Congratulations on the purchase of your new device.
You have selected a high-quality product. The operating instructions are part
of this product. They contain important information about safety, use and
disposal.
Before using the product, please familiarise yourself with all operating and
safety instructions. Use the product only as described and for the range of
applications specified. Retain these instructions for future reference. Please
also pass these operating instructions on to any future owner.
Notes on trademarks
USB® is a registered trademark of USB Implementers Forum, Inc.
The Bluetooth
marks of Bluetooth SIG, Inc. (Special Interest Group). Any use of the
trademarks by Kompernaß Handels GmbH is made under the provisions of
a licence.
The SilverCrest trademark and the retail name are the property of their
respective owner.
All other names and products may be trademarks or registered trademarks of
their respective owner.
Limitation of liability
The manufacturer assumes no responsibility for damage caused by failure to
observe these instructions, improper use, incompetent repairs, unauthorised
modifications or for the use of non-approved replacement parts.
®
logotype and Bluetooth® logo are registered trade-
Intended use
This consumer electronics device is used to play back audio files which can
be transferred via Bluetooth® or 3.5 mm jack cable. You can use the
headphones as a headset to take calls using the integrated microphone once
the Bluetooth® connection has been made. The device is not intended for
any other purpose, nor for use beyond the scope described.
The device is not intended for use in commercial or industrial environments.
The manufacturer accepts no responsibility for damage caused by failure to
observe these instructions, improper use or repairs, unauthorised modifications or the use of unapproved replacement parts. The risk shall be borne
solely by the user.
■ 2 │ GB
│IE│
NI
SKBA 2 A1
Warnings
The following types of warning are used in these operating instructions:
DANGER
A warning at this hazard level indicates a potentially
hazardous situation.
Failure to avoid this hazardous situation could result in injuries or death.
► Follow the instructions in this warning notice to prevent injury.
CAUTION
A warning notice of this hazard level indicates a risk of
property damage.
Failure to avoid this situation could result in property damage.
► Follow the instructions in this warning notice to prevent material damage.
NOTE
► A note provides additional information that makes handling the
device easier for you.
SKBA 2 A1
GB│IE│NI
│
3 ■
Safety
This section contains important safety instructions for using the headphones.
These headphones comply with statutory safety regulations. Improper use
may result in personal injury and property damage.
Risk of hearing damage
DANGER
Risks from extremely high volume levels!
Loud music can lead to hearing damage.
► Avoid listening to music at an extremely high volume,
especially over long periods of time, when using these
earphones.
Risk of accidents
DANGER
Risk of impaired perception!
► Acoustic warning and indication signals and ambient noise can
sound different while you are wearing these headphones. Make
yourself aware of how these signals deviate in their sound so that
you can recognise the signals in the appropriate situations.
► Do not use the headphones while driving a vehicle, riding a bicycle,
operating machinery or in any other situation in which impaired perception of ambient noise could put you or other people in danger.
Please also observe the statutory provisions and regulations of the
country in which you are using the headphones.
Notes on the radio interface
Switch off the appliance if you are in an aeroplane, hospital, operating
theatre or in the vicinity of a electronic medical system. The transmitted radio
waves can affect the functionality of sensitive devices. Keep the device at
least 20 cm away from a pacemaker or implanted defibrillator, as the proper
functioning of the pacemaker or the implanted defibrillator could be affected
by radio waves. The transmitted radio waves can cause noise interference in
hearing aids. Do not use the unit in the presence of flammable gases or in a
potentially explosive atmosphere (e.g. in a paint shop) while the radio component is activated as the transmitted radio waves can cause an explosion or
ignite a fire. The range of the radio waves is dependent on the environment
and the ambient conditions. Data transmissions via a wireless connection can
be intercepted by unauthorised third parties.
■ 4 │ GB
│IE│
NI
SKBA 2 A1
Basic safety instructions
To ensure safe operation of the headphones, follow the safety guidelines set
out below:
■ Check the headphones for visible external damage before use. Do not
operate damaged headphones or headphones that have been dropped.
■ Protect the cables against damage, for example caused by sharp edges,
hot areas, clamping or crushing.
■ If the cables or connections are damaged, have them replaced by author-
ised specialists or Customer Service.
■ This device may be used by children aged 8 years and above and by
persons with limited physical, sensory or mental capabilities, or lack of
experience and knowledge, provided that they are under supervision
or have been told how to use the device safely and are aware of the
potential risks. Children must not play with the device. Cleaning and user
maintenance tasks may not be carried out by children unless they are
supervised.
■
DANGER! Do not allow children to play with the packaging material!
Keep all packaging materials away from children.
There is a risk of suffocation!
■ The headphones should only be repaired by authorised specialist personnel
or the customer service department. Improper repairs may put the user at
risk. It will also invalidate any warranty claims.
■ Repairs to the headphones during the warranty period may only be
carried out by a customer service department authorised by the manufacturer. Otherwise, no warranty claims will be held for any subsequent
damages.
■ Do not make any unauthorised modifications or alterations to the head-
phones. This device may not be opened by the user.
■ Ensure that the charger cable is not stretched tightly or kinked.
