IAN 113364
CONVECTION HEATER SKD 2300 B2
CONVECTION HEATER
Operating instructions
KONVEKTOR
Bedienungsanleitung
GB / IE / CY Operating instructions Page 1
DE / AT / CH Bedienungsanleitung Seite 21
Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of
the device.
Klappen Sie vor dem Lesen die Seite mit den Abbildungen aus und machen Sie sich anschließend mit allen
Funktionen des Gerätes vertraut.
1
SKD 2300 B2
GB
IE
Contents
Introduction ...................................................2
Information concerning these operating instructions .............................. 2
Copyright ............................................................... 2
Limitation of liability ....................................................... 2
Intended use ............................................................ 2
Warning notes ........................................................... 3
Safety. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Risk of electrocution ....................................................... 4
Basic safety guidelines ..................................................... 5
Risk of injury if batteries are improperly handled ................................ 7
Before use ....................................................8
Package contents and transport inspection ..................................... 8
Disposal of packaging materials ............................................. 8
Set-up location requirements ................................................ 9
Before initial use ........................................................10
Electrical connection ..................................................... 10
Inserting the batteries in the remote control .................................... 10
Operating components .........................................11
Installation ...................................................12
Fitting the feet. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Wall mounting .......................................................... 12
Handling and operation ........................................13
Switching the appliance on and off .......................................... 13
Selecting the temperature ................................................. 14
Select heat setting ....................................................... 14
Switching on the fan .....................................................14
Set heating time ......................................................... 15
Overheating protection ...................................................15
Frost protection function ...................................................15
Cleaning .....................................................16
Transport and storage .........................................16
Disposal .....................................................16
Disposing of the batteries ................................................. 17
Troubleshooting ..............................................17
Fault causes and rectification ...............................................17
Appendix ....................................................18
Technical data ..........................................................18
Notes concerning the EC Declaration of Conformity ............................18
Warranty ..............................................................19
Service ................................................................ 19
Importer ...............................................................19
2
SKD 2300 B2
GB
IE
Introduction
Information concerning these operating instructions
Congratulations on the purchase of your new appliance.
You have selected a high-quality product. The operating instructions are part of
this product. They contain important information on safety, usage and disposal.
Before using the product, familiarise yourself with all handling and safety guidelines. Use the product only as described and for the range of applications specified. Please also pass these operating instructions on to any future owner(s).
Copyright
This documentation is protected by copyright.
Any copying or reproduction, including in the form of extracts, or any repro-
duction of images (even in a modified state), is permitted only with the written
authorisation of the manufacturer.
Limitation of liability
All the technical information, data and instructions regarding installation, connection and operation contained in these operating instructions corresponds to the
latest information available to us at the time of printing and takes our previous
experience and know-how into account.
No claims can be derived from the details, illustrations and descriptions in these
instructions.
The manufacturer assumes no responsibility for damage caused by failure to
observe these instructions, improper use, incompetent repairs, unauthorised
modifications or for the use of non-approved replacement parts.
Intended use
This appliance is intended only for the heating of indoor living spaces and only
for domestic use. This device can be used free standing or mounted on a wall.
This appliance is not intended for use in areas where special conditions may
apply, such as corrosive or potentially explosive atmospheres (dust, vapour or
gas). Do not use the appliance outdoors. It is not intended for any other or more
extensive use.
Claims of any kind for damage arising as a result of incorrect use will not be
accepted. The risk shall be borne solely by the user.
3
SKD 2300 B2
GB
IE
Warning notes
The following warning notice types are used in these operating instructions:
DANGER
A warning notice at this hazard level indicates an imminently
hazardous situation.
If the hazardous situation is not avoided, it could result in death or serious
physical injury.
► Follow the instructions in this warning notice to avoid the risk of death or
serious injury.
WARNING
A warning notice at this hazard level indicates a potentially
hazardous situation.
Failure to avoid this hazardous situation could result in injury.
► Follow the instructions in this warning notice to prevent injury.
CAUTION
A warning notice at this hazard level indicates a potential for
property damage.
Failure to avoid this situation could result in property damage.
► Follow the instructions in this warning notice to prevent property damage.
NOTE
► A note provides additional information that will assist you in using the
appliance.
4
SKD 2300 B2
GB
IE
Safety
In this section, you will find important safety instructions for using the appliance.
This appliance complies with statutory safety regulations. Improper use may
result in personal injury and property damage.
Do not cover the appliance!
Covering the appliance can lead to overheating and
thus result in a fire!
