BUILT-IN OVEN
ZBQ 865
INSTRUCTION BOOKLET
Please read this instruction booklet before using the appliance
GB
Important Safety Information
You MUST read hese warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 727727
Installation
•This oven must be installed by qualified personnel to the relevant British Standards.
•This oven is heavy. Take care when moving it.
•Remove all packaging, both inside and outside the oven, before using the oven.
•Do not attempt to modify the oven in any way.
Child Safety
•This oven is designed to be operated by adults. Do not allow children to play near or with the oven.
•The oven gets hot when it is in use. Children should be kept away until it has cooled.
•When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the oven.
Maintenance and Cleaning
•Onlycleanthisoveninaccordancewiththeinstructions.
•The oven should be kept clean at all times. A build-up of fats or other foodstuffs could result in a fire, especially in the grill pan.
•Never use steam or high pressure steam cleaners to clean the appliance.
•Always allow the oven to cool down and switch off the electrical supply before carrying out any cleaning or maintenance work.
During Use
•This oven is intended for domestic cooking only. It is not designed for commercial or industrial purposes.
•Appliances become very hot with use, and retain their heat for long periods after use. Care should be taken to avoid touching heating elements inside the oven.
•Always stand back from the oven when opening the oven door during cooking or at the end of it to allow any build up of steam or heat to release.
•Never line any part of the oven with aluminium foil.
•Do not allow heatproof cooking material, e.g. roasting bags, to come into contact with oven elements.
•Never place plastic or any other material which may melt in or on the oven.
•Do not place sealed cans or aerosols inside the oven. They may explode if they are heated.
•Do not hang towels, dishcloths or clothes from the oven or its handle.
•Do not use this oven if it is in contact with water and never operate it with wet hands.
•Take great care when heating fats and oils as they will ignite if they become too hot.
•Alwaysuseovenglovestoremoveandreplacefoodin theoven.
•Ensure that all control knobs are in the OFF position when not in use.
•Do not leave cookware containing foodstuffs, e.g. fat or oil in or on the oven in case it is inadvertently switched ON.
Service
•This oven should only be repaired or serviced by an authorisedServiceEngineerandonlygenuineapproved spare parts should be used.
Environmental Information
•After installation, please dispose of the packaging with due regard to safety and the environment.
•Whendisposingofanoldappliance,makeitunusable, by cutting off the cable. Remove any door catches, to prevent small children being trapped inside.
Keep this instruction book for future reference and ensure it is passed on to any new owner.
2
Contents
For the User
Important Safety Information |
2 |
Description of the Oven |
4 |
Controls |
5 |
Before the First Use |
6 |
Electronic programmer |
7 |
Using the Oven |
9 |
Hints and Tips |
9 |
Using the Conventional Oven |
10 |
Using the Fan Oven |
11 |
Cooking chart-Conventional and Fan Oven |
12 |
Grilling |
13 |
Defrosting |
15 |
Cleaning the Oven |
16 |
Care of Catalytic Liner |
17 |
Replacing the Oven Light |
18 |
Something not working |
19 |
Service and Spare Parts |
19 |
Customer Care Department |
20 |
Guarantee Conditions |
20 |
Guide to use the instructions
The following symbols will be found in the text to guide you throughout the Instructions:
Safety Instructions
)Step by step instructions for an operation 
Hints and Tips
Environmental information
This appliance complies with the following E.E.C.
Directives:
*73/23 - 90/683 (Low VoltageDirective); *93/68(General Directives);
*89/336(ElectromagneticalCompatibilityDirective) and subsequent modifications.
For the Installer
Installation |
21 |
Technical data |
21 |
Electrical Connection |
21 |
Building In |
22 |
3
Description of the Oven
6 |
5 |
4 |
3 |
2 |
1
8
7
9
10
1. |
Control panel |
6. |
Thermostat Control Light |
2. |
Oven Control Function Knob |
7. |
Oven Light |
3. |
Electronic Programmer |
8. |
Grill |
4. |
Thermostat Control Knob |
9. |
Oven Fan |
5. |
Mains on Light |
10.Rating Plate |
|
Oven accessories
Grill/roasting |
Grill trivet |
pan |
|
Anti-tip shelf (x 2)
Removable
handles
4
Controls
Retractable control knobs
Some models are provided with push-pull control knobs (see diagram). These knobs can be completely sunken inside the control panel when the oven is not working.
