Aeg-electrolux EC600R JS, EC1200R JS, EC1200L JS, EC600L JS, EC1000L JS Manual

HIDEAWAY MINI-KITCHEN INSTRUCTIONS

ELECTRICAL - Sockets for the mini-kitchen.

An authorized electrician should carry out the electrical installation. The sockets should be fitted on the wall at the back of the sink base (see drawings). The voltage for both the hotplates and the refrigerator is 230 - 240 V.

ASSEMBLING

First unpack the base unit and position in front of the place of installation and provide space around it for assembly. Check that the electrical connections have been prepared prior to the installation.

Remove the protection film from the kitchen sink plus the three screws, (save no. 1) which hold the kitchen sink at the back edge. Unpack the top unit. Unclip the doors and put them aside in order not to damage them. Loosen the six transport screws (save no. 2). Lift up the top unit and place it on top of the base unit.

Please take extreme care, as the 3 metal runners on the lower part of the top unit are very sharp.

Wear heavy-duty protective gloves for this part of the installation.

Take care not to displace the sink fitting from its position on the bottom unit.

Place the top unit level with the front edge of the base unit. Please note the depth of the top unit is 620 mm and the bottom is 600 mm. Screw in the three screws that you saved (no. 1) through the back edge profile. The six transport screws which you saved (no. 2) should be used to attach both of the side rails to the sink unit.

In order to do this, use a metall drill with 2,5 mm diameter and drill through the pre bored holes in the side edge profiles through onto the kitchen sink´s side gables.

Tighten the screws.

Remove the safety metal bar profile that is fitted between the inner sides of the top unit at the lower front edge and re-mount the screws.

FINAL ASSEMBLY

•Re-hang the doors and if needed, adjust the hinges.

•Connect the plugs in the right wall sockets and test all functions.

•Check that the safety micro switch cuts the circuit to the lighting and the hotplates but not to the refrigerator.

•Connect water and run through to check seals are tight.

SAFETY INSTRUCTIONS

The compact kitchen is approved by SEMKO for connection according to the enclosed instructions. The hotplates effect 1000 W respectively 1200 W may not be increased by exchange. The top unit has a safety switch for the hotplates and light / socket assembly.

The safety switch closes the circuit when the door is shut and may not be bypassed.

822 90 24-12