Ryobi RY141600 User Manual
RY141600 QUICK REFERENCE GUIDE
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product. All page references refer to
the operator’s manual.
FIRST TIME ASSEMBLY
1 3
Connect the spray wand to the trigger handle
(see page 10).
Connect the high pressure hose to the pump (see
page 10).
Connect the garden hose to the pump (see page
4
10).
STARTING THE UNIT USING DETERGENT
Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is
1
ready for operation (see page 11).
If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet
(see pages 3 and 8).
USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:
Cord Length Wire Size (A.W.G.)
25 ft. 14
Pour pressure washer
1
detergent in soap tank (see
page 13).
Install blue or black soap
2
nozzle (see page 13).
25
DETERGENT
Use of soap nozzle will activate detergent injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
• Will void your warranty
• Will damage plants/shrubs
Squeeze trigger and wait
3
approx. 5 seconds for soap
(see page 13).
5 S
Connect the high pressure hose to the trigger
2
handle (see page 10).
Completely uncoil garden hose or remove
completely from reel to prevent kinks.
Press switch ON to start the motor (see page 11).
2
50 ft. 12
100 ft. Not Allowed
NOTE: A.W.G. = American Wire Gauge
SWITCH
ON
NOZZLE SELECTION GUIDE
Use the chart below to determine the correct nozzle for your job.
Turbo Nozzle
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
HIGH PRESSURE
(NO SOAP WHEN USING
THESE NOZZLES)
15º
LOW
PRESSURE
(FOR SOAP OR
GENTLE RINSE)
Blue or Black
Soap Nozzle
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until
a steady stream of water appears.
3
When finished, press switch OFF to stop the motor (see page 12).
SWITCH
OFF
Lawn Equipment, Boat, RV
Recommended Nozzle
Use With Caution for Certain Applications
BEFORE STORING THE UNIT
Always add Pump Protector to the unit after each use and before storing. This will significantly im-
1
prove pump life. (See page 14.)
Pump protector is available from your local retailer. For further assistance, call customer service at
1-800-860-4050.
To add, follow the instructions provided by the Pump Protector manufacturer.
Make the most of your purchase! Go to www.ryobitools.com
and register your new tool online. For questions about operating
or maintaining your product please call, 1-800-860-4050.
12-22-14 (REV:01)
PROTECTOR
991000343
PUMP
Loading...