Caution! Hot surface!
This symbol warns of hot surfaces on the appliance.
There is a risk of burns!
Risk of electrocution
DANGER
Risk of fatal injury from electrocution!
Contact with live cables or components can result in fatal
injury!
Please observe the following safety guidelines to prevent electrical hazards:
► Do not use the appliance if the power cable or the plug are damaged.
► Before using the appliance again, have a new mains power cable installed
by an authorised specialist.
► The appliance housing must not be opened under any circumstances. There
is a risk of electric shock if live connections are touched and the electrical
and mechanical structure is changed.
5
SKD 2300 B2
GB
IE
Basic safety guidelines
To ensure safe operation of the appliance, follow the safety
guidelines set out below:
■ Check the appliance for visible external damage before use.
Do not operate a appliance that has been damaged or
dropped.
■ If the appliance’s mains power cable is damaged, it must be
replaced by the manufacturer, the manufacturer’s customer
service department or by a qualified technician so that risks
can be avoided.
■ This appliance may be used by children aged 8 years and
above and by persons with limited physical, sensory or mental
capabilities or lack of experience and knowledge, provided
that they are under supervision or have been told how to use
the appliance safely and are aware of the potential risks.
Children must not use the appliance as a plaything. Cleaning
and user maintenance tasks may not be carried out by children
unless they are supervised.
■ Children younger than three years old should be kept away
from the appliance unless they are constantly monitored.
■ Children older than 3 and younger than 8 years of age may
only switch the appliance on and off if they are supervised
or instructed in the safe use of the appliance and have understood the resulting dangers, provided that the appliance
is located or installed in its normal operating position.
■ Children older than 3 and younger than 8 years of age may
not plug in, regulate or clean the appliance and may not
carry out user maintenance tasks.
■ Children should be supervised to ensure that they do not
play with the appliance.
■ Caution – some parts of the product may be very hot and
cause burns. Be particularly careful when children and
vulnerable persons are present.
6
SKD 2300 B2
GB
IE
■ The metal surfaces of the appliance can become hot.
Therefore, only hold the appliance by the handles
9
.
■ All repairs must be carried out by authorised specialist com-
panies or by the Customer Service department. Improper repairs can pose significant risks to the user. It will also invalidate any warranty claims.
■ Defective components must always be replaced with original
replacement parts. Only by using original replacement parts
can it be assured that the safety requirements are being complied with.
■ Protect the appliance from penetration by moisture and liquids.
■ Always unplug the appliance from the mains power socket
before cleaning.
■ Always disconnect the power cable from the mains power
socket by pulling on the plug; never pull on the cable.
■ Avoid using extension cables.
■ Do not use the appliance in the vicinity of naked flames.
■ The appliance must not be placed immediately under or over
a mains power socket.
■ Do not use this heater together with a programmable switch,
a timer, a separate remote control system or any other system
which switches on the heater automatically, as this could lead
to a fire risk if the heater is covered or set up incorrectly.
■ Disconnect the plug from the mains power socket if the appli-
ance malfunctions and also during thunderstorms.
■ The appliance must not be used in the immediate vicinity of
a bath, a shower or a swimming pool.
■ The appliance is to be installed so that a person in the bath
or shower is unable to touch the switch and other controls.
■ Do not expose the appliance to spray and/or dripping water
and do not place any objects filled with liquid, such as vases
or open drink containers, on or near the appliance.
7
SKD 2300 B2
GB
IE
Risk of injury if batteries are improperly handled
WARNING
►
Keep batteries out of the reach of children. Children might
put batteries into their mouth and swallow them. If a
battery has been swallowed, seek medical assistance
IMMEDIATELY.
► Do not throw batteries into a fire. Never subject batteries
to high temperatures.
► Risk of explosion! Do not charge batteries unless they
are explicitly labelled as "rechargeable".
► Do not open the batteries or short-circuit them.
► Do not mix different types of batteries. Due to increased
risk of leakage, empty batteries should be removed.
The batteries should also be removed from the remote
control if it is not being used for long periods.
► Battery acid leaking from a battery can cause skin ir-
ritation. In the event of contact with the skin, rinse with
plenty of water. If the liquid comes into contact with your
eyes, rinse thoroughly with water, do not rub and consult
a doctor immediately.
► When handling leaking batteries, always use coated
gloves and protective goggles!
► The chapter entitled "Initial operation" describes how to
correctly insert and remove batteries.