Oven Function Control Knob
0 The oven is off.
Oven light - The oven light will be on without any cooking function.
Conventional cooking - The heat comes
from both the top and bottom element, ensuring even heating inside the oven.
Top heating element - The heat comes from the top element only (outer section).
Bottom heating element - The heat comes from the bottom of the oven only.
Inner grill element only - Can be used for
grilling |
small quantities. |
Full Grill - The full grill element will be on.
Thermal Grilling - This function offers an al-
ternative method of cooking food items, normally associated with conventional grilling. The grill element and the oven fan operate together, circulating hot air around the food.
When using the thermal grill cooking function, select a maximum temperature of 200°C.
Fan cooking - This allows you to roast or roast
and bake simoultaneously using any shelf, without flavour transference.
Defrost Setting - This setting is intended to assist in thawing of frozen food.
Mains on Light
The mains on light will come on when the oven function control knob is set.
Thermostat Control Knob (°C)
Turn the thermostat control knob clockwise to select temperatures between 50 °C and 230 °C (MAX).
Thermostat Control Light
The thermostat control light will come on when the thermostat control knob is turned. The light will remain on until the correct temperature is reached. It will then cycle
on and off to show the temperature is being maintained.
5
The Safety Thermostat
This oven is provided with a safety thermostat. In case of malfunctioning of the main thermostat, and consequent over-heating, the safety device will stop the power supply to the appliance. If this happens, call your local Service Force Centre. Under no circumstances should you attempt to repair the appliance yourself.
The cooling fan
The cooling fan operates during cooking. Air is expelled through vents between the oven door and the control panel, as shown in the diagram.
The cooling fan may run on after the oven is switched off to keep the controls cool. This is quite normal.
Before the First Use
Remove all packaging, both inside and outside the oven, before using the oven.
Before first use, the oven should be heated without food. During this time, an unpleasant odour may be emitted. This is quite normal.
The oven will work only if the time of day has been set (see the relevant instructions).
)1. Set the time of day with the electronic programmer (see chapter "Electronic Programmer").
2.Switch the oven function control knob to fan cooking 
.
3.Set the thermostat control knob to MAX.
4.Open a window for ventilation.
5.Allow the oven to run empty for approximately 45 minutes.
This procedure should be repeated with the grill 
function for approximately 5-10 minutes.
6
Electronic programmer
|
|
|
4 |
|
|
|
|
|
|||
5 |
|
|
|
|
|
|
|
|
|
7 |
|
|
|
|
|
|
|
||||||
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
||||
6 |
|
|
|
|
|
|
|
|
|
8 |
|
|
|
|
|
|
|
||||||
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
|
|
|
|
2 1 3
1.Push button for selecting a function 
2.Decreasing control button “ ”
3.Increasing control button “
”
4.Display
5.“Cooking Duration” pilot lamp
6.“End of cooking” pilot lamp 
7.“Minute minder” pilot lamp 
8.“Time of day” pilot lamp 
The oven will work only if the time of day has been set.
However, the oven can also be operated without any programme.
Setting the time of day 
When the power supply is switched on, or after a power failure, the “Time of day” pilot lamp 
will flash on the display.
To set the correct time of day:
1.Press button “
” or “ ”.
2.After the setting is carried out, wait for 5 seconds: the “Time of day” pilot
lamp 
will go out and the display will show the set time. The appliance is ready for use.
To reset the correct time of day:
1.Press button 
repeatedly to select the “Time of day” function. The relevant pilot lamp will start flashing. Then proceed as described above. The time of day can only be reset if no automatic function (cook duration 
or end of cooking 
) has been set.
