HOUSEHOLD- WASHING MACHINE WA 7180
Instruction Manual
|
Contents |
Introduction............................................................................................................. |
Page 3 |
General Notes…………………………………………………………..………….…….Page 3 Special safety Information for this Unit…………………………….…………………..Page 4 Unpacking the Appliance………………...……………………….…….………..…..…Page 6 Appliance Equipment……..……………….………………...…………….……..……..Page 6 Installation…………….……...…………….………...………………………...………...Page 7 Startup / Operation………...................……...………………………..…..…….……Page 10 Cleaning and Maintenance.....…………………………...……..………………...…..Page 18 Troubleshooting……………………….………..………………………………......….Page 21 Technical Data……………...…………………………..……………..……..…………Page 22 Disposal….………………………..………………..….……………………..……..…..Page 23 EU Product Data Sheet………….………………..….……………………..……..…..Page 24
2
Introduction
Thank you for choosing our product. We hope you will enjoy using the appliance.
Symbols in these Instructions for Use
Important information for your safety is specially marked. It is essential to comply with these instructions in order to avoid accidents and prevent damage to the machine:
WARNING:
This warns you of dangers to your health and indicates possible injury risks.
CAUTION:
This refers to possible hazards to the machine or other objects.
NOTE: This highlights tips and information.
General Notes
Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty and the receipt. If you give this device to other people, please also pass on the operating instructions.
NOTE:
Illustrations in this instruction manual can deviate from the original appliance.
•The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fit for commercial use.
•The appliance is only to be used as described in the user manual. Do not use the appliance for any other purpose. Any other use is not intended and can result in damages or personal injuries.
•Do not use it outdoors. Keep it away from sources of heat, direct sunlight, humidity.
•Do not operate the appliance without supervision.
•When not in use, for cleaning, user maintenance works or with disruption, switch off the appliance and disconnect the plug (pull the plug itself, not the lead) or turn off the fuse.
3
•The appliance and if possible the mains lead have to be checked regularly for signs of damage. If damage is found the appliance must not be used.
•For safety reasons, alterations or modifications of the appliance are prohibited.
•In order to ensure your children’s safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach.
WARNING:
Do not allow small children to play with the foil. There is a danger of suffocation!
Special safety Information for this Unit
WARNING: Hot surface! Danger of burns!
During operation the temperature of the bull’s-eye may be very hot.
•Before using the transportation locking screws must be removed, otherwise it may cause serious damages.
•The dry weight of laundry must not exceed the max. loading capacity.
•The unit must be connected with a new set of hoses to the water supply; old hose sets should not be reused.
•The maximum / lowest permitted water inlet pressure is 1.0 MPa / 0.03 MPa.
•Do not use any flammable/explosive cleaning agents such as benzene in the appliance.
4
•In the appliance bottom are located ventilation openings (depending on model). These may not be blocked e.g. by carpet. Pay attention to free circulation of air.
•If the unit is used in the bathroom, unplug the power cord after using as the proximity of water presents a danger. This even applies when the unit is switched off.
•This appliance can be used by children aged from
8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
•Children shall not play with the appliance.
•Children younger than 3 years should be kept away, unless they are constantly supervised.
•Cleaning and user maintenance shall not be made by children unless they are older 8 years and supervised.
•The appliance must be cleaned regularly. Follow the instructions in the chapter "Cleaning and Maintenance".
•Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the expo-
5
sure to danger, always have faulty cable be replaced only by the manufacturer, by our customer service or by qualified person and with a cable of the same type. Do not use the device if the device or plug is damaged.
Unpacking the Appliance
•Remove the appliance from its packaging.
•Remove all packaging material, such as foils, filler and cardboard packaging.
•To prevent hazards, check the appliance for any transport damage.
•In case of damage, do not put the appliance into operation. Contact your distributor.
NOTE:
Production residue or dust may have collected on the appliance. We recommend cleaning the appliance according to chapter “Cleaning and Maintenance”.
