GETTING STARTED
WITH YOUR NEW DISHWASHER
STEP 1- ADDING RINSE AGENT
For Proper Drying Always use Rinse Agent even if your detergent containes Rinse Agent
Rinse Agent |
• |
Add Rinse Agent when the light |
|
|
on the control panel illuminates |
||
Level |
|
||
• |
Lift tab to |
or (Model Dependent) |
|
|
open |
Rinse Agent Level indicator on |
|
|
|
||
|
|
the dispenser changes to a |
|
|
|
light silver color |
|
• To add Rinse Agent |
Arrow |
||
|
pour on the arrow |
||
• Turn arrow to |
Turn |
|
|
Decrease |
Increase |
||
|
adjust the amount |
for |
for |
|
of rinse agent |
Streaks on |
Spots on |
|
dispensed |
glasses |
glasses |
STEP 2 - ADDING DETERGENT
|
|
|
|
|
|
|
|
|
|
|
• Use fresh powdered detergent |
|
|
|
|
|
|
|
|
|
|
|
for best results |
|
|
|
|
|
|
|
|
|
|
• Add |
• 1 tablespoon will clean most loads |
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
• 3 tablespoons Max, do not overfi ll |
|
|
|
|
|
|
|
|
|
|
|
Detergent |
|
|
|
|
|
|
|
|
|
|
|
|
• When using detergent tabs, lay |
|
|
|
|
|
|
|
|
|
|
|
them fl at to avoid contact with the |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
cover |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 |
Slide cover fully left |
|
2 |
• To close |
Push rear of cover down |
|
|
||
1 |
|
2 |
|
|
|
|
fi rmly until you hear the |
|
|
|
CLICK |
|
|
|
|
|
|
• If you should |
• Push the blue button in |
|
|
|
|
|
|
need to open |
(NOT DOWN) |
|
|
|
|
|
|
the cover |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
STEP 3 - TO START THE DISHWASHER
|
1) Close the door |
|
Exposed |
4) The unit will |
|
Front |
||
then start |
||
Controls |
||
|
||
2) Turn on |
3) Select a cycle |
|
1) Open the door |
|
Hidden Top |
4) Close the |
|
door to start |
||
Controls |
||
|
||
2) Turn on |
3) Select a cycle |
FREQUENTLY ASKED
QUESTIONS
Run Time
To save energy, this dishwasher has a "Smart Control" that automatically adjusts the cycle based on soil loads and incoming water temperature. The "Smart Control" makes decisions that can cause the cycle time and water usage to adjust at discrete times, and suddenly change in midcycle. The cycle times listed in the Use and Care manual are based on normal soil loads and 120°F incoming water and will vary based on your actual conditions.
When is the Cycle Complete
Depending on model you can tell when your unit has completed the cycle in one of the following ways. Please refer to your Use and Care manual for complete details
•Countdown Display at "0"
•Clean Light illuminates
•Cycle completion signal sounds (tone adjustable)
•Cycle indicator light that shines on fl oor goes out
Canceling a Cycle
Be careful of splash-out.
To cancel a cycle in process, press and hold the two buttons labeled "Cancel Drain" for 3 seconds. Re-start the dishwasher as normal
Cancel Drain
To Contact Customer Service
With the dishwasher door open, locate the label on the right side of the door. There you will fi nd the:
•Model Number
•Serial Number (FD#########)
•Toll Free Customer Service Phone Number
ALWAYS READ YOUR USE AND CARE MANUAL FOR DETAILED INSTRUCTIONS AND
IMPORTANT SAFETY NOTICES. |
9000121317 Rev. B • 02/06 |
|