Extractor hood
en Instructions for installation and use
en |
|
Table of contents |
|
INSTRUCTION MANUAL.......................................................... |
2 |
8Intended use................................................................... |
2 |
(Important safety information........................................ |
2 |
7Environmental protection ............................................. |
4 |
ÇOperating modes ........................................................... |
4 |
1Operating the appliance................................................ |
5 |
2Cleaning and maintenance ........................................... |
8 |
3Trouble shooting ........................................................... |
9 |
4Customer service......................................................... |
10 |
INSTALLATION INSTRUCTIONS........................................... |
11 |
(Important safety information...................................... |
12 |
KGeneral information..................................................... |
13 |
5Installation.................................................................... |
14 |
INSTRUCTION MANUAL |
|
Additional information on products, accessories, |
|
replacement parts and services can be found at |
|
www.bosch-home.com and in the online shop |
|
www.bosch-eshop.com |
|
8Intended use |
|
Read these instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual and installation instructions for future use or for subsequent owners.
The appliance can only be used safely if it is correctly installed according to the safety instructions. The installer is responsible for ensuring that the appliance works perfectly at its installation location.
This appliance is intended for domestic use and the household environment only. The appliance is not intended for use outside. Do not leave the appliance unattended during operation. The manufacturer is not liable for damage which is caused by improper use or incorrect operation.
This appliance is intended for use up to a maximum height of 2000 metres above sea level.
This appliance may be used by children over the age of 8 years old and by persons with reduced physical, sensory or mental capabilities or by persons with a lack of experience or knowledge if they are supervised or are instructed by a person responsible for their safety how to use the appliance safely and have understood the associated hazards.
Children must not play with, on, or around the appliance. Children must not clean the appliance or carry out general maintenance unless they are at least 8 years old and are being supervised.
Keep children below the age of 8 years old at a safe distance from the appliance and power cable.
Check the appliance for damage after unpacking it. Do not connect the appliance if it has been damaged in transport.
This appliance is not intended for operation with an external clock timer or a remote control.
(Important safety information
:Warning
Danger of suffocation!
Packaging material is dangerous to children. Never allow children to play with packaging material.
:Warning
Danger of death!
Risk of poisoning from flue gases that are drawn back in.
Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as room airdependent heat-producing appliance is being operated.
2
Room air-dependent heat-producing appliances (e.g. gas, oil, wood or coaloperated heaters, continuous flow heaters or water heaters) obtain combustion air from the room in which they are installed and discharge the exhaust gases into the open air through an exhaust gas system (e.g. a chimney).
In combination with an activated vapour extractor hood, room air is extracted from the kitchen and neighbouring rooms - a partial vacuum is produced if not enough fresh air is supplied. Toxic gases from the chimney or the extraction shaft are sucked back into the living space.
■Adequate incoming air must therefore always be ensured.
■An incoming/exhaust air wall box alone will
not ensure compliance with the limit. Safe operation is possible only when the partial vacuum in the place where the heatproducing appliance is installed does not exceed 4 Pa (0.04 mbar). This can be
achieved when the air needed for combustion is able to enter through openings that cannot be sealed, for example in doors, windows, incoming/exhaust air wall boxes or by other technical means.
In any case, consult your responsible Master Chimney Sweep. He is able to assess the house's entire ventilation setup and will suggest the suitable ventilation measures to you.
Unrestricted operation is possible if the vapour extractor hood is operated exclusively in the circulating-air mode.
Important safety information en
:Warning
Risk of fire!
■ Grease deposits in the grease filter may catch fire.
Clean the grease filter at least every
2 months.
Never operate the appliance without the grease filter.
■ Grease deposits in the grease filter may catch fire. Never work with naked flames close to the appliance (e.g. flambéing). Do not install the appliance near a heatproducing appliance for solid fuel (e.g. wood or coal) unless a closed, nonremovable cover is available. There must be no flying sparks.
■ Hot oil and fat can ignite very quickly. Never leave hot fat or oil unattended. Never use water to put out burning oil or fat. Switch off the hotplate. Extinguish flames carefully using a lid, fire blanket or something similar.
■ When gas burners are in operation without any cookware placed on them, they can build up a lot of heat. A ventilation appliance installed above the cooker may become damaged or catch fire. Only operate the gas burners with cookware on them.
■ Operating several gas burners at the same time gives rise to a great deal of heat. A ventilation appliance installed above the cooker may become damaged or catch fire. Never operate two gas burners simultaneously on the highest flame for longer than 15 minutes. One large burner of more than 5 kW (wok) is equivalent to the power of two gas burners.
:Warning
Risk of burns!
The accessible parts become very hot when in operation. Never touch hot parts. Keep children at a safe distance.
:Warning
Risk of injury!
■ Components inside the appliance may have sharp edges. Wear protective gloves.
■ Items placed on the appliance may fall down. Do not place any objects on the appliance.
