Blaupunkt RCR 127 User Manual

0 (0)

Radio / Cassette

Dakota RCR 127

Operating instructions

Contents
Quick reference ............................	20
Important notes ............................	23
Precautions ...........................................	23
Traffic safety .........................................	23
Installation .............................................	23
Accessories ..........................................	23
Second KeyCard ...................................	23
KeyCard theft protection system 24
Putting the unit into operation ..............	24
Removing the KeyCard ........................	24
“Training” a second KeyCard/
Replacing a KeyCard ............................	24
Displaying the radio pass data .............	24
Short Additional Memory (S.A.M.) ........	25
Turn On Message (T.O.M.) ..................	25
Optical indication of anti-theft
protection ..............................................	25
Care of your KeyCard ...........................	25
Selecting the audio source .........	25
Radio operation with RDS ...........	26
AF - Alternative frequency ....................	26
REG - regional programme ..................	26
Station tuning ........................................	26
Automatic tuning / .......................	26
Manual tuning with << >> ..................	27
Scrolling through the broadcasting
networks ................................................	27

Changing the memory bank .................	27
Storing stations .....................................	27
Automatically storing the strongest
stations with Travelstore .......................	27
Recalling stored stations ......................	28
Scanning stored stations with
Preset Scan ..........................................	28
Selecting the seek tuning sensitivity ....	28
Stereo - mono switching .......................	28
Loudness ..............................................	28
Receiving traffic programme
stations with RDS-EON................	29
Traffic announcement priority on/off ....	29
Beep tone .............................................	29
Switching off the beep tone ...............	29
Automatic seek tuning start
(tape operation) ....................................	29
Adjusting the volume for traffic
announcements and the beep tone ......	30
Cassette operation .......................	30
Inserting a tape .....................................	30
Ejecting a tape ......................................	30
Fast winding ..........................................	30
Reversing the tape ...............................	30
Listening to the radio during fast tape
winding with RM (Radio Monitor) .........	31
Care notes ............................................	31

DSC programming .......................	32
Overview of DSC factory settings ........	33
Specifications ...............................	33
Blaupunkt telephone hotline .................	34

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS

Quick reference

1On Off Volume

When switching the set on with the knob, the KeyCard has to be inserted. The unit will play with the preadjusted volume.

Switching on/off with the KeyCard:

The set has to be turned on with the knob.

Notice:

Read the information in chapter “KeyCard theft protection system”.

Switching on/off via the ignition:

When connected correspondingly, the set can also be turned on and off with the vehicle ignition.

After the ignition has been switched off, a double beep tone will remind you that you should remove the KeyCard before leaving your vehicle.

Switching on with the ignition being switched off:

To keep on operating the set when the ignition is switched off (KeyCard is inserted), proceed as follows:

Turn the knob to switch the unit off, wait for about 2 seconds and turn it on again.

To avoid that the battery goes flat, the system will be turned off automatically after one hour of playback.

2SCA / SRC

SCA – Preset Scan

Press SCA/SRC for about 1 second - The stations stored on the preset buttons will be scanned.

The indicators for the waveband, memory bank and preset button will flash in the display.

To stop Preset Scan:

Press SCA/SRC again for about 1 second.

SRC (Source)

Press SRC/SRC briefly –

You can switch between radio and cassette mode, if a cassette is inserted.

3TS/FM

Selector key to access the memory banks I, II and T.

To switch over:

Press TS/FM as many times as required.

Travelstore

To store and recall the five most powerful stations with Travelstore.

To store: Press button for approximately 1 sec. until you hear a beep

and “T-STORE” appears in the display. To recall: Select the memory bank “T” and press the corresponding preset button (1-5) briefly.

4Cassette ejection

Press .

5Cassette loading slot

Insert the tape with side A or 1 facing up, the open side showing to the right.

6Reversing the tape / Fast winding

Reversing the tape/fast winding

Press FR and FF buttons at a time.

TR1 or TR2 will be displayed.

Fast winding

FR : fast rewind, press FF to stop FF : fast forward, press FR to stop

7AF / TA

AF – Alternative frequency in RDS mode:

When “AF” is displayed, the radio’s RDS module is searching for a frequency offering the same programme in a better quality.

AF on/off: press button for about 1 second.

TA (Traffic Announcement = priority for traffic stations)

If “TA” is displayed, the radio will play traffic stations only.

Priority on/off: press button briefly.

81, 2, 3, 4, 5 - preset buttons

You can store five stations for each of the memory banks I, II and T.

To store a station: Press a preset button during radio operation and hold down until the set resumes play (beep).

To recall a station: Select the desired memory bank and press the relevant preset button briefly.

9KeyCard theft protection system

To operate the set it is necessary that the KeyCard is inserted.

KeyCard

Inserting the KeyCard

With the KeyCard tongue sticking out of the unit, introduce the KeyCard into the slot with the contact area showing up.

To remove the card, press first to unlock.

Read also the information in chapter “KeyCard theft protection system”.

Flashing KeyCard tongue

When the radio is turned off and the KeyCard removed, the KeyCard tongue can be programmed to flash for optical theft protection.

For more information see chapter “DSC programming”.

This flashlight can be switched off by pushing in the tongue and lock. “WRONG KC” will briefly appear on the display and the set will switch off automatically.

DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS

: Display

c d e

f g h i

a)NDR1 NDS - Station name

b)TR 1 - Track (side) 1 of the cas-

		sette
c)	FM	- Waveband
d)	I, II, T	- Memory bank I, II or
		Travelstore
e)	5	- Preset button (1-5)
f)	AF	- Alternative frequency for
		RDS operation
g)	TP	- A traffic station is being
		received
h)	TA	- Priority for traffic stations
i)	LD	- Loudness on

; Rocker switch

/	Station search
	Up
	Down
<</>>	Up/Down in short intervals when AF
	is off
<</>>	To scroll through the station net-
	works when AF is on, e.g.NDR 1, 2,
	3, 4, N-JOY, FFN, ANTENNE ... .

Extra rocker switch functions:

Further setting functions with

AUD <

DSC Mode <

Condition: The corresponding function is activated.

<AUD

To adjust the treble, bass, balance and fader.

If the display shows “TRE” or “BAS”, you can adjust the reproduction of the treble and bass frequencies with the rocker switch. If “BAL” or “FAD” is displayed, you can set the balance (left/ right) and fader (front/rear).

Briefly press AUD as many times as required and make the setting using the rocker switch.

Treble + / Fader front

Treble – / Fader rear

Bass – / Balance left

Bass + / Balance right

The last setting will be stored automatically.

To switch off AUD: Press button briefly again.

If the setting remains unchanged within 8 seconds, the display will switch back to the previous condition.

+ 13 hidden pages