TANDBERG D50503.02 User Manual

TANDBERG Intern MXP Edge Install Kit

If installed, u

nscrew

thumbscrews

Remove the codec.

Unscrew the three (3) bolts

hat hold the codec shelf to

the pole and remove shelf.

Place

the

Precision

Use the same

from STEP 1 to

Use two (2) screws to

Position the

emove the

stand on the

lace the

onto the shelf with the

(be sure that

on the

hand side when facing

Secure the

Edge c

odec

to the system with the

with

Connect

the cables as

. Replace/use

for

camera connection by

ing it through the

cable egress and up the

mall hole on the shelf

Use the shorter camera

cable included with the

upgrade kit to connect the

emove the ferrite

found with the

Turn on the power to

Your TANDBERG Intern system is now HD ready.

Install cable

t Set bolts aside for STEP 2.

(If codec is installed.)

the two from underneath the codec shelf to remove the codec.

Camera onto the shelf and securely mount it with thumbscrew (1) found underneath the shelf.

Camera shelf into position as shown. Be sure to feed the cables through the hole.

stabilize the new shelf.

Edge codec and p

Edge

I/O facing up the power switch is

left –

the back of the system).

Edge cover plate

five (5) screws.

three (3) bolts secure the new

PHD Camera shelf to the pole.

codec and camera

labeled

the short cable

feed

platform.

bead longer camera cable included with the Edge codec and attach it to the new camera cable.

cover plate.

the Edge codec.

D50503.02