■ Do not expose the device to direct sunlight or high temperatures. Other-
wise it may overheat and be irreparably damaged.
■
DANGER! Do not operate the device close to naked flames (e.g.
candles) and do not place burning candles on or next to the device. This
will help to prevent fires.
■ The device may heat up while it is charging. Place the headphones in a
well-ventilated location during the charging process and do not cover it.
■ Protect the device from penetration by moisture and liquids. Never sub-
merge the device in water or place objects filled with liquids (e.g. vases)
next to the device.
SKBA 2 A1
GB│IE│NI
│
5 ■
■ Switch the device off immediately and disconnect any connected cables
from the device if you hear any unusual noises, smell fumes or notice any
smoke. Have the device checked by a qualified specialist before using it
again.
DANGER! The device has an integrated lithium-polymer battery.
■
Improper use of lithium-polymer batteries can cause fires, explosions, leakages of hazardous materials or other hazards! Do not throw the device
into an open fire.
■ Comply with all restrictions or prohibitions on use for battery-powered
devices in locations with specific hazard risks, e.g. petrol stations, aeroplanes, hospitals, etc.
Use
Package contents
The package contents include the following components (see fold-out page
for illustrations):
● Bluetooth
● Charging cable (Micro USB to USB)
● Audio cable (3.5 mm jack plug)
● These operating instructions (symbol)
♦ Unpack all parts of the device from the packaging and remove all
packaging materials.
NOTE
► Check the package for completeness and signs of visible damage.
► If any items are missing or damaged as a result of defective packag-
ing or transportation, please contact the Service Hotline (see section
"Service").
®
Headphones
Disposal of the packaging
The packaging protects the headphones from damage during transport. The
packaging materials have been selected for their environmental friendliness
and ease of disposal, and are therefore recyclable.
Returning the packaging to the material cycle conserves raw
materials and reduces the amount of waste that is generated.
Dispose of packaging materials that are no longer needed in
accordance with applicable local regulations.
■ 6 │ GB
│IE│
NI
SKBA 2 A1
Operating elements
(See fold-out page for illustrations)
1 Adjustable headband
2 LED (speaker mode)
3 Slider
4 PAIRING button
5
6 Right speaker
7
8
9 Micro-USB charging port (POWER INPUT)
0 Operating/charging LED
q AUX IN connection socket (3.5 mm jack)
w Microphone
e Right earpiece
r Left earpiece
t Left speaker
z Charging cable (micro USB to USB cable)
u Audio cable (3.5 mm jack plug)
i Operating instructions
button
button
button
Handling and use
Charging the battery
Before using the headphones, the integrated battery must be completely
charged.
CAUTION
► Only charge the headphones in dry indoor spaces.
► Always use the supplied charger cable z to charge the head-
phones!
► Always disconnect the charger cable z when charging is complete!
♦ Make sure that the headphones are switched off. To switch off the head-
phones, press and hold the
series of beeps and the operating/charging LED 0goes out.
♦ Connect the USB plug on the charger cable z to a PC or to a USB
power supply.
♦ Connect the micro USB plug of the charger cable zto the micro USB
charging socket (POWER INPUT) 9of the headphones.
SKBA 2 A1
button 5 until you hear a rising
GB│IE│NI
│
7 ■
NOTE
► The operating/charging LED 0 lights up orange during charging.
When the battery is fully charged, the operating/charging LED switches
off.
► Charging takes about 3.5 hours at a charging current of 500 mA.
When the battery is fully charged, you can play back music for about
20 hours at a medium volume in headphone mode or for up to 5 hours
in speaker mode. The playback time may vary depending on usage
(volume).
► When the battery is empty, you will hear two beeps at an interval of
two minutes, and the operating/charging LED 0 flashes three times orange every 15 seconds. The headphones then switch off automatically.
Wearing the headphones
♦ When putting the headphones on, please note the side markings “R”
(right) and “L” (left) on the inside of the head band 1.
♦ Adjust the headband 1 so that it fits your head comfortably and the
earpieces e + r cover your ears.
Pairing the headphones with a Bluetooth® device
Before you can use the headphones with the Bluetooth® function, you
must pair it with a compatible Bluetooth® device.
♦ To switch on the headphones, press and hold the
until you hear a rising series of beeps and the operating/charging LED
0 lights up violet for 2 seconds. Afterwards, the operating/charging LED
flashes blue once every 3 seconds.
♦ Press and hold the PAIRING button4 until the operating/charging LED
0 flashes alternately orange and blue to activate pairing mode.
®
♦ Set the Bluetooth
playback device so that it scans for Bluetooth®
devices. A detailed description of how to do this can be found in the operating manual for your Bluetooth® playback device.
♦ Select the entry SKBA 2 A1 from the list of found devices on your
Bluetooth
®
playback device and, if required, enter the code 0000
to connect the two devices. If the pairing is successful, you will hear
a rising series of beeps and the operating/charging LED 0 flashes
blue twice at 3-second intervals.
button 5
■ 8 │ GB
│IE│
NI
SKBA 2 A1
Loading...
+ 25 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.