Page 1
5713219871/01.13
Page 2
BEAN TO CUP ESPRESSO AND
CAPPUCCINO MACHINE
Instruction for use
DE
GB
ECAM23.120
ECAM25.120
Page 3
2
B1
B5
B2
B3
B4
B
B10
B6
B8
B9
B7
C
C2
C4
C1
C3
C5
ElEctrical rEquirEmEnts
Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt
about your supply contact your local electricity company. The exible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13
amp capacity. Should this plug not t the socket outlets in your home, it should be cut o and replaced with a suitable plug, following the procedure
outlined below.
Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left where children might nd it and
plug it into a supply socket - with the obvious consequent danger.
N.B. We recommend the use of good quality plugs and wall sockets that can be switched o when the machine is not in use.
IMPOR TANT: the wires in the mains lead tted to this appliance are coloured in accordance with the following code:
GREEN AND YELLOW EARTH
B LUE NEUTR AL
BROWN LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
- The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or
coloured green or green and yellow.
- The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
- The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. If your electricity
supply point has only two pin socket outlets, or if you are in doubt, consult a qualied electrician. Should the mains lead ever require replacement, it is essential that this
operation be carried out by a qualied electrician and should only be replaced with a exible cord of the same size. After replacement of a fuse in the plug, the fuse cover
must be retted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the
coloured insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover. Only 13amp replacement fuses
which are asta approved to B.S. 1362 should be tted. This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference.
Green and Yellow to Earth
Blue to
neutral
Warning - this appliance must be earthed
2
13 amp
Fuse
Brown to
live
Cord Clamp
Page 4
3
A14
A17
A18
A
A2
A5
A6
A7
A4
A3
A16
A15
A1
A8
A9
PUSH
A11
A12
A10
A13
A21
A19
A19
C
A
P
P
U
C
C
I
N
O
H
O
T
M
I
L
K
A20
3
Page 5
4
1A
55
1B
2
34
56
9
13
10 11 12
14 15 16
78
4
Page 6
5
HOT MILK
21
17
18 19 20
22
25
29
26
30A
30A
27
28
31 32
H
H
PUS
5
PUS
Loading...