“Cooking Duration” function 
This function allows the oven to automatically switch off at the end of a programmed cooking duration time. Place food in the oven, select a cooking function and adjust the cooking temperature. Press button
repeatedly to select the “Cooking Duration” function. The relevant pilot lamp
will start flashing. Then, proceed as follows:
To set the duration time:
1.Press button “
” or “ ”.
2.After the setting is carried out, wait for 5 seconds: the "Cooking Duration" pilot lamp
will come on and the display will revert to the time of day.
3.When cooking time is over, the oven will be switched off automatically and an acoustic alarm will be heard, while the pilot lamp will start flashing. Turn the oven function and the thermostat control knob to zero.
To switch off the acoustic alarm, press any button.
NOTE: turning the acoustic alarm off will reset the oven to manual, and if the oven function and the thermostat knobs are not set to zero the oven will start to heat again.
To cancel the duration time:
1.Press button 
repeatedly to select the “Cooking Duration” function. The relevant pilot lamp
will flash and the display will show the remaining cooking time.
2.Press button “ ” until the display shows “0:00”. After 5 seconds the pilot lamp will go out and the display will revert to the time of day.
7
“End of cooking” function 
With this function, you can set the oven to switch off automatically when a programmed end of cooking time is over. Placefood in the oven, select a cooking function and adjust the cooking temperature. Press button
repeatedly to select the “End of cooking” function. The relevant pilot lamp
will start flashing. Then, proceed as follows:
To set the End of cooking time:
1.Press button “
” or “ ”.
2.After the setting is carried out, wait for 5 seconds: the “End of cooking” pilot lamp 
will come on and the display will revert to the time of day.
3.When cooking time is over, the oven will be switched off automatically and an acoustic alarm will be heard, while the pilot lamp will start flashing. Turn the oven function and the thermostat control knob to zero.
To switch off the acoustic alarm, press any button. NOTE: turning the acoustic alarm off will reset the oven to manual, and if the oven function and the thermostat knobs are not set to zero the oven will start to heat again.
To cancel the End of cooking time:
1.Press button 
repeatedly to select the “End of cooking” function. The relevant pilot lamp 
will flash and the display will show the programmed End of cooking time.
2.Press button “ ” until the display shows the current time of day. The programmer will beep and the pilot lamp will go out.
“Cooking duration” 
and “End of cooking time” 
combined
The functions “Cooking duration” and “End of cooking time” can be used simultaneously to set the oven to switch on and off automatically at a later time.
1.With the “Cooking duration” function
(carry out the cooking duration setting as described in the relevant chapter) set the duration time. Then, press button 
: the display will show the programmed setting.
2.With the “End of cooking time” function 
(carry out the End of cooking setting as described in the relevant chapter) set the end of cooking time. The relevant pilot lamps will come on and the display will show the time of day. The oven will switch on and off according to the set programmes.
“Minute minder” function 
The minute minder alarm will sound at the end of a timed period, but THE OVEN WILL REMAIN ON, if it is in use.
To set the minute minder:
1.Press button
repeatedly to select the “Minute minder” function. The relevant pilot lamp 
will start flashing.
2.Then, press button “
” or “ ” (maximum: 2 hours, 30 minutes).
3.After the setting is carried out, wait for 5 seconds: the “Minute minder” pilot lamp 
will come on.
4.At the end of the timed period, the pilot lamp will start flashing and an acoustic alarm will be heard. To switch off the acoustic alarm, press any button.
To cancel the minute minder:
1.Press button
repeatedly to select the “Minute minder” function. The relevant pilot lamp 
will flash and the display will show the remaining time.
2.Press button “ ” until the display shows “0:00”. After 5 seconds the pilot lamp will go out and the display will revert to the time of day.
How to switch off the display
1.Press two or three programmer push buttons simoultaneously and keep them pressed for about 5 seconds. The display will switch off.
2.To switch on the display, press any button.
The display can be switched off only if no other functions have been set.
8
Loading...