Appliance Equipment
Appliance overview
1Detergent drawer
2Control panel
3Appliance door
4Feet
5Drain pump cover
6Inlet valve (cold water)
7Power plug
Delivery scope
1x Inlet hose, 1x hose retaining sheet, 1x wrench
6
Installation
WARNING:
The unit must not be connected to the mains during installing. Otherwise there is danger to life or electric shock hazard!
CAUTION:
For a correct operation the appliance must be connected properly. The specifications for water supply and drain as well as the electrical connection must fulfill the required criteria.
Remove the transport locking screws
CAUTION:
•Before using, all transport locking screws must be removed from the appliance back. Otherwise it may cause serious damages.
•Keep the transport locking screws for later use / transport. Never transport the appliance without properly attached transportation safety!
•Loosen and remove the four transport locking screws with the supplied wrench.
•Insert the pre-installed transport locking covers at the unit back.
Installation location
•The site should be located near the water inlet and outlet, as well as near a properly grounded power socket.
•Good ventilation around the appliance is required, in order to dissipate the heat properly. Sufficient clearance must be created for this purpose.
•The clearance to the front must be created so, that the appliance door can open without being impeded.
•Make sure that the floor on which the appliance is installed, is even, heat-resistant and clean.
7
•Take care of a solid and horizontal position of the appliance. If the appliance is not horizontally leveled, adjust the feet accordingly (see “Adjust the feet”).
•Power cord and water hoses may not kinked or squashed.
•The wall socket must be freely accessible.
•Avoid the installation:
-near heaters, next to a stove, direct sunlight or any other heat sources;
-at locations with high humidity (e.g. outdoors), as metal parts would be susceptible to corrosion under such circumstances;
-in rooms where the temperature could drop below freezing. Do not expose the appliance any weather.
-near volatile or flammable materials (e.g. gas, fuel, alcohol, paint, etc.).
Adjust the feet
CAUTION:
The feet must never be removed. Do not restrict the floor clearance through carpets, strips of wood or similar. Danger of heat accumulation!
Use the wrench to loosen the lock nuts.
Rotate the feet to change the height. Tighten the lock nuts with the wrench, if the unit is aligned. The feet must have solid ground contact.
Check with a spirit level whether the appliance is leveled horizontally. If the unit is not in balance, the feet must be adjusted again.
Water connection
CAUTION:
•The Installation of the water supply must conform to the local laws and regulations.
•The appliance is not suitable for hot water supply.
•Use the new supplied hose set to connect the appliance to the water supply. Do not reuse old or used connection sets.
•If the water pipe is new or long time not used, ensure before connecting to the water system, that the water is clear and free from contamination.
8
Notes on inlet hose safety system (delivery scope depending on model)
The safety system consists of a double-walled inlet hose. It guarantees to cut off the water supply when leakage of the inner hose. Switching off the water supply leads over an electronic contact.
If necessary, you can order an inlet hose safety system from your dealer or in our online accessories shop, www.bomann-germarny.de. To order, use the reference number found under “Technical Data”.
Connect the water inlet hose (cold water connection)
NOTE:
The water pressure must be between 0.03 MPa and 1.0 MPa. With higher pressure: use a pressure regulator.
•Check the tightness of the rubber seals (d) at both ends of the inlet hose to prevent leakage.
•Connect the water inlet hose to a water thread with ¾“. Screw the hose firmly in the direction of the screw thread; pay attention for a tight fit.
•Connect the other end of the inlet hose to the inlet valve on the appliance back; pay attention for a tight fit too.
Connect the water drain hose
NOTE:
The drain hose has a length of approx. 1.5 m and can extend with a suitable hose and connecting piece to a length of max. 4 m.
CAUTION:
In order to prevent backflow of contaminated water, the free end of the hose must not come under the water level of the drain.
•Connect the drain hose to a drain pipe with a minimum diameter of 40 mm; alternatively the drain hose can be fixed to a sink or directly to the drainage.
9
Loading...