Series 5
Series 5 
s
e
ive nsit
|
|
|
|
|
|
Type 5751 |
|
590 cc-4 |
Modèle 5751 |
|
|
|
565 cc-4 |
|
Modelo 5751 |
|
|
www.braun.com/register |
|
550 cc-4 |
|
|
|
English |
4 |
Thank you for purchasing a Braun product. |
|
|
|
We hope you are completely satisfied with |
|
Français |
17 |
your new Braun shaver. |
|
|
|
If you have any questions, please call: |
|
Español |
26 |
US residents |
1-800-BRAUN-11 |
|
|
|
1-800-272-8611 |
|
|
Canadian residents 1-800-387-6657 |
|
Merci d’avoir fait l’achat d’un produit Braun. Nous espérons que vous serez entièrement satisfait de votre nouveau rasoir Braun.
Si vous avez des questions, veuillez appeler Braun Canada au : 1-800-387-6657
Gracias por haber comprado un producto Braun.
Esperamos que quede completamente satisfecho con su nueva afeitadora Braun. Si tiene alguna duda, por favor llame al:
01(800) 508-5800
99490656/III-10 USA / CAN / MEX
3 |
4 |
5 |
7
Series 5 |
2
1
STOP
8
9
10
11
12
13
14
6
15
16
17
18
|
|
e |
|
|
iv |
|
|
it |
|
|
s |
s |
e |
n |
|
|
590/565 550
19
5
sensiitiiv
3
A
1
2
new/nouvelle
s
B 
|
|
|
e |
|
|
|
iv |
|
|
|
it |
|
e |
n |
s |
s |
|
|
|
|
|
|
+
-
s
1 |
2 |
3 |
1 |
2 |
3 |
|
|
|
|
||||
|
|
|
|
|
|
|
|
iv |
|
it |
|
s |
e |
n |
|
90°
nsitiv 
4
C
a ••• b •••
s
c
D
s i t i v e
s i t i v e
new/ nouvelle
old/usée
s i t i v e
5
English
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following:
Read all instructions before using this appliance.
When disconnected, the hand-held part of this shaving appliance may be cleaned under water.
DANGER
To reduce the risk of electric shock:
1.Use only in dry conditions.
2.Do not submerge in water.
3.Do not reach for an appliance that has fallen into water. Unplug immediately.
4.Do not use while bathing or in a shower.
5.Do not place, store or charge the appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid.
6.Except when charging, always unplug this appliance from the electrical outlet immediately after using.
7.Unplug this appliance before cleaning.
8.This appliance is provided with a special cord set with integrated Safety Extra Low Voltage power supply. Do not exchange or manipulate any part of it.
9.Do not use an extension cord with this appliance.
FOR HOUSEHOLD USE ONLY
6
WARNING
To reduce the risk of burns, fire, electric shock, or injury to persons:
1.Close supervision is necessary when this appliance is used by, on, or near children or invalids.
2.Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
3.Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or if the power supply has been dropped into water. Return the appliance to a service center for examination and repair.
4.Keep the cord away from heated surfaces.
5.Never drop or insert any object into any opening.
6.Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
7.Do not use this appliance with a damaged or broken foil, as serious skin injuries may occur.
8.Always attach plug to appliance first, then to outlet.
To disconnect, turn all controls to «off», then remove plug from outlet.
9.When plugging to an electrical outlet outside the USA, use a plug adapter to match the outlet’s pin configuration.
10.Caution: The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not disassemble heat above 100 °C (212 °F) or incinerate.
SAVE THESE INSTRUCTIONS
7
Warning
Your shaving system is provided with a special cord set, which has an integrated Safety Extra Low Voltage power supply. Do not exchange or tamper with any part of it, otherwise there is risk of an electric shock.
To prevent the cleaning fluid from leaking, ensure that the Clean&Renew station is placed on a flat surface. When a cleaning cartridge is installed, do not tip, move suddenly or transport the station in any way as cleaning fluid might spill out of the cartridge. Do not place the station inside a mirror cabinet, nor place it on a polished or lacquered surface.
The cleaning cartridge contains a highly flammable liquid so keep it away from sources of ignition. Do not expose to direct sunlight and cigarette smoking nor store it over a radiator.
Keep it out of reach of children.
Do not refill the cartridge and use only original Braun refill cartridges.
Description
Clean&Renew™ station
1Level indicator
2Lift button for cartridge exchange
3Station-to-shaver contacts
4Start button
5Station power socket
6Cleaning cartridge
Shaver
7Shaver foil
8Cutter block
9Foil release buttons
10Long hair trimmer
11Comfort setting switch «sensitive»
12Shaver-to-station contacts
13On/off switch
14Shaver display
15Cleaning light (yellow)
16Replacement light for shaving parts
17Shaver power socket
18Special cord set
19Travel pouch
A Before shaving
Prior to first use, you have to connect the shaver to an electrical outlet using the special cord set (18) or alternatively, proceed as follows:
Installing the Clean&Renew station
•Using the special cord set (18), connect the station power socket (5) to an electrical outlet.
•Press the lift button (2) to open the housing.
•Hold the cleaning cartridge (6) down on a flat, stable surface (e.g. table).
•Carefully remove the lid from the cartridge.
