Maytag MED5030MW, YMED5030MW, MGD5430MW Dimension Guide

Dimension Guide

MED5030MW, YMED5030MW - Electric

MGD5030MW - Gas

W11426296B

DETAILED PLANNING DIMENSIONS

WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in your appliance's Owner's Manual, before installing and operating this appliance.

Electrical Requirements

	Fuel Type	Electric	Gas
	Minimum Circuit	30 A	15 A
	Amperage Rating
	Maximum AMP Draw	26 A	6 A
	Operating Voltage	120/240 V AC only	120 V AC only
	Current Canada Rating	24 A	NA
	Operating Frequency		60 Hz
			D
		A	C

B

E	F	G
		90o
		23"
		578 mm

Product Dimensions

		in	mm
A	Height (with leveling legs not extended)	421/4	1071
B	Width	29	737
C	Top Height (with leveling legs not extended)	367∕8	937
D	Depth	287∕16	722
E	Top Height (with leveling legs fully extended)	381/2	978
F	Height (with leveling legs fully extended)	4313∕16	1113
G	Depth with Door Open	5011∕16	1288

2

DETAILED PLANNING DIMENSIONS

Electric

Gas

J

H

		L	M
	O		N
I			K

	R
	P
Q	S
	Product Dimensions

		in	mm
H	Strain Relief from Side (Electric)	153∕4	400
I	Exhaust Duct from Side	147∕16	366
J	Power Cord from Side (Gas)	143∕4	375
K	Gas Connection from Side	93∕16	234
	Power Cord Length (Canadian)	523∕8	1330
	Gas Power Cord Length	60	1524
L	Strain Relief Height (Electric) (with leveling legs not extended)	281∕8	714
M	Power Cord Height (Gas) (with leveling legs not extended)	323∕8	822
N	Gas Connection Height (with leveling legs not extended)	111∕16	43
O	Exhaust Duct Height (with leveling legs not extended)	51∕8	130
P	Strain Relief Height (Electric) (with leveling legs fully extended)	293∕4	755
Q	Exhaust Duct Height (with leveling legs fully extended)	611∕16	170
R	Power Cord Height (Gas) (with leveling legs fully extended)	34	863
S	Gas Connection Height (with leveling legs fully extended)	35∕16	84

3

DETAILED PLANNING DIMENSIONS

Spacing for recessed area or closet installation

The dimensions shown are for the recommended spacing allowed.

ɃAdditional spacing should be considered for ease of installation and servicing.

ɃAdditional clearances might be required for wall, door, and floor moldings.

ɃAdditional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer.

ɃFor closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilations openings are acceptable.

ɃCompanion appliance spacing should also be considered.

14"

(356 mm) maximum

3" (76 mm) 48 in2

(310 cm )

18" (460 mm)

24"2/in24"2 3" (155 cm )

(76 mm)

6"/0"*
(152 mm/0 mm)	1"
1"/0"*	(25 mm)
(25 mm/0 mm)
*Recommended/Minimum spacing

4