Thermocouple and Fine Wire Welder
Make Quality Beaded Thermocouples
TL-WELD
UWire-Holding Pliers and Lead
USafety Glasses
UMagnifying Eyeglass
UCarbon Electrodes
USpare 2 A Fuse
UArgon Hose
UPower Cord
UFootswitch for Greater Ease of Use
The TL-WELD is designed for sensor manufacturers who produce commercial-grade thermocouple junctions, and for users of large numbers of exposed junction thermocouples, such as test and development laboratories where multipoint temperature sensing of test pieces is required.
No special skills are needed and most people will be capable of producing quality work with minimal practice. The instrument can be operated via the front panel or by using the footswitch.
This model is suitable for welding wires up to 1.1 mm (0.043") in diameter and has an argon gas shield facility.
A satisfactory thermocouple junction is produced without using argon, but where argon is available a momentary purge is automatically triggered immediately prior to the weld to give optimum weld integrity.
Specifications
General
Energy Output: 0 to 60 joules
Welding Capacity: Wires up to 1.1 mm (0.043") in diameter
Duty Cycle: Minimum 5 to 10 welds/minute
Mechanical
Dimensions:
220 W x 120 H x 250 mm D
(8.7 x 4.7 x 9.9") Weight: 4 kg (8.8 lb)
TL-WELD.
Please see omega.com for thermocouple bare wire.
Beaded Thermocouples Only
TL-WELD-PL shown smaller than actual size.
Electrical
Power Supply:
Standard: 110 to 120 Vac Optional: 220 to 250 Vac, 50 to 60 Hz
Power Consumption:
Max 170 VA dropping to 20 VA during charging
To Order Vist omega.com/tl_weld for Pricing and Details |
|
Model No. |
Description |
TL-WELD |
Thermocouple and fine wire welder |
|
|
Accessory |
|
Model No. |
Description |
TL-WELD-CAR |
Replacement carbon electrodes (package of 5) |
TL-WELD-PL |
Pliers for TL-WELD |
For 220 Vac, add suffix “-220V” no extra charge.
Ordering Example: TL-WELD, 120 Vac powered welder and TL-WELD-CAR, spare carbon electrodes.
H-10
H