KITCHENAID HANDLE ACCESSORY
for Built-in Refrigerators
BEFORE YOU BEGIN:
A qualified service technician must perform installation.
IMPORTANT: This handle should NOT be used on acrylic panels.
Kit Contains:
Kit Part Number |
Long Handle |
Short Handle |
Screws |
|
W10541593 |
W10541591 |
|
W10782871 |
2 |
1 |
6 |
|
|
|
|
W10782873 |
2 |
- |
4 |
|
|
|
|
W10782874 |
1 |
1 |
4 |
|
|
|
|
HANDLE INSTALLATION:
•The handle hardware must be installed before installing the custom panel.
•Handle mounting screws will need to be countersunk into custom panel before put into place. Countersink 1⁄4" deep and 1⁄2" diameter for the screw head to be flush with custom panel.
•Recommended center of handle, 41" from floor.
LONG VERTICAL HANDLE
INSTALLATION:
|
<![if ! IE]> <![endif]>38 17⁄64" |
|
Door handle |
|
mounting |
|
screws (2) per |
Door |
door (counter- |
sink screws for |
|
handle |
clearance |
|
before panel is |
Recommend |
put in place) |
|
|
handle centered |
|
41" from floor |
|
Floor
SHORT HORIZONTAL HANDLE
INSTALLATION:
29
Center door handle (left to right)
on bottom panel
1⁄4
"
Door handle mounting screws (2) per door (countersink screws for clearance before panel is put in place)
© Whirlpool Corporation 2015 |
Instruction Sheet W10788846 Rev. A 3/15 |
(All Rights Reserved) |
|