PORTABLE
SOUND SYSTEMS
From Fender Pro Audio
Owner's Manual for
Passport - 150
P/N 000000
REV A
A Message from the Chairman
At Fender, we know the importance of sound reinforcement. From the simple box-top powered mixer to today’s touring concert systems, the need to communicate to make the connection between the performer and the audience is foremost in our mind.
Perhaps no other piece of gear can make or break your message or your band’s sound than your sound reinforcement gear. Your sound system is far more than just a combination of dials, wires and speakers. It is an integral part of the audio chain and should be treated with special care and attention to detail.
Fender knows what building quality musical instruments and sound reinforcement equipment is all about. In fact, many of the world’s best sounding electric musical instruments and sound reinforcement equipment proudly wear the Fender name.
Whether you need a small powered mixer for your Saturday afternoon “jam” or a professional full-size concert system, Fender has the sound reinforcement gear to meet your needs. Likewise, your decision to purchase quality Fender Professional Audio Equipment is one you will appreciate with each performance for years to come.
Wishing you years of enjoyment and a heartfelt thank you,
Bill Schultz
Bill Schultz
Chairman of the Board
Fender Musical Instruments Corporation
Fender Passport - 150
Portable Sound System
INTRODUCTION
150 Watts of Clear Stereo Sound
Built-in Digital Reverb
VIP™ (Vocal Input Priority) Allows input one to automatically override all other inputs when a signal is present on input one
Three Mono Microphone / Line Inputs with XL and 1/4” balanced inputs connections
Stereo Input with 1/4” and RCA Connections
Switch Mode Power Supply Allows Use
Anywhere In The World
Everything You Need To Get Started:
-Passport Mixer Amplifier
-A Dynamic Microphone & 6m (20’) Cable
-Two Speaker Cables, 9m (30’) -IEC Power Cable
-Two High Sensitivity, Full-Range Speaker Enclosures
-Full transportation enclosure -Plastic slip cover
Congratulations on your purchase of a Fender Passport 150 high performance, self-contained portable audio system. Your Passport includes everything you will need for great sound… Anywhere.
Carry your Passport as you would a medium sized suit case. Flip open the speaker latches, and you’ll discover two full-range speaker cabinets, a powered mixer, a dynamic microphone, plus all the cables you need to get started. Use your Passport to amplify voices, musical instruments, CD’s, tape playback and more. Passport’s quick and easy setup, its ability to cover large audiences and simple operation are the hallmarks of this new and innovative product.
The Passport’s control panel features three mono mic/line inputs and one stereo channel. The stereo input channel can be configured for mono or stereo operation allowing superb flexibility in input use. Moreover, two 6.5” speakers in each speaker enclosure work together to deliver clean full range coverage, while the self-powered mixer provides a total of 150 watts of high quality stereo sound.
For vocal operation, the Passport’s VIP (Vocal Input Priority) feature can be used to reduce or “duck” the background music level as you begin to speak and then restore your background music when you have finished speaking. Experiment with the tone controls, digital reverb and speaker placement and discover the Passport’s incredible power and versatility.
WARNING:
-TO PREVENT DAMAGE, FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
-NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
-THIS UNIT MUST BE EARTH GROUNDED.
3
SAFETY PRECAUTIONS
The Fender Passport sound system is supplied with a detachable power cable with an IEC female connector and a male AC connector. Depending on the territory in which the Passport system is purchased, the power cable will be supplied with one of a number of male AC connectors to accommodate the different safety and code requirements of specific countries. All AC cables supplied with Passport products are three pin grounded types.
Under no circumstances should the ground (earth) pin be disconnected or removed.
Your Passport System features a Switch-Mode- Power-Supply designed to operate on any AC voltage and line frequency to convert AC power with maximum efficiency.
When traveling abroad with the Passport system, as a standard precaution, always check the local voltage and set the voltage selector switch located adjacent to the power input socket on the rear of the mixer / amplifier to the appropriate operating range. This check must be performed before connecting the power cable. The Fender Passport has two range settings: 115v or 230v.
Failure to select the appropriate voltage range will cause the unit to go into protect mode, void any warranty and may cause damage to the unit.
For example, The United States of America is standardized at 117 volts/60 Hz, Japan operates on 100 volts/50 Hz. For both of these countries the range selector must be set to 115v. Countries in the EEC have standardized at 230 volts/50 Hz., however, there are different types of AC plugs used. For all these countries the selector should be at the 230v position. When using plug adapters or operating in a territory other than the one in which the unit was purchased, take great care to comply with local safety requirements and electrical codes of practice.
If you are not sure of the local voltage, wiring codes & colors, AC grounding, or correct procedures for connection, consult a qualified technician.
Warning
Under no circumstances should the ground pin on the Passport or on any of your electrical equipment be lifted. It is possible that under certain circumstances a combination of different types of ungrounded equipment can create a life threatening shock hazard. Microphones have metal cases and are connected through the mic cable to the mixer’s chassis. Your Passport mixer may be correctly grounded if the building’s wiring is to code and the ground pin on the A/C plug is properly connected. However if for any reason external A/C powered equipment with ungrounded A/C connections are used in conjunction with the Passport system (e.g. an ungrounded music amplifier), there may be a difference in potential to the microphone case. With this combination a performer holding a (grounded) microphone coming into contact with an ungrounded item of powered equipment may be subject to dangerous electrical shocks.
By following the correct procedures and safety precautions, risks of severe shock hazard can be minimized. Always check the A/C connection and particularly the voltage between the microphone and any other A/C equipment. Best of all, avoid operating the system in conjunction with ungrounded or improperly grounded electrical equipment.
4
TRANSPORTATION LATCHES
To open and close your Passport system, simply follow these guidelines:
1. Place your finger tip under the safety latch and gently lift. When the safety latch has disengaged, lift both the latches clear on each speaker before attempting to remove the speaker.
2. To replace, position each speaker on the tower foot and bring the speaker in to close the engagement with the tower and latches. Position the latch hooks over the speaker notch and close the latches. The 4 latches will automatically engage.
Note: These parts are precision engineered and no force is needed to secure them. Careful alignment of parts will ensure easy operation.
SAFETY CATCH
CATCH PLATE
SPEAKER LATCH
ROTATE SAFETY CATCH TO
DISENGAGE SPEAKER LATCH
SPEAKER
5
Loading...