USER MANUAL
EFC90950
We were thinking of you when we made this product
electrolux 3
EN |
|
IMPORTANT SAFETY INFORMATION |
4 |
YOUR APPLIANCE |
5 |
OPERATING INSTRUCTIONS |
6 |
MAINTENANCE AND CLEANING |
8 |
SOMETHING NOT WORKING |
11 |
GUARANTEE/CUSTOMER SERVICE |
12 |
GUARANTEE CONDITIONS |
13 |
INSTALLATION INSTRUCTIONS |
15 |
ELECTRICAL CONNECTIONS |
16 |
INSTALLING THE COOKER HOOD |
17 |
EN
Welcome to the world of Electrolux
Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual. Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. We promise that it will provide a superior User Experience delivering Ease-of-Mind.
Good luck!
Guide to use the instruction book
The following Symbols will be found in the text to guide you through the instruction book
Safety instructions |
Step by step instructions |
|
|
|
4 electrolux IMPORTANT SAFETY INFORMATION |
|
IMPORTANT SAFETY INFORMATION |
|
These warnings are provided in the interests of your safety. Ensure that you |
|
understand them all before installing or using this appliance. Your safety is of |
|
paramount importance. If you are unsure about any of the meanings of these |
EN |
warnings contact the Customer Care Department. |
Installation
•Any installation work must be undertaken by a qualified electrician or a competent person.
•This hood must be installed in accordance with the installation instructions and all measurements must be adhered to.
•If the cooker hood is installed for use above a gas appliance then the provision for ventilation must be in accordance with the Gas Safety Codes of Practice BS.6172, BS.5440 and BS.6891 (Natural Gas) and BS.5482 (LP Gas) 1994, the Gas Safety (Installation & Use) Regulations, the Building Regulations issued by the Department of the Environment, the Building standards (Scotland) (Consolidated) Regulations issued by the Scottish Development Department.
•The fan motor of this cooker hood incorporates a cut-out device which will operate if the cooker hood is installed below the minimum height recommended under section ‘Clearance Height’, or if the motor becomes overheated. If the cutout device is activated, switch off the fan motor and allow the cooker hood to cool. The cut-out device will reset itself when the fan motor has cooled significantly.
•It is dangerous to alter the specifications or modify this product in any way.
•When installed between adjoining wall cabinets the wall cabinets must not overhang the hob.
•If the room where the hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the room sealed or balanced flue type.
•If other types of flue or appliances are fitted ensure that there is an adequate supply of air to the room.
•The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose.
•Do not install above a cooker with a high level grill.
Child Safety
•This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance.
During Use
•This product is for domestic use only.
•Never leave frying pans unattended during use as over-heated fats and oils might catch fire.
•Never do flambé cooking under this cooker hood.
•Do not leave naked flames under the hood.
•This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.
Maintenance and Service
•This appliance can be a hazard if the synthetic paper and charcoal filters are not replaced as recommended.
•Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunction. Refer to your local Electrolux Service Force Centre. Always insist on genuine spare parts.
YOUR APPLIANCE AND OPERATING INSTRUCTIONS electrolux 5
YOUR APPLIANCE
EN
650 min. |
6 electrolux YOUR APPLIANCE AND OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
The cooker hood is designed to extract
unpleasant odours from the kitchen, it will not extract steam.
EN
The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button.
