC, PAL)

TVD-3105 (1.3MPX IP IR Outdoor Mini Dome, PoE/12VDC, NTSC)

TVD-1106 (3MPX IP IR Outdoor Mini Dome, PoE/12VDC, PAL)

TVD-3106 (3MPX IP IR Outdoor Mini Dome, PoE/12VDC, NTSC)

IP VF mini dome camera:

TVD-1103 (1.3MPX VF Mini Dome, PAL)

TVD-3103 (1.3MPX VF Mini Dome, NTSC)

TVD-1104 (3MPX VF Mini Dome, PAL)

TVD-3104 (3MPX VF Mini Dome, NTSC)

IP wedge camera:

TVW-1101 (1.3MPX Wedge, 2.8mm lens, PAL)

TVW-3101 (1.3MPX Wedge, 2.8mm lens, NTSC)

TVW-1102 (3MPX Wedge, 2.8mm lens, PAL)

TVW-3102 (3MPX Wedge, 2.8mm lens, NTSC)

Installation Guide

3

Installation

This section provides information on how to install the cameras.

Installation environment

When installing your product, consider these factors:

•Electrical: Install electrical wiring carefully. It should be done by qualified service personnel. Always use a proper PoE switch or a 12 VDCUL listed Class 2 or CE certified power supply to power the camera. Do not overload the power cord or adapter.

•Ventilation: Ensure that the location planned for the installation of the camera is well ventilated.

•Temperature: Do not operate the camera beyond the specified temperature, humidity or power source ratings.

The operating temperature of the camera is between -30 to +60°C (-22 to 140°F). Humidity is below 90%.

•Moisture: Do not expose the camera to rain or moisture, or try to operate it in wet areas. Turn the power off immediately if the camera is wet and ask a qualified service person for servicing. Moisture can damage the camera and also create the danger of electric shock.

•Servicing: Do not attempt to service this camera yourself. Any attempt to dismantle or remove the covers from this product will invalidate the warranty and may also result in serious injury. Refer all servicing to qualified service personnel.

•Cleaning: Do not touch the sensor modules with fingers.

If cleaning is necessary, use a clean cloth with some ethanol and wipe the camera gently. If the camera will not

4	Installation Guide

be used for an extended period of time, put on the lens cap to protect the sensors from dirt.

Package contents

Check the package and contents for visible damage. If any components are damaged or missing, do not attempt to use the unit; contact the supplier immediately. If the unit is returned, it must be shipped back in its original packaging.

IP mini bullet camera

Camera

Installation manual	CD with Configuration
	manual and TruVision
	Device Finder

Installation Guide

5

Template

Water joint: provides water resistance to network connection.

Screws

Drywall anchor

Φ7.5 x 24.5mm (3 pcs)

Screw M4

(4 x 25mm (3 pcs)

12 VDC connector: DC jack socket to

terminal connectors with positive and negative indicators.

6	Installation Guide

IP VF bullet camera

Camera

Installation manual	CD with Configuration
	manual and TruVision
	Device Finder

Template	Screws
	Drywall anchor
	Φ7.5 x 24.5mm (4 pcs)
	Screw M4
	(4 x 25mm (4 pcs)

Installation Guide

7

Water joint: provides water	12 VDC Connector: DC
resistance to network	jack socket to
connection.	terminal connectors
	with positive and
	negative indicators.

Video test cable

Back box

Screws C: M4.8×18, 4pcs

IP mini dome camera

Camera

8	Installation Guide

Installation manual

Template

Water joint: provides water resistance to network connection.

CD with Configuration manual and TruVision Device Finder

Screws

Drywall anchor

Φ7.5 x 24.5mm (3 pcs)

Screw M4

(4 x 25mm (3 pcs)

12 VDC Connector: DC jack socket to

terminal connectors with positive and negative indicators (TVD-1105 / 3105 / 1106 / 3106 only).

Installation Guide

9

Screws B	Hex wrench
(4 x 75mm, 3pcs)

IP VF dome camera

Camera

Installation manual	CD with Configuration
	manual and TruVision
	Device Finder

10	Installation Guide

Template

Water joint: provides water resistance to network connection.

Video test cable

Screws C: M4×19, 3pcs

Screws

Drywall anchor

Φ7.5 x 24.5mm (4 pcs)

Screw M4

(4 x 25mm (4 pcs)

12 VDC connector: DC jack socket to

terminal connectors with positive and negative indicators.

Hex wrench

Adaptor

Installation Guide

11