GE JX15BUMPBB, JX15BUMPWW Installation Manual

Installation	Bump-Out Kit
Instructions	JX15BUMP
	For 15” Deep Cabinets

IMPORTANT:

Use the existing mounting bracket that comes with your OTR Microwave to identify location for the Bump Out Kit.

Place the original bracket on the wall according to installation instructions from the OTR Microwave to determine where to place the Bump Out Kit Bracket.

Existing Mounting Bracket from OTR Microwave

Mark lowest edage of bracket

Place the Bump Out Kit Bracet in place of existing bracket location making sure that the bottom edge lines up.

Bump-Out Kit

Bracket

49-40719-1 03-15 GE

Installation Instructions

TOOLS YOU WILL NEED

		Ruler or tape
	Pencil	measure and
#1 and #2 Phillips screwdriver		straight edge	Carpenter square
			(optional)

Tin snips (for cutting
damper, if required)	Scissors	Electric drill with 3ø16” , 7ø16”, 3ø8”,
	(to cut template, if necessary)
		1ø2” and 5ø8” drill bits

Gloves

Saw (saber, hole or keyhole)

Stud finder or Hammer (optional)

Filler blocks or scrap wood pieces, if needed for top cabinet spacing (used on recessed bottom cabinet installations only)

Safety goggles	Level	Duct and masking tape

MOUNTING SPACE

NOTE: Maximum cabinet depth is 15”.		Bottom edge
		of cabinet
		needs to
16-1ø4”		be 30” or
		more from
30”	30”	the cooking
	min.	surface
2”		Backsplash
66” or more
from the
floor to the
top of the
oven

NOTES:

The space between the cabinets must be 30” wide and free of obstructions.

If the space between the cabinets is greater than 30”, a Filler Panel Kit may be used to fill in the gap between the oven and the cabinets.

Your Owner’s Manual contains the kit number for your model.

This oven is for installation over ranges up to 36” wide.

If you are going to vent your oven to the outside, see Hood Exhaust Section for exhaust duct preparation.

When installing the oven beneath smooth, flat cabinets, be careful to follow the instructions on the top cabinet template for power cord clearance.

2