Iveco Daily User Manual
Visit https://truckmanualshub.com/ for more information’s
https://truckmanualshub.com/iveco-daily-fault-codes-list/
Iveco Daily Fault Codes List
Blink code (on vehicles up to chassis No.5383302IDI87233)
With the key turned off, press the diagnosis button.
– Two sets of flashes of the EDC warning light with a short pause in between indicate the code number
of the first error stored in memory.
– Press the button again to pass on to the next error.
– After reaching the last error, the first one is repeated.
– The list of errors contains a¦¦ the errors stored in memory and not only the active ones.
– The order of presentation of the errors respects the chronological order in which they appeared.
The table gives the error codes.
To delete the list of errors from the control unit memory, follow this procedure:
– with the key turned off, press the diagnosis button;
– keeping the button pressed, turn the key on;
– keep the button pressed for 5 seconds;
– let go of the button;
– turn the key off.
Visit https://truckmanualshub.com/ for more information’s
https://truckmanualshub.com/iveco-daily-fault-codes-list/
Blink code
Indicator light
Fault description
Power reduction
VEHICLE
1.1
On
Vehicle speed
1.2
Off
(not used)
1.3 Cruise Control buttons
1.4
Blinking
Throttle pedal
*
1.5
Off
Clutch switch
1.6
On
Brake switch
1.7
On
Throttle/brake plausibility
doing
1.8
Off
Main EDC / diagnosis indicator light
1.9
Off
Air–conditioner control contactor
ENGINE
2.1
Blinking
Water temperature sensor
*
2.2
Off
Air temperature sensor
2.3
On
Fuel temperature sensor
2.4
Blinking
Turbocharging pressure sensor
*
2.5
Off
Atmospheric pressure sensor
2.7
On
Fuel motor pump control contactor
2.8
Off
Fuel filter heater control contactor
2.9
On
Fan control contactor
ENGINE 2
3.1
Off
Cylinder 1 balancing
3.2
Off
Cylinder 2 balancing
3.3
Off
Cylinder 3 balancing
3.4
Off
Cylinder 4 balancing
3.5
Off
Battery voltage
3.6
Off
Glow plug indicator light
3.7
Off
Glow plug control contactor
3.9
Off
Pre–heating monitoring
Loading...