•Slide the cartridge into the base of the station as far as it will go.
•Slowly close the housing by pushing it down until it locks.
Charging the shaver in the Clean&Renew station
Insert the shaver head down into the cleaning station. (The contacts (12) on the back of the shaver will align with the contacts (3) in the cleaning station).
If required, the Clean&Renew station will start charging the shaver now.
A full charge provides up to 45 minutes of cordless shaving time. This may vary according to your beard growth.
The best environmental temperature for charging is between 41 °F to 95 °F / 5 °C to 35 °C. Do not expose the shaver to temperatures higher than 122 °F / 50 °C for extended periods of time.
Shaver display
The shaver display (14) shows the charge status of the battery. During charging or when using the shaver, the respective battery segment will blink (green). When fully charged, all segments will light up for approximately one hour, provided the shaver sits in the C&R station.
8
The red low-charge light flashes when the battery is running low.
You should be able to finish your shave.
B Shaving
Press the on/off switch (13) to operate the shaver.
Comfort setting switch «sensitive»
Setting the shaver head according to your comfort needs.
The «sensitive» switch (11) provides three options for comfort setting:
1« + » :
The shaver head is in full swing, freely follows the contours of your skin to provide more comfort.
2middle position:
The shaver head is semi-fixed for more control.
3« – » :
The shaver head is fixed for full control and precise handling in hard to reach areas.
Long hair trimmer
To trim sideburns, mustache or beard, slide the long hair trimmer (10) upwards.
Tips for the perfect shave
For best results, Braun recommends you follow 3 simple steps:
1.Always shave before washing your face.
2.At all times, hold the shaver at right angles (90°) to your skin.
3.Stretch your skin and shave against the direction of your beard growth.
Shaving with the cord
If the shaver has run out of power (discharged), you may also shave with the shaver connected to an electrical outlet via the special cord set.
Cleaning
For best shaving results, we recommend cleaning the shaver in the station after each shave (see «Automatic cleaning»).
All charging and cleaning needs are then automatically taken care of.
Cleaning indicator
Clean your shaver in the Clean&Renew station at the latest when the yellow cleaning light (15) shines constantly after shaving.
If this is not done, the cleaning light will go off after some time and the counter will be reset.
C Automatic cleaning
The Clean&Renew has been developed for cleaning, charging and storing your shaver. After each shave, return the shaver to the Clean&Renew station and proceed as follows:
•Insert the shaver head down into the cleaning station.
•Push down the start button (4). The cleaning process will start (approx. 5 minutes cleaning, 4 hours drying).
•Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use.
If interruption is needed nonetheless, press the start button (4).
•When cleaning is finished, the yellow cleaning light will go off and the shaver is ready for use.
•A cleaning cartridge should be sufficient for about 30 cleaning cycles. When the level indicator (1) has reached the «min» mark, the remaining fluid in the cartridge is sufficient for about 5 more cycles. Then the cartridge should be replaced, when used daily approx. every 4 weeks.
•The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air.
Each cartridge, if not daily used, should be replaced after approximately 8 weeks.
9
•The cleaning cartridge also contains lubricates, which may leave residual marks on the shaver head after cleaning. However, these marks can be removed easily by wiping gently with a cloth or soft tissue paper.
Cleaning the housing
From time to time clean the housing of the shaver and the Clean&Renew station with a damp cloth, especially inside the cleaning chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button (2) to open the housing, wait for a few seconds before removing the used cartridge to avoid any dripping.
Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.
D Manual cleaning
The hand-held unit should be detached from the power supply cord before cleaning. The shaver should not be used until it has dried.
Rinsing the shaver head under running water is an alternative way to keep the shaver clean, especially when traveling:
•Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
•Next, switch off the shaver, press the foil release buttons (9) to remove the shaver foil (7) and cutter block (8). Then leave the disassembled shaving parts to dry.
•If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer (10) and shaver foil (7).
The following quick cleaning is another alternative cleaning method:
•Press the foil release buttons (9) to lift the shaver foil (do not remove the foil completely). Switch on the shaver for approx. 5–10 seconds so that the shaved stubbles can fall out.
•Switch off the shaver. Remove the shaver foil and tap it out on a flat surface. Using a brush, clean the inner area of the shaver
head. However, do not clean the shaver foil nor the cutter block with the brush as this will damage them.
Keeping your shaver in top shape
Replacing the foil and cutter block / reset
To maintain 100% shaving performance, replace the shaver foil (7) and cutter block (8), when the replacement symbol (16) lights up (after about 18 months) or when cassette is worn.
The replacement symbol will remind you during the next 7 shaves to replace the shaver foil and cutter block. Then the shaver will automatically reset the display.
After you have replaced the shaving parts (foil and cutter block), press the on/off switch (13) for at least 5 seconds to reset the counter.
While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time.
Accessories
Available at your dealer or Braun Service Centers:
•Shaver foil and cutter block: 51S
•Cleaning cartridge Clean&Renew: CCR
10
Environmental notice
This appliance contains rechargeable batteries. To protect the environment, do not dispose of the appliance in the
household waste at the end of its useful life. Disposal can take place at a Braun Service Center or appropriate collection sites.
The cleaning cartridge can be disposed with regular household waste.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
11
Loading...