MXDMA65
INSTALLATION/OWNER'S MANUAL
AM/FM/CD/MP3/WMA/iPod™ Ready Receiver with Detach Face
MXDMA65 INSTALLATION
Preparation
Please read entire manual before installation.
Before You Start
•Disconnect negative battery terminal. Consult a qualified technician for instructions.
•Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
•Remove 2 transit screws located on top of the unit.
• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.
•Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna. Consult a qualified technician if you are unsure.
•harness adapter (sold separately).
•Test for correct operation and slide into mounting sleeve to secure.
• Snap trim ring into place.
•Mount the iplug™ adapter to any smooth clean surface using the supplied double-sided tape or #2 x 3/8” Phillips head screws.
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
2
MXDMA65 INSTALLATION
Wiring Diagram
FUSE
When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The MXDMA65 uses one 10 amp ATM fuse located
beside the wiring connector.
3
MXDMA65 OPERATION
Control Locations
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
9 |
10 |
11 |
21 |
20 |
19 |
18 |
|
17 |
16 |
15 |
14 |
13 |
12 |
|
|
1 |
Release |
12 |
EQ/9 |
|
|
|
|
|
|
|
2 |
Band/Play/Pause |
13 |
Loudness |
|
|
|
|
|
|
|
3 |
Volume |
14 |
Display/0 |
|
|
|
|
|
|
|
4 |
Mode/Search |
15 |
Tuner Scan/8 |
|
|
|
|
|
|
|
5 |
Preset 4/Menu |
16 |
Mute |
|
|
|
|
|
|
|
6 |
Preset 1/Repeat |
17 |
Return/7 |
|
|
|
|
|
|
|
7 |
Preset 5/Folder Down |
18 |
Auto Store/Preset Scan/Enter |
|
||||
|
|
8 |
Preset 2/Random |
19 |
Power |
|
|
|
|
|
|
|
9 |
Preset 3/Intro |
20 |
Tune/Track Down |
|
|
|
||
|
|
10 |
Eject |
21 |
Tune/Track Up |
|
|
|
|
|
|
|
11 |
Preset 6/Folder Up |
|
|
|
|
|
|
|
The MXDMA65 allows playback of your favorite MP3 and WMA files recorded on CD-R and CD-RW discs. Its powerful on-board DSP processor decodes the compressed audio while maintaining near-CD sound quality. An internal SRAM buffer provides ESP (Electronic Skip Protection) to virtually eliminate skipping and allows alphanumeric or direct track search - even while a song is currently playing!
4
MXDMA65 OPERATION
General Operation
Faceplate Removal Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure.
Semi-permanent Remove trim ring and install supplied #1 x 7/32” Phillips Faceplate Installation head screw through left side of mounting frame into faceplate.
Power On/Off Press POWER or any other button (except eject) to turn the unit on. Inserting a disc will turn the unit on automatically. Press POWER to turn the unit off.
Mode Press MODE to select between tuner, CD player, auxiliary input and iPod mode. Modes of operation are indicated in the display.
Loudness Press LOUD to activate and deactivate the loudness contour curve. Activating this feature will enhance the bass and treble frequencies when listening to music at low volumes.
Volume Adjust volume using rotary encoder (00-46).
Programmable Press and hold POWER for 3 seconds to program currently Turn-On Volume selected volume level. "P-VOL" and the current volume level will momentarily appear in the display.
Preset EQ Curves Press EQ to select between POP, JAZZ, CLASSIC, BEAT, ROCK and OFF (default) equalization curves. Any adjustment to the Bass or Treble settings automatically cancels the current EQ curve (if one is selected).
Display Press DISP to select between clock and different types of information, such as radio frequency, CD track/elapsed time, or MP3/WMA/iPod song information.
Set the Clock With the unit on, press and hold DISP until the clock begins to flash, then release. Press TUNE nnto adjust the hours and TUNE llto adjust the minutes. Press DISP momentarily to save the selected time.
12/24-hour Clock The clock will display 12-hour AM/PM time in USA frequency spacing mode (PM 10:00). In European frequency spacing mode, the clock will display 24-hour time (22:00).
5
MXDMA65 OPERATION
General Operation - Setup Menu
Reset Press to RESET the unit upon initial installation or if abnormal operation occurs. The reset button is located behind the faceplate.
Mute Press MUTE to silence the audio. “MUTE” will flash in the display. Press MUTE again to cancel.
Setup Menu Press and hold the rotary encoder for more than 3 seconds to access the setup menu. Press the rotary encoder momentarily to select between the menu functions and rotate the rotary encoder left/right to adjust or activate the desired function.
Menu Function |
Options |
Action |
Tuner Frequency |
FREQ USA |
Programs the unit to USA tuner spacing. |
Spacing |
|
(200kHz for FM and 10kHz for AM) |
|
FREQ EUR |
Programs the unit to European tuner spacing. |
|
|
(50kHz for FM and 9kHz for AM) |
Clock Display |
CLK OFF |
Programs the unit to not display the clock when the |
|
|
power is off. |
|
CLK ON |
Programs the unit to display the clock when the |
|
|
power is off. |
Auxiliary Mode |
AUX ON |
Enables access to auxiliary mode. |
|
AUX OFF |
Disables access to auxiliary mode. |
Beep |
BEEP OFF |
Disables the confirmation beep. |
Confirmation |
BEEP ON |
Enables the confirmation beep. |
Local/Distance |
LOC OFF |
Activates Distance tuning. |
Tuning |
LOC ON |
Activates Local tuning for strong station reception |
|
|
only. |
Power on |
MSG OFF |
Disables power on message. |
Message |
MSG ON |
Enables power on message to be displayed. |
Made for iPod |
DEMO ON |
Enables Made for iPod message to be displayed |
Message |
|
every 60 seconds in Tuner and Aux modes. |
|
DEMO OFF |
Disables Made for iPod message. |
6