For screen sizes not indicated on the projection tables, use the formulas below.
If the figures on the tables do not match the results of formulas, use the figures in the table.
The ceiling must be strong enough to support the LCD projector and the installation must be in accordance with any local
building codes.
• All calculations are based on 4:3 aspect ratio.
• Distances are in inches, for millimeters multiply by 25.4.
• Distances may vary ±5%.
Formulas
Units: Inches (for millimeters multiply final number by 25.4)
Definitions:
H = Horizontal Screen Width (4:3)
V = Vertical Screen Height (4:3)
B = Vertical distance between lens center and screen center
C = Throw distance
D = Vertical distance between lens center and screen top (screen bottom for desktop application)
α = Throw Angle
Projection Formulas:
B = 0.3007H H = Screen Diagonal x 4/5
C (wide) = 1.8381H – 1.724 V = Screen Diagonal x 3/5
C (tele) = 2.2057H – 1.724 Screen Diagonal = H x 5/4
D = 0.0743H
α (wide) = tan
α (tele) = tan
-1
-1
Screen Formulas (4:3):
(B/C(wide))
(B/C(tele))
Page 1
ver 1.5
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Visual Systems
VT650 Installation Data
Desktop and Ceiling Mount ver 1.5
Projection Distance and Screen Size for Ceiling Mount
The following shows the proper relative position of the projector and screen. Refer to the table for installation data.
Distances are in inches. For millimeters multiply by 25.4.
Communication Protocol:
Baud Rate: 19200 bps
Data Length: 8 bits
Parity: No Parity
Stop Bit: One bit
X on/off: None
Communications: Full duplex
PC Control Connector (DIN-8P)
To RxD of PC
678
345
12
To GND of PC
NOTE 1: Pins 2, 3, 5, 6 and 8 are used inside the projector.
NOTE 2: For long cable runs it is recommended to set communication speed within projector menus to 9600 bps.
To TxD of PC
Page 7
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.