TruVision 11/31
Series IP Camera
Installation Guide
P/N 1072857-EN • REV C • ISS 05MAY15
Copyright |
© 2015 United Technologies Corporation, |
|
Interlogix is part of UTC Building & Industrial |
|
Systems, a unit of United Technologies |
|
Corporation. All rights reserved. |
Trademarks and |
Trade names used in this document may be |
patents |
trademarks or registered trademarks of the |
|
manufacturers or vendors of the respective |
|
products. |
Manufacturer |
Interogix |
|
2955 Red Hill Avenue, Costa Mesa, CA 92626-5923, |
|
USA |
|
Authorized EU manufacturing representative: |
|
UTC Fire & Security B.V. |
|
Kelvinstraat 7, 6003 DH Weert, The Netherlands |
Certification |
|
|
N4131 |
FCC compliance |
Class A: This equipment has been tested and found to |
|
comply with the limits for a Class A digital device, |
|
pursuant to part 15 of the FCC Rules. These limits are |
|
designed to provide reasonable protection against |
|
harmful interference when the equipment is operated in |
|
a commercial environment. This equipment generates, |
|
uses, and can radiate radio frequency energy and, if not |
|
installed and used in accordance with the instruction |
|
manual, may cause harmful interference to radio |
|
communications. Operation of this equipment in a |
|
residential area is likely to cause harmful interference in |
|
which case the user will be required to correct the |
|
interference at his own expense. |
ACMA compliance |
Notice! This is a Class A product. In a domestic |
|
environment this product may cause radio interference |
|
in which case the user may be required to take |
|
adequate measures. |
Canada |
This Class A digital apparatus complies with Canadian |
|
ICES-003. |
European Union
directives
Cet appareil numérique de la classe A est conforme à la norme NMB-0330 du Canada.
12004/108/EC (EMC directive): Hereby, UTC Fire & Security declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC.
2002/96/EC (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info.
Contact information For contact information, see www.interlogix.com or www.utcfssecurityproducts.eu.
Content
Introduction 2
Product overview 2
Installation 4 |
|
|
|
Installation environment |
4 |
|
|
Package contents |
5 |
|
|
Cable requirements |
13 |
|
|
Camera description |
14 |
|
|
Setting up the camera |
19 |
|
|
Accessing the SD card |
20 |
|
|
Mounting the IP mini bullet camera |
20 |
||
Mounting the IP VF bullet camera |
22 |
||
Mounting the IP VF dome camera |
27 |
||
Mounting the IP mini dome camera |
31 |
||
Mounting the IP wedge dome camera 34 |
|||
Using the camera with a recorder |
36 |
Using the camera with TruVision Navigator 37
Specifications 37 |
|
TruVision IP mini bullet cameras |
37 |
TruVision IP VF bullet cameras |
37 |
TruVision IP mini dome 38
TruVision IP VF mini dome cameras 39 TruVision IP wedge cameras 40
Pin definitions 41
Installation Guide |
1 |
Introduction
Product overview
This is the installation guide for TruVision 11-31 Series IP camera models:
IP mini bullet camera:
TVB-1101 (1.3MPX Bullet, 6mm lens, PAL)
TVB-3101 (1.3MPX Bullet, 6mm lens, NTSC)
TVB-1102 (3MPX Bullet, 6mm lens, PAL)
TVB-3102 (3MPX Bullet, 6mm lens, NTSC)
TVB-1103 (1.3MPX Bullet, 4mm lens, PAL)
TVB-3103 (1.3MPX Bullet, 4mm lens, NTSC)
IP VF bullet camera:
TVB-1104 (1.3MPX Bullet, 2.8 to 12mm VF Lens, PAL)
TVB-3104 (1.3MPX Bullet, 2.8 to 12mm VF Lens, NTSC)
TVB-1105 (3MPX Bullet, 2.8 to 12mm VF Lens, PAL)
TVB-3105 (3MPX Bullet, 2.8 to 12mm VF Lens, NTSC)
IP mini dome camera:
TVD-1101 (1.3MPX Plastic Mini Dome, PoE, PAL)
TVD-3101 (1.3MPX Plastic Mini Dome, PoE, NTSC)
TVD-1102 (3MPX Plastic Mini Dome, PoE, PAL)
TVD-3102 (3MPX Plastic Mini Dome, PoE, NTSC)
2 |
Installation Guide |
TVD-1105 (1.3MPX IP IR Outdoor Mini Dome, PoE/12VDC, PAL)
TVD-3105 (1.3MPX IP IR Outdoor Mini Dome, PoE/12VDC, NTSC)
TVD-1106 (3MPX IP IR Outdoor Mini Dome, PoE/12VDC, PAL)
TVD-3106 (3MPX IP IR Outdoor Mini Dome, PoE/12VDC, NTSC)
IP VF mini dome camera:
TVD-1103 (1.3MPX VF Mini Dome, PAL)
TVD-3103 (1.3MPX VF Mini Dome, NTSC)
TVD-1104 (3MPX VF Mini Dome, PAL)
TVD-3104 (3MPX VF Mini Dome, NTSC)
IP wedge camera:
TVW-1101 (1.3MPX Wedge, 2.8mm lens, PAL)
TVW-3101 (1.3MPX Wedge, 2.8mm lens, NTSC)
TVW-1102 (3MPX Wedge, 2.8mm lens, PAL)
TVW-3102 (3MPX Wedge, 2.8mm lens, NTSC)
Installation Guide |
3 |
Installation
This section provides information on how to install the cameras.
