Siemens SL34A012UC, SL33A005UC, SL34A015UC, SL84A605UC, DWHD64EF Manual [da]

GETTING STARTED

WITH YOUR NEW DISHWASHER

STEP 1- ADDING RINSE AGENT

For Proper Drying Always use Rinse Agent even if your detergent containes Rinse Agent

Rinse Agent	•	Add Rinse Agent when the light
		on the control panel illuminates
Level
•	Lift tab to	or (Model Dependent)
	open	Rinse Agent Level indicator on
		the dispenser changes to a
		light silver color
• To add Rinse Agent		Arrow
	pour on the arrow
• Turn arrow to		Turn
		Decrease	Increase
	adjust the amount	for	for
	of rinse agent	Streaks on	Spots on
	dispensed	glasses	glasses

STEP 2 - ADDING DETERGENT

											• Use fresh powdered detergent
											for best results
										• Add	• 1 tablespoon will clean most loads
											• 3 tablespoons Max, do not overfi ll
										Detergent
											• When using detergent tabs, lay
											them fl at to avoid contact with the
											cover

		1	Slide cover fully left
	2	• To close	Push rear of cover down
1		2
			fi rmly until you hear the
			CLICK

						• If you should	• Push the blue button in
						need to open	(NOT DOWN)
						the cover

STEP 3 - TO START THE DISHWASHER

		1) Close the door
	Exposed	4) The unit will
	Front
		then start
	Controls
	2) Turn on	3) Select a cycle

		1) Open the door
	Hidden Top	4) Close the
		door to start
	Controls
	2) Turn on	3) Select a cycle

FREQUENTLY ASKED

QUESTIONS

Run Time

To save energy, this dishwasher has a "Smart Control" that automatically adjusts the cycle based on soil loads and incoming water temperature. The "Smart Control" makes decisions that can cause the cycle time and water usage to adjust at discrete times, and suddenly change in midcycle. The cycle times listed in the Use and Care manual are based on normal soil loads and 120°F incoming water and will vary based on your actual conditions.

When is the Cycle Complete

Depending on model you can tell when your unit has completed the cycle in one of the following ways. Please refer to your Use and Care manual for complete details

•Countdown Display at "0"

•Clean Light illuminates

•Cycle completion signal sounds (tone adjustable)

•Cycle indicator light that shines on fl oor goes out

Canceling a Cycle

Be careful of splash-out.

To cancel a cycle in process, press and hold the two buttons labeled "Cancel Drain" for 3 seconds. Re-start the dishwasher as normal

Cancel Drain

To Contact Customer Service

With the dishwasher door open, locate the label on the right side of the door. There you will fi nd the:

•Model Number

•Serial Number (FD#########)

•Toll Free Customer Service Phone Number

ALWAYS READ YOUR USE AND CARE MANUAL FOR DETAILED INSTRUCTIONS AND

IMPORTANT SAFETY NOTICES.	9000121317 Rev. B • 02/06