■ The light emitted by LED lights is very dazzling, and can damage the eyes (risk group 1). Do not look directly into the switched on LED lights for longer than 100 seconds.
3
en Environmental protection
:Warning
Risk of electric shock!
■ A defective appliance may cause electric shock. Never switch on a defective appliance. Unplug the appliance from the mains or switch off the circuit breaker in the fuse box. Contact the after-sales service.
■ Incorrect repairs are dangerous. Repairs may only be carried out and damaged power cables replaced by one of our trained after-sales technicians. If the appliance is defective, unplug the appliance from the mains or switch off the circuit breaker in the fuse box. Contact the aftersales service.
■ Do not use any high-pressure cleaners or steam cleaners, which can result in an electric shock.
Causes of damage
Caution!
Risk of damage due to corrosion. Always switch on the appliance while cooking to avoid condensation. Condensate can produce corrosion damage.
Always replace faulty bulbs to prevent the remaining bulbs from overloading.
Risk of damage due to ingress of humidity into the electronic circuitry. Never clean operator controls with a wet cloth.
Surface damage due to incorrect cleaning. Clean stainless steel surfaces in the direction of the grain only. Do not use any stainless steel cleaners for operator controls.
Surface damage due to strong or abrasive cleaning agents. Never use strong and abrasive cleaning agents.
Risk of damage from returning condensate. Install the exhaust duct in such a way that it falls away from the appliance slightly (1° slope).
7Environmental protection
Environmentally-friendly disposal
Dispose of packaging in an environmentally-friendly manner.
This appliance is labelled in accordance with European Directive 2012/19/EU concerning used electrical and electronic appliances (waste electrical and electronic equipment - WEEE). The guideline determines the framework for the return and recycling of used appliances as applicable throughout the EU.
ÇOperating modes
Exhaust air mode
The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system.
Note: The exhaust air must not be conveyed into a functioning smoke or exhaust gas flue or into a shaft which is used to ventilate installation rooms which contain heat-producing appliances.
■Before conveying the exhaust air into a nonfunctioning smoke or exhaust gas flue, obtain the consent of the heating engineer responsible.
■If the exhaust air is conveyed through the outer wall, a telescopic wall box should be used.
Circulating-air mode
The air which is drawn in is cleaned by the grease filters and an activated carbon filter and conveyed back into the kitchen.
Notes
■To bind odours in circulating-air mode, you must install an activated carbon filter. The different options for operating the appliance in circulating-air mode can be found in the brochure. Alternatively, ask your dealer. The required accessories are available from specialist retailers, from customer service or from the Online Shop.
■For appliances with an additional internal filter, only the CleanAir recirculation module (see Accessories for circulating-air mode) can be used.
4
1Operating the appliance
These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance.
Note: Switch on the extractor hood when you start cooking and switch it off again several minutes after you have finished cooking. This is the most effective way of removing the kitchen fumes.
Control panel model 1
Control panel
ERRVW 
Explanation
%Fan on/off
-Reduce the fan settings/fan run-on time
+ Increase the fan settings/intensive setting 1, 2
BLight on/off/dimming
Setting the fan
Switching on the appliance
■Press the % button.
The fan starts at setting ƒ.
■Press the + or - button to change the fan strength.
Switching off
■ Press the % button.
Intensive setting
You can use the intensive setting if there is a large build-up of odours and fumes/vapours.
Press the + button when the fan is at setting „.
The intensive boost setting‚ is activated. Pressing the + button again activates the intensive boost ƒsetting.
After approx. six minutes, the electronics automatically reduce the fan to a lower setting . If you want to end the intensive setting before the preset time expires, press the - button until the required fan setting is reached.
Fan run-on time
Press the - button until ‚r appears.
After approx. ten minutes, the fan switches off automatically.
Operating the appliance en
Lighting
The lighting can be switched on and off independently of the fan.
Press the B button.
Setting the brightness
Press and hold the B button until the desired brightness is reached.
Saturation display
When the metal mesh grease filters or the activated carbon filter are saturated, a signal sounds for approx. 4 seconds after the fan is switched off.
In addition, the corresponding symbol appears in the display:
■Metal mesh grease filter: #
■Activated carbon filter: ’#
If you have not yet done so, the metal mesh grease filters should be cleaned or the activated carbon filter changed now.
For instructions on how to clean the metal mesh grease filters, please refer to the section Cleaning and
maintenance.
While the saturation displays are flashing, they can be reset. To do this, press the – button.
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display must be switched over accordingly:
■The extractor hood must be connected and switched off.
■Press the % and - button at the same time until the ™#display for starter sets for circulating-air mode or
’# display for CleanAir circulating air modules lights up.
■Repeatedly press the button combination to switch the electronic control display back to exhaust air mode (# display).
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the % and +
buttons at the same time for approx. three seconds. An acknowledgement signal sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
5
Loading...