8
SKD 2300 B2
GB
IE
Before use
Package contents and transport inspection
The appliance is supplied with the following components as standard:
▯ 1 convector heater SKD 2300 B2
▯ 1 remote control
▯ 1 CR2032 button cell
▯ 2 feet
▯ 4 screws for the feet
▯ 4 wall brackets
▯ 4 wall plugs with screws for wall mountings
▯ These operating instructions
NOTE
► Check the package for completeness and for signs of visible damage.
► If any items are missing or damaged as a result of defective packaging or
insufficient care during transportation, contact the Service hotline (see the
chapter Service).
Disposal of packaging materials
The packaging protects the appliance from damage during carriage. The packaging materials have been selected for their environmental friendliness and ease
of disposal, and are therefore recyclable.
Returning the packaging to the material cycle conserves raw materials and
reduces the amount of waste which is generated. Dispose of packaging materials
that are no longer needed in accordance with applicable local regulations.
NOTE
► If possible, keep the appliance's original packaging for the warranty period
so that the appliance can be packed properly for return shipment in the
event of a warranty claim.
9
SKD 2300 B2
GB
IE
Set-up location requirements
For safe and trouble-free operation of the appliance, the set-up location must fulfil
the following requirements:
■ The appliance may only be operated in a vertical position and fully assembled.
■ When using the feet, the device must be placed on a firm, flat and even floor.
■ When wall mounting, the appliance must only be mounted in a fixed position on
a vertical wall.
■ The minimum clearances between the housing and other objects must be main-
tained: 10 cm at the sides, 30 cm above, 15 cm below (with wall mounting) and
50 cm in front.
■ Ensure that air can always enter and escape freely. Otherwise, there could be a
heat build-up in the appliance.
■ Do not place the appliance in a hot, wet or extremely moist environment or in the
vicinity of flammable materials.
■ The mains power socket must be easily accessible so that the power cable can
be easily disconnected in an emergency.
■ Environmental temperature range: 0 to +40°C
■ Humidity (no condensation): 5–85%
DANGER
Fire risk due to contact with materials!
There is a risk of fire if the heating elements come into contact
with flammable materials!
► Do not place the appliance in the vicinity of curtains and other flammable
materials.
► Do not allow flammable materials (i.e. textiles) to come into contact with
the appliance.
► Do not cover the appliance.
10
SKD 2300 B2
GB
IE
Before initial use
■ Remove all packaging materials and all transport locks from the appliance.
NOTE
►
You may notice a slight smell when using the appliance for the first time.
This is normal and is completely harmless.
Electrical connection
To ensure safe and trouble-free operation of the appliance after making the
electrical connection, please observe the following advice:
CAUTION
► Before connecting the appliance, compare the connection data (voltage
and frequency) on the rating plate with that of your mains power supply.
These data must agree so that no damage is sustained by the appliance.
► Ensure that the mains power cable is not damaged and is not running over
hot surfaces and/or sharp edges.
► Ensure that the mains power cable is not taut or knotted.
Inserting the batteries in the remote control
If the battery in the remote control 25 is dead, a new CR2032 battery needs to
be inserted.
♦ Open the battery compartment
30
on the underside of the remote control 25.
(see description on the rear of the remote control 25)
♦ Remove the old battery from the remote control
25
.
NOTE
► Please follow the disposal instructions (see section Disposal of batteries).
♦ Insert a new CR2032 battery into the battery compartment
30
.
Ensure the +/- terminals are correctly aligned.
♦ Slide the battery compartment 30 back into the remote control 25.
11
SKD 2300 B2
GB
IE
Operating components
Control panel
2
Display
3
Air outlet
4
Compartment for the remote control
5
Air inlet
6
Feet
7
Temperature sensor
8
Main switch
9
Carrying handle
10
Display of the selected heat setting
11
“Fan” symbol
12
“Frost protection” symbol
13
Display of the selected measurement unit
14
Fan button
15
Increase temperature
16
Decrease temperature
17
Timer button
18
Runtime display
19
Preset target temperature display
20
Display of the measured actual temperature
21
On/Off button
22
Infrared receiver for remote control
23
Button to select the measurement unit
24
Button to select the heating setting
25
Remote control
26
Button to select the heating setting
27
Fan button
28
Button to select the measurement unit
29
Decrease temperature
30
Battery compartment
Timer button
32
Increase temperature
33
On/Off button
34
Wall bracket
35
Screw
36
Screw
37
Wall plug
38
Wall bracket
Loading...