Laser output : Less than 0.5mW on the objective lens
Wavelength : 760-800nm
2
2 SPECIFICATIONS
SR-L250i
TUNER SECTION
Frequency Range: FM: 87.50 MHz to 108.0 MHz (EUR)
76.0 MHz to 90.0 MHz, TV1 to TV3 (JP)
AM: 522 kHz to 1620 kHz (EUR)
522 kHz to 1629 kHz (JP)
SPEAKER SYSTEM Section
Type: 60 mm x 2
Impedance: 4 ohms
GENERAL
Total Output Power 4 W
Power Requirement AC 230V.50 Hz (EUR)
AC 100V.50/60 Hz (JP)
Power Consumption 20 W
Dimension (W x H x D ) 310 x 101 x 210 mm
Weight (net) 2.2 kg
Standard Accessories
Remote Control Unit (RC-1150W or RC-1150B) x1 (EUR)
(RC-1187W or RC-1187B) x1 (JP)
Battey for Remote Control Unit (AAA) x 2
Battey for Memory Backup (CR2032) x1
AM loop antenna x 1
Dock adapter x 6 (adapter "60GB(color) + photo 40/60GB" premounted)
Stereo mini plug cable x 1
AC Adapter x 1
Owner's Manual x 1
Warranty Card x 1 (EUR)
Design and specifications are subject to change without notice.
Weight and dimensions are approximate.
Illustrations may differ slightly from production models.
3
SR-L250i
3 ADJUSTMENTS AND CHECKS
3-1 TUNER SECTION
Use a screwdriver with a plastic or ceramic grip for all adjustment.
3-1-1 AM adjustment
1. Set the function switch to the TUNER position.
2. Set the BAND switch to the AM position.
3. Connect the test loop antenna across the output of the signal generator.
4. Connect the oscilloscope to the PHONES JACK terminal.
5. Connect the digital multimeter to R430/R453 on TUNER PCB.
6. Set the signal generator as listed in the alignment chart.
3-1-2 FM adjustment
1. Set the function switch to the TUNER position.
2. Set the BAND switch to the FM position.
3. Connect the signal generator output through a 75 ohm dummy antenna to "ANT" on MAIN PCB.
4. Connect the oscilloscope to the PHONES JACK terminal.
5. Connect the digital multimeter to R450/C404 on TUNER PCB.
6. Set the signal generator as listed in the alignment chart.