Powerfix Z29663 User Manual

270°

0°

PROTRACTOR SPIRIT LEVEL

Operation and Safety Notes

A

9

1 212 12 3 4

B

T

1011

56789

Protractor Spirit Level

Introduction

The instructions for use are a component of this product.

They contain important information pertaining to safety,

use and disposal. Prior to use, familiarise yourself with
all the operating and safety instructions for this product. Only
use the product as described and for the indicated range of
applications. If passing this product on to a third party also
include all documents.

Measuring jaw T

10

Goniometer scale

11

Locking screw

12

Marking aids for hanging

Scope of delivery

1 Protractor Spirit Level
1 Pencil
2 Scribers
1 Directions for use

Z29663

This device is not a toy. It does not belong in the hands of

children. Children do not appreciate the dangers associated
with the device.

Risk of injury!

Handle the device with care when the scribers have been

inserted into the measuring jaws. Otherwise you could
injure yourself and other people.

Do not damage the spirit levels. If the spirit level is damaged,

avoid coming into any contact with the fluid that is in the
spirit level. Should you come into contact with it, you must
observe the following instructions. First-aid measures with:

- SKIN CONTACT: Immediately clean the affected area

with lots of soap and water for at least 15 minutes. If the
skin continues to be irritated, go to a doctor.

- EYE CONTACT: Immediately rinse the affected eye with

lots of water for at least 15 minutes. Use your thumb and
forefinger to hold the affected eye open. Go to a doctor
immediately.

- INHALATION: Immediately get a lot of fresh air. If there

are respiratory problems, use pure oxygen.

- CONTACT WITH THE ORAL CAVITY (MOUTH):

Immediately rinse the inside of the mouth out with lots of
water if the person affected is conscious. Go to a doctor
immediately.

Examples of use

Note: Loosen the locking screw 11 before opening measuring

1

jaws

and 9. Tighten the locking screw 11 again after

aligning the measuring jaws.

6

B

C

Measuring angles

Place the measuring jaw 1 onto the respective area.
Open the measuring jaw 9 upwards until the bubble of air

in the vertical spirit level
is precisely in the centre (see fig. A).
Note: The bubble in the spirit level must be located precisely
in the middle of the marks. The arrowhead indicates the
respective angle on the goniometer scale

Place legs 1 and 9 on the surfaces in question. Now

you should be able to read the angle (0 – 270°) between
the two surfaces (see Fig. B).

Measuring areas

Horizontal and vertical surfaces of 0 – 19 ⅝ inch in length

can be measured using legs

Using the marking aids for hanging

First place the device against the object to be hung.
Measure and note down the distance between the hanging

fixings on the object.

Place the device on to the desired supporting surface.

Note: Ensure that the marking aids for hanging

upwards.

Set the marking aids for hanging 12 to the previously noted

distance apart.

Now mark the desired positions on the supporting surface

using a pencil or similar marker.

7

or the horizontal spirit level 8

10

.

1

and 9 (see Fig. C).

12

point

Intended use

This device is suitable for the horizontal and vertical alignment
of an object and for the measurement of angles. Other types of
use or product modifications are not regarded as intended and
may lead to risks such as injuries and damages. The manufacturer
is not liable for any damages caused by any use other than its
intended purpose. The product is not intended for commercial use.

Description of parts

1

Measuring jaw B

2

Pencil

3

Pencil compartment

4

End cap

5

Compartment for scriber

6

Scriber

7

Vertical spirit level

8

Horizontal spirit level

Removing the marking aids

To use the horizontal spirit level 8 the marking aids 12

need to be removed.

Mounting the scribers

Open the end caps 4.
Remove the scribers 6 from the compartment 5.
Insert one scriber 6 into each opening on the measuring

1, 9

jaw

The goniometer can now be used as a compass.

Cleaning

Do not use corrosive cleaning agents.
Clean the product with a little mild detergent solution and

thoroughly dry it.

Disposal

Contact your local refuse disposal authority for more details of
how to dispose of your worn-out product.

.

The packaging is made entirely of recyclable materials,

which you may dispose of at local recycling facilities.

Technical data

Angle measurement range: 0 – 270°
Bubbles: 1 horizontal and 1 vertical
Legs: 19 ⅝ inch each
Dimensions (closed): approx. 61.5 x 8.5 x 4.4 cm

(L x W x D)

Safety instructions

KEEP ALL THE SAFETY ADVICE AND INSTRUCTIONS IN
A SAFE PLACE FOR FUTURE REFERENCE!

DANGER OF LOSS OF

LIFE OR ACCIDENT TO INFANTS AND
CHILDREN! Never leave children unsupervised

with the packaging materials. Packaging materials present

a suffocation hazard. Children often underestimate danger.
Always keep the product out of reach of children.

GB/IEGB/IE

Product information:

Protractor Spirit Level
Model No.: Z29663
Version: 07 / 2011

Last Information Update: 07 / 2011
Ident. no.: Z29663072011-6

© by ORFGEN Marketing

IAN 63679

Milomex Ltd.

c/o Milomex Services
Hilltop Cottage
Barton Road
Pulloxhill
Bedfordshire
MK45 5HP
UK

GB/IEGB/IEGB/IEGB/IE

63679_pow_Winkelmesser_mit_Wasserwaage_Content_LB6.indd 1 08.07.11 13:30