S1
|
|
L |
T1 |
T2 |
T3 |
T4 |
KEY |
|
LED |
FUNCTIONS |
|
|
|
L |
0/1 Light |
|
Turns lighting on and off. |
|
|
|
T1 |
0/1 Motor |
on |
First speed. |
|
|
|
|
|
|
When pressed for about 1 seconds the motor is switched off. |
|||
T2 |
Speed |
on |
Second speed. |
|
|
|
T3 |
Speed |
on |
Third speed. |
|
|
|
T4 |
Speed |
Fixed |
Max. speed |
|
|
|
|
|
Flashing |
Intensive speed. |
|
|
|
|
|
|
Suitable for the strongest cooking vapours and odours. |
|||
|
|
|
The function |
becomes active when the button is pushed |
||
|
|
|
for about 2 seconds. After 10 minutes of functioning it turns |
|||
|
|
|
off automatically. This function can be interrupted by means of |
|||
|
|
|
pressing any of the buttons. |
|
||
S1 |
Led |
Fixed |
Indicates that the Metal grease filters saturation alarm has |
|||
|
|
|
been triggered, and the filters need to be washed. The alarm |
|||
|
|
|
is triggered after 100 working hours. (Reset; check the |
|||
|
|
|
Maintenance-paragraph) |
|
|
|
|
|
Flashing |
indicates that the activated charcoal odour filter saturation |
|||
|
|
|
alarm has been triggered, and the filter has to be replaced; the |
|||
|
|
|
metal grease filters must also be washed. The activated |
|||
|
|
|
charcoal odour filter is triggered after 200 working hours. |
|||
|
|
|
(Activation and Reset; check the Maintenance-paragraph) |
|||
To Operate
Select the required fan speed and light if required.
Recirculation
In the recirculation mode the contaminated air enters the cooker hood through the grease filters. The air is cleaned by passing through the charcoal filters before being passed back into the kitchen through the grilles in either side of the chimney stack.
Extraction
In the extraction mode the contaminated air enters the cooker hood passing through the grease filters and is passed out through the ducting into the atmosphere.
To obtain the best performance when cooking it is advisable to switch the cooker hood on for a few minutes before you start cooking and leave it running for about 15 minutes after finishing.
When used in the ducting mode the charcoal filters are not required.
Never do flambé cooking under this cooker hood.
Never leave frying pans unattended during use, as over-heated fats and oils can catch fire.
Do not leave naked flames under the cooker hood.
Ensure heating areas on your hob are covered with pots and pans when using the hob and cooker hood simultaneously.
electrolux 7
EN
8 electrolux MAINTENANCE AND CLEANING
MAINTENANCE AND CLEANING
|
Before carrying out any maintenance |
|
or cleaning isolate the cooker hood |
EN |
from the mains supply. |
|
The cooker hood must be kept clean, |
|
as a build up of grease or fat can be a |
|
fire hazard. |
|
External Cleaning |
|
Wipe the cooker hood frequently with |
|
warm soapy water using a mild detergent. |
Never use scouring pads or abrasive cleaners.
Never use excessive amounts of water when cleaning particularly around the control panel.
Metal Grease Filters
The filters are washable and must be cleaned when the Led S1 lights up or at least every 2 months of operation, or more frequently for particularly heavy usage.
Remove the metal grease filters one at a time by:
Releasing the catches on the filters, the filters can be removed.
The metal grease filters should be washed, by hand, in mild soapy water or in a dishwasher. Allow to dry completely before replacing.
Alarm signal reset
Switch off the lights and extractor motor.
Press Button T3 for at least 3 seconds, until the leds start to flash.
Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply.
Charcoal Filters
In the recirculation mode the charcoal filters absorb smells and unwanted odours.
Enabling the alarm signal
•In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or at a later date.
•Turn the Lights and the suction Motor off.
•Disconnect the Hood using the Main switch or the double-pole switch on the mains power supply.
•Restore the connection by pressing and holding T1.
•Release the button. All five LEDs are turned on
•Within 3 seconds press T1 until LEDs T1 and T4 flash in confirmation:
•LED flashes twice - Activated charcoal filter saturation alarm ENABLED
•LED flashes once - Activated charcoal filter saturation alarm DISABLED
MAINTENANCE AND CLEANING electrolux 9 |
|
The filter is not washable and cannot |
|
be regenerated. It must be replaced |
|
when led S1 flashes or at least every |
|
4 months. The alarm signal will only |
|
light up when the extractor motor is |
EN |
switched on. |
To Remove/Replace the
Charcoal Filters
•Remove the metal grease filters
•Remove the saturated activated carbon filter by releasing the fixing hooks
•Fit the new filter by hooking it into its seating
•Replace the metal grease filters.
This appliance can be a possible fire hazard if the grease and charcoal filters are not cleaned and replaced as recommended.
Alarm signal reset
•Switch off the lights and extractor motor.
•Press button T3 for at least 3 seconds, until the leds start to flash.
Loading...