Safety
Symbols used in these instructions
The important recommendations have these symbols. These recommendations must be followed.
Danger!
Failure to comply can be or is the cause of injury due to lifethreatening electric shocks.
Attention!
Failure to comply can be or is the cause of injury or damage to the appliance.
Scalding hazard!
Failure to comply can be or is the cause of scalding or burns.
Please Note:
This symbol highlights recommendations and important information for the user.
Fundamental recommendations regarding safety
Danger!
As the appliance operates using electric current, electric shocks can not be excluded.
Therefore, follow the safety recommendations given:
•Do not touch the appliance when you have wet hands or feet.
•Donottouchtheplugwithwethands.
•Make sure that the socket used can always be easily reached, so that the plug can be removed when required.
•Remove the plug from the socket by acting directly on the plug itself. Do not pull the cable as damage could be caused.
•Remove the plug from the socket to disconnect the appliance completely.
•Do not attempt to repair the appliance if it should breakdown.
Switch the appliance off, remove the plug from the socket and contact the After-Sales Service. Please refer to enclosed guarantee leaflet for details.
•Iftheplugorpowersupplycablearedamaged,havethem replacedexclusivelybytheDe’LonghiAfter-SalesService, in order to prevent risks. Please refer to the enclosed guarantee leaflet for details.
Attention:
Keep the packaging material (plastic bags, expanded
polystyrene) out of the reach of children.
Attention:
The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
Scalding hazard!
This appliance produces hot water and steam may form when it is operating.
Pay attention not to come into contact with hot water sprays or steam.
Do not touch the cup warmer plate when the appliance is on; it is hot.
Conditions of use
This appliance is manufactured for the preparation of coffee and to heat beverages.
The appliance is designed and produced for domestic use only.
Itisnotsuitableforusein:
•staffkitchensinshops,officesandotherworkplaces
•farms
•hotels,motelsorotherholidayaccommodation
•guesthouses
Any other use must be considered improper and therefore dangerous.
The manufacturer is not liable for damage deriving from the improper use of the appliance.
Instructions for use
Thank you for choosing this coffee machine. To get the very best out of your new coffee machine it is advisable to read these instructions before using the appliance. This is the only way to ensure optimum results and maximum safety.
The manufacturer is not liable for damage deriving from the failure to comply with the user instructions.
Please Note:
Keep these instructions carefully. If the appliance should be transferred to other persons, these instructions must accompany it.
Check after transport
After the packaging has been removed, check the integrity of the appliance and the presence of all accessories.
Do not use the appliance in the presence of obvious damage. Contact the De’Longhi Customer Services department, please see enclosed leaflet.
12
Introduction
Installing the appliance
Attention!
The following safety measures must be complied with when installing the appliance:
•The appliance could be damaged by the penetration of water.
Donotpositiontheapplianceneartowatertapsorsinks.
•The appliance could be damaged if the water it contains freezes. Do not install the appliance in a room where the temperature can fall below freezing point.
•Positionthepowersupplycableinawaythatitcannotbe damaged by sharp edges or by contact with hot surfaces.
Connecting the appliance
Attention!
Make sure that the electric mains voltage corresponds with that indicated on the rating plate on the base of the appliance. Only connect the appliance to a correctly installed socket with a minimum rating of 10A and correctly earthed.
In the case of incompatibility between the socket and the plug on the appliance, have the plug replaced by a qualified technician.
•The power supply cable on this appliance must never be replaced by the user as special tools are needed for this operation. Contact an After-Sales Centre authorised by the manufacturer if the cable is damaged or must be replaced, in order to avoid all risks. Please refer to enclosed guarantee leaflet for details.
Filling the water tank
1.Open the water tank lid (fig. 1) and then lift the tank to remove it (fig. 2).
2.Fill the tank with fresh water but do not pass MAX level (fig.3).Re-positionthetankbypressingitlightlyinaway to open the valve situated on the base of the tank itself.
3.Alternatively, do not remove the tank, just fill it by pouring in water from a jug, be careful of splashes
Attention!
Do not operate the appliance without water in the tank and always fill it when the water is a few centimetres from the bottom.
Please Note: it is normal to find water in the compartmentunderthetank;dryusingacleansponge.
Description |
EN |
|
A |
Selector dial |
|
B |
Steam position |
|
C |
“OFF” position |
|
D |
Onindicatorlight |
|
EOK indicator light
FCoffeehot water delivery position
GSteam dial
HWater tank
IWatertanklid
JFilter compartment
KPower supply cable
L Coffeetamper M Driptray
NBoiler outlet
OSteam or hot water tube
PCappuccino nozzle
QFilter holder
RFilter
S Measure
Technical date |
|
Mainsvoltage: |
220-240V˜50/60Hz |
Absorbed power: |
1100W |
Dimensions(LxHxD): |
195x285x240(330)mm |
Pressure: |
15 bar |
Watertankcapacity: |
1L |
Cable lenght: |
1,2 m |
Weight: |
3 kg |
13
Loading...