MXDM51
INSTALLATION/OWNER'S MANUAL
AM/FM/CD/MP3/WMA Receiver with Detach Face
MARINE
MXDM51 INSTALLATION
Preparation
Please read entire manual before installation.
Before You Start
•Disconnect negative battery terminal. Consult a qualified technician for instructions.
•Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
• Remove 2 transit screws located on top of the unit.
• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
•Connect wiring harness and antenna. Consult a qualified technician if you are unsure.
•Test for correct operation and slide
into mounting sleeve to secure.
• Snap trim ring into place.
• Mount the iplug™ adapter to any smooth clean surface using the supplied double-sided tape or #2 x 3/8” Phillips head screws.
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
2
MXDM51 INSTALLATION
Wiring Diagram
FUSE
When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The MXDM51 uses one 10 amp AGC fuse (Battery) located in-line.
3
MXDM51 OPERATION
Control Locations
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
21 |
20 |
19 |
18 |
17 |
16 |
15 |
14 |
|
13 |
12 |
11 |
10 |
9 |
|
1 |
|
Release |
|
|
|
|
12 |
EQ/9 |
|
|
|
|
|
2 |
|
Power |
|
|
|
|
13 |
Tuner Scan/8 |
|
|
||
|
3 |
|
Mute |
|
|
|
|
14 |
Local/Distance/7 |
|
|
||
|
4 |
|
Audio |
|
|
|
|
15 |
Preset 6/Folder Up |
|
|||
|
5 |
|
Band/Play/Pause |
|
|
|
16 |
Preset 5/Folder Down |
|
||||
|
6 |
|
Auto Store/Preset Scan/Enter |
|
17 |
Preset 4 |
|
|
|
||||
|
7 |
|
Mode/Search |
|
|
|
18 |
Preset 3/Intro |
|
|
|||
|
8 |
|
Eject |
|
|
|
|
19 |
Preset 2/Random |
|
|
||
|
9 |
|
Tune/Track Up/Down |
|
|
20 |
Preset 1/Repeat |
|
|
||||
|
10 |
|
Loudness |
|
|
|
|
21 |
Volume Up/Down |
|
|
||
|
11 |
|
Display/0 |
|
|
|
|
|
|
|
|
|
|
The MXDM51 allows playback of your favorite MP3 and WMA files recorded on CD-R and CD-RW discs. Its powerful on-board DSP processor decodes the compressed audio while maintaining near-CD sound quality. An internal SRAM buffer provides ESP (Electronic Skip Protection) to virtually eliminate skipping and allows alphanumeric or direct track search - even while a song is currently playing!
4
MXDM51 OPERATION
General Operation
Faceplate Removal Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure.
Semi-permanent Remove trim ring and install supplied #1 x 7/32” Phillips Faceplate Installation head screw through left side of mounting frame into faceplate.
Power On/Off Press PWR or any other button (except eject) to turn the unit on. Inserting a disc will turn the unit on automatically. Press PWR to turn the unit off.
Mode Press MODE to select between tuner, CD player and auxiliary input. Modes of operation are indicated in the display.
Loudness Press LOUD to activate and deactivate the loudness contour curve. Activating this feature will enhance the bass and treble frequencies when listening to music at low volumes.
Volume Adjust volume using VOL t / VOL s (00-46).
Programmable Press and hold PWR for 3 seconds to program currently Turn-On Volume selected volume level. "P-VOL" and the current volume level
will momentarily appear in the display.
Preset EQ Curves Press EQ to select between POP, JAZZ, CLASSIC, BEAT, ROCK and OFF (default) equalization curves. Any adjustment to the Bass or Treble settings automatically cancels the current EQ curve (if one is selected).
Display Press DISP to select between clock and radio frequency (tuner mode), clock and CD track/elapsed time (CD mode), or clock and AUX (AUX mode).
Set the Clock With the unit on, press and hold DISP until the clock begins to flash, then release. Press TUNE << to adjust the hours and TUNE >> to adjust the minutes. Press DISP momentarily to save the selected time.
12/24-hour Clock The clock will display 12-hour AM/PM time in USA frequency spacing mode (PM 10:00). In European frequency spacing mode, the clock will display 24-hour time (22:00).
5
MXDM51 OPERATION
General Operation
Programmable Display In tuner mode, press and hold DISP then press TUNE >> Priority to select function priority display. “FREQ” will momentarily
appear in the display.
Note:
"FUNC" will appear in CD or AUX modes.
Radio frequency (tuner mode), CD track/elapsed time (CD mode) or AUX (AUX mode) will be displayed by default.
Note:
When playing MP3/WMA files, the track number/elapsed time, track name, directory name, title, artist, album, year or comment will be displayed by default. Clock is accessed by pressing DISP momentarily.
Press and hold DISP then press TUNE << to select time display priority. “TIME” will momentarily appear in the display. Clock will be displayed by default. Radio frequency, CD track/elapsed time or MP3/WMA file information is accessed by pressing DISP momentarily.
Programmable Clock Programs unit to display clock/no clock when unit is off. Priority Press and hold MODE then press PRESET 1 to select clock
priority on/off. “CLK ON” or “CLK OFF” will momentarily appear in the display.
Reset Press and hold for more than 2 seconds to RESET the unit upon initial installation or if abnormal operation occurs. The reset button is located behind the faceplate. Refer to page 2 for details.
Confirmation Beep Press and hold AUD for 3 seconds to turn confirmation beep on/off. "BEEP ON" or BEEP OFF" will momentarily appear in the display.
Mute Press MUTE to silence the audio. “MUTE” will flash in the display. Press MUTE again to cancel.
6
Loading...