Installation environment
When installing your product, consider these factors:
•Electrical: Install electrical wiring carefully. It should be done by qualified service personnel. Always use a proper PoE switch or a 12 VDCUL listed Class 2 or CE certified power supply to power the camera. Do not overload the power cord or adapter.
•Ventilation: Ensure that the location planned for the installation of the camera is well ventilated.
•Temperature: Do not operate the camera beyond the specified temperature, humidity or power source ratings.
The operating temperature of the camera is between -30 to +60°C (-22 to 140°F). Humidity is below 90%.
•Moisture: Do not expose the camera to rain or moisture, or try to operate it in wet areas. Turn the power off immediately if the camera is wet and ask a qualified service person for servicing. Moisture can damage the camera and also create the danger of electric shock.
•Servicing: Do not attempt to service this camera yourself. Any attempt to dismantle or remove the covers from this product will invalidate the warranty and may also result in serious injury. Refer all servicing to qualified service personnel.
•Cleaning: Do not touch the sensor modules with fingers.
If cleaning is necessary, use a clean cloth with some ethanol and wipe the camera gently. If the camera will not
4 |
Installation Guide |
be used for an extended period of time, put on the lens cap to protect the sensors from dirt.
Package contents
Check the package and contents for visible damage. If any components are damaged or missing, do not attempt to use the unit; contact the supplier immediately. If the unit is returned, it must be shipped back in its original packaging.
IP mini bullet camera
Camera
Installation manual |
CD with Configuration |
|
manual and TruVision |
|
Device Finder |
Installation Guide |
5 |
Template
Water joint: provides water resistance to network connection.
Screws
Drywall anchor
Φ7.5 x 24.5mm (3 pcs)
Screw M4
(4 x 25mm (3 pcs)
12 VDC connector: DC jack socket to
terminal connectors with positive and negative indicators.
6 |
Installation Guide |
IP VF bullet camera
Camera
Installation manual |
CD with Configuration |
|
manual and TruVision |
|
Device Finder |
Template |
Screws |
|
Drywall anchor |
|
Φ7.5 x 24.5mm (4 pcs) |
|
Screw M4 |
|
(4 x 25mm (4 pcs) |
Installation Guide |
7 |
Water joint: provides water |
12 VDC Connector: DC |
resistance to network |
jack socket to |
connection. |
terminal connectors |
|
with positive and |
|
negative indicators. |
Video test cable |
Back box |
Screws C: M4.8×18, 4pcs
IP mini dome camera
Camera
8 |
Installation Guide |
Installation manual
Template
Water joint: provides water resistance to network connection.
CD with Configuration manual and TruVision Device Finder
Screws
Drywall anchor
Φ7.5 x 24.5mm (3 pcs)
Screw M4
(4 x 25mm (3 pcs)
12 VDC Connector: DC jack socket to
terminal connectors with positive and negative indicators (TVD-1105 / 3105 / 1106 / 3106 only).
Installation Guide |
9 |
Screws B |
Hex wrench |
(4 x 75mm, 3pcs) |
|
IP VF dome camera
Camera
Installation manual |
CD with Configuration |
|
manual and TruVision |
|
Device Finder |
10 |
Installation Guide |
Template
Water joint: provides water resistance to network connection.
Video test cable
Screws C: M4×19, 3pcs
Screws
Drywall anchor
Φ7.5 x 24.5mm (4 pcs)
Screw M4
(4 x 25mm (4 pcs)
12 VDC connector: DC jack socket to
terminal connectors with positive and negative indicators.
Hex wrench
Adaptor
Installation Guide |
11 |