Pioneer AVIC-F220 User Manual

INSTALLATION MANUAL
HIDE-AWAY NAVIGATION SYSTEM
AVIC-F220
English
PIONEER CORPORATION
PIONEER ELECTRONICS (USA) INC.
P.O. Box 1540, Long Beach, California 90801-1540, U.S.A. TEL: (800) 421-1404
PIONEER EUROPE NV
Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium/Belgique TEL: (0) 3/570.05.11
PIONEER ELECTRONICS ASIACENTRE PTE. LTD.
253 Alexandra Road, #04-01, Singapore 159936 TEL: 65-6472-7555
PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
178-184 Boundary Road, Braeside, Victoria 3195, Australia TEL: (03) 9586-6300
PIONEER ELECTRONICS OF CANADA, INC.
300 Allstate Parkway, Markham, Ontario L3R 0P2, Canada TEL: 1-877-283-5901 TEL: 905-479-4411
PIONEER ELECTRONICS DE MEXICO, S.A. de C.V.
Blvd.Manuel Avila Camacho 138 10 piso Col.Lomas de Chapultepec, Mexico, D.F. 11000 TEL: 55-9178-4270
司 : 台北4413
: (02) 2521-3588
9901-6
: (0852) 2848-6488
Published by Pioneer Corporation. Copyright © 2010 by Pioneer Corporation. All rights reserved.
Printed in China
<CZR5376-A> AU
<KMZZX> <10C00000>
ABOUT YOUR NEW NAVIGATION SYSTEM AND THIS MANUAL
! The navigation features of this product are
intended solely to aid you in the operation of your vehicle. It is not a substitute for your attentiveness, judgement and care when driving.
! Never use this navigation system to route
to hospitals, police stations, or similar facil­ities in an emergency. Please call the ap­propriate emergency number.
! Do not operate this navigation system if
doing so in any way will divert your atten­tion from the safe operation of your vehicle. Traffic restrictions and advisories currently in force should always take precedence over guidance given by this product. Al­ways obey current traffic restrictions, even if this product provides contrary advice.
! This manual explains how to install this na-
vigation system in your vehicle. Operation of this navigation system is explained in the separate manuals for the navigation system.
! Do not install this product where it may (i)
obstruct the drivers vision, (ii) impair the performance of any of the vehicles operat­ing systems of safety features, including airbags, hazard lamp buttons or (iii) impair the driver s ability to safely operate the vehi­cle. In some cases, it may not be possible to install this product because of the vehi­cle type or the shape of the vehicle inter­ior.
WARNING
Pioneer does not recommend that you install your navigation system yourself. We recom­mend that only authorised Pioneer service personnel, who have special training and ex­perience in mobile electronics, set up and in­stall this product. NEVER SERVICE THIS PRODUCT YOURSELF. Installing or servi­cing this product and its connecting cables may expose you to the risk of electric shock or other hazards, and can cause damage to the navigation system that is not covered by warranty.
PLEASE READ ALL OF THESE INSTRUCTIONS REGARDING YOUR NAVIGATION SYSTEM AND RETAIN THEM FOR FUTURE REFERENCE
1 Read this manual fully and carefully before in-
stalling your navigation system. 2 Keep this manual handy for future reference. 3 Pay close attention to all warnings in this
manual and follow the instructions carefully. 4 This navigation system may in certain circum-
stances display erroneous information regard-
ing the position of your vehicle, the distance
of objects shown on the screen, and compass
directions. In addition, the system has certain
limitations, including the inability to identify
one-way streets, temporary traffic restrictions
and potentially unsafe driving areas. Please
exercise your own judgement in the light of
actual driving conditions. 5 As with any accessory in your vehicles inter-
ior, the navigation system should not divert
your attention from the safe operation of your
vehicle. If you experience difficulty in operat-
ing the system or reading the display, please
make adjustments while safely parked.
IMPORTANT INFORMATION
IMPORTANT SAFEGUARDS
6 Please remember to wear your seat belt at all
times while operating your vehicle. If you are ever in an accident, your injuries can be con­siderably more severe if your seat belt is not properly fastened.
7 Certain country and government laws may
prohibit or restrict the placement and use of this system in your vehicle. Please comply with all applicable laws and regulations re­garding the use, installation and operation of your navigation system.
Precautions before connecting the system
CAUTION
! If you decide to perform the installation
yourself, and have special training and ex-
perience in the mobile electronics instal-
lations, please carefully follow all of the
steps in the installation manual. ! Secure all wiring with cable clamps or
electrical tape. Do not allow any bare wir-
ing to remain exposed. ! Do not directly connect the yellow lead of
this product to the vehicle battery. If the
lead is directly connected to the battery,
engine vibration may eventually cause
the insulation to fail at the point where
the wire passes from the passenger com-
partment into the engine compartment. If
the yellow leads insulation tears as a re-
sult of contact with metal parts, short-cir-
cuiting can occur, resulting in
considerable danger. ! It is extremely dangerous to allow the
cables to become wound around the steer-
ing column or gearstick. Be sure to install
this product, its cables, and wiring away
in such a way that they will not obstruct
or hinder driving. ! Make sure that the cables and wires are
routed and secured so they will not inter-
fere with or become caught in any of the
vehicles moving parts, especially the
steering wheel, gearstick, handbrake, slid-
ing seat tracks, doors, or any of the vehi-
cles controls. ! Do not route wires where they will be ex-
posed to high temperatures. If the insula-
tion heats up, wires may become
damaged, resulting in a short circuit or
malfunction and permanent damage to
the product.
IMPORTANT SAFEGUARDS
Connecting the system
! Do not cut the GPS aerial cable to shorten
it or use an extension to make it longer. Altering the aerial cable could result in a short circuit or malfunction.
! Do not shorten any leads. If you do, the
protection circuit (fuse holder, fuse resis­tor or filter, etc.) may fail to work properly.
! Never feed power to other electronic pro-
ducts by cutting the insulation of the power supply lead of the navigation sys­tem and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating.
! The black lead is earth. Please earth this
lead separately from the earth of high-cur­rent products such as power amps. Do not earth more than one product together with the earth from another product. For example, you must separately earth any amp unit away from the earth of this navi­gation system. Connecting earths to­gether can cause a fire and/or damage the products if their earths became detached.
Before installing this product
! Use this unit with a 12-volt battery and ne-
gative earthing only. Failure to do so may
result in a fire or malfunction. ! To avoid shorts in the electrical system, be
sure to disconnect the (–) battery cable be-
fore beginning installation.
To prevent damage
! When disconnecting a connector, pull the
connector itself. Do not pull the lead, as
you may pull it out of the connector. ! Attach the connectors of the same colour
to the corresponding coloured port, i.e.,
blue connector to the blue port, black to
black, etc.
Parts supplied
Detachable device Base unit
Power cord RDS-TMC tuner
26-pin cable GPS aerial
External aerial Lock tie
Loading...
+ 4 hidden pages