Gas Dryer
PRODUCT MODEL NUMBERS
WGD70HEB, WGD80HEB, WGD86HEB,
WGD88HEA, WGD94HEA, WGD96HEA
Front view: |
Side view: |
27" (686 mm)
381/8"
(968 mm)
3/4"*
(18 mm)
Back view: |
Recommended Installation Spacing: |
61/4"
(159 mm)
|
Water inlet |
|
|
|
(Steam Models Only) |
|
297/8"* |
|
|
|
|
|
|
|
(759 mm) |
53/4"* |
|
|
31/2"* |
(146 mm) |
Vent |
|
|
|
|
(89 mm) |
|
|
Gas |
|
5" |
|
|
(127 mm) |
|
|
|
|
|
|
|
|
61/8"* |
3/4"* |
14 |
3 |
(156 mm) |
(18 mm) |
/8" |
|
|
(365 mm) |
|
||
|
|
||
|
253/4" |
|
|
|
(654 mm) |
|
|
NOTE: Most installations require a minimum of 5" (127 mm) clearance behind dryer for exhaust vent with elbow. See “Venting Requirements”.
|
3" |
|
18" min. |
(76 mm) |
48 in.2 min. |
(457 mm) |
|
|
|
(310 cm2) |
24 in.2 min.
(155 cm2)
3" (76 mm)
1" |
1" |
|
(25 mm) |
||
(25 mm) |
||
|
* 0" (0 mm) spacing is allowed.
Installation spacing for recessed area or closet installation
The dimensions shown below are for the recommended spacing for this dryer. |
|
■■ Additional spacing should be considered for ease of installation and servicing. |
|
■■ Additional clearances might be required for wall, door, and floor moldings, and dryer venting. |
|
■■ Additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer. |
|
■■ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. |
|
Louvered doors with equivalent ventilation openings are acceptable.Companion appliance spacing should also |
W10558994 |
be considered. |
01/2013 |