gsk GSK ZJY User Manual

In this manual, we have tried as much as possible to describe all the various matters about the spindle servo motor. However, we can not describe all the matters which must not be done or which can not be done because there are so many possibilities. Therefore, matters which are not especially described in this manual should be regarded as “impossible” or “forbidden”.

The copyright of the user manual is owned by GSK CNC Equipment Co., Ltd (Hereinafter referred to as GSK).It is against the law for any organization or individual to reproduce this manual in any form without the permission of GSK and GSK reserves the right to investigate its law duty.

GSK ZJY Series Spindle Servo Motor

PREFACE

Dear user:

It’s our honor that you select GSK ZJY serial spindle servo motor

(Hereinafter referred to as motor).

For safety of the motor and the product and for the normal and effective running, please read the manual carefully before installing and using the product.

GSK ZJY Series Spindle Servo Motor

SAFETY PRECAUTION

The incorrect connection and operation may cause the accident, so

before using and operating the motor, please read the manual carefully!

1. The motor is installed with the photoelectric encoder, and it’s not allowed to hit the motor. And the user can’t disassemble the photoelectric encoder by himself; otherwise, once the encoder is damaged, it may cause the motor out of running!

2. In the normal climate, measure the insulation resistance, which the motor winding is against with the cabinet, by 1000V megameter, and the value should NOT be less than 20 M

Ω.

3. The motor and the drive unit should be connected correctly based on the manual to guarantee the protective grounding stable and reliable.

4. The motor can run with load only after the motor is free of noise and vibration during running from zero speed to the maximum speed in the dry run state.

5. During the motor running, it’s not allowed to touch the motor shaft and cabinet.

6. Only the qualified person can adjust and maintain the motor.

7. It is forbidden to move the motor by dragging the wire (cable), the motor shaft or the encoder.

8. GSK does NOT take any responsibility for any change on the product by the user, and the warranty bill becomes invalid.

All specifications and designs are subject to change without notice.

III

GSK ZJY Series Spindle Servo Motor

RESPONSIBILITY

Responsibility of the manufacturer

——The manufacturer should be in charge of the design and the structure of the motor

and its accessories.

——The manufacturer should be responsible for the safety of the motor and its

accessories.

——The manufacturer should be in charge of the provided information and suggestion

for the user.

Responsibility of the end user

——The user should be very familiar with the safety operation through learning the

motor safety operation or participating in the training session.

——The user should be responsible for the safety after adding, changing or modifying

the original motor and its accessories by himself.

——The user should be in charge of the danger resulted from the operation, adjusting,

maintenance, installation and storage which are not complied with the manual regulation.

The manual is kept by the end user.

Thank you for your friendly support during using GSK product.

+ 14 hidden pages