www.dexpress.com DIMENSION EXPRESS Fax on Demand (775) 833-3600
|
This Data Sheet Includes Information On |
|
|
Jenn-Air |
|
• |
Product Model Number (s): |
• |
|
30" Electric/Microwave Ovens: |
|
|
JMW9530BAW, JMW9530BAQ and JMW9530BAB |
|
• |
Dimensions (Actual Size) |
• |
|
Cutout width: |
28 3/16" |
|
Cutout height: |
44 1/2" |
|
Minimum cabinet width: 30" |
|
|
Minimum cabinet depth: 24" |
|
Recommended cutout location from floor : 4" to 20"
Distance from face of cabinet to
outer edge of open doors (door swing): 20 1/2"
Distance from face of cabinet to
front of closed door handle: 15/16"
Overall unit width: 29 3/4"
Overall unit height: 44 15/16"
Penetration into cabinet: 23 1/2"
Oven overlap distances when using cutout dimensions listed above:
Top overlap: 7/16"
Bottom overlap: 0"
Right side overlap: 25/32"
Left side overlap: 25/32"
• |
Additional Information |
• |
•Cutout height and width are ± 1/16".
•Cutout in cabinet should be level and straight. There are no provisions to level the unit after it is installed.
•Construct 5/8" minimum plywood floor flush with bottom of opening. Floor must be level and straight and capable of supporting 250 lbs.
•A three-wire, single phase, A.C. 120/208-240 volt, 60Hz cycle electrical system must be provided (Load 30 amps @ 120/240VAC). 40 amp circuit recommended. 7/8" O.D. flexible cable 4 feet long is furnished by manufacturer. Mount junction box in area under plywood floor if adequate lower cabinet space is available. Locate 1 1/4" conduit access hole in the back right hand side of the plywood floor.
•For European style cabinets (flush front) the required clearance for operation of the oven door is a minimum spacing of 7/8" between the cutout and the door, hinge or drawer of the cabinet.
Subject to change without notice. This system is designed to |
|
be updated daily if necessary. Dimension Express is not |
|
responsible for use of superseded, voided, or outdated data |
|
sheets. Because of the difficulty or impracticability of deter- |
|
mining actual damages, liability of Dimension Express shall |
|
not exceed $50.00. |
|
Copyright © Dimension Express, 2001. |
239 |
Cabinet Opening
(not to scale)
Mount receptacle on back wall in the center of cavity below oven opening and within 3" of oven bottom (shaded area).
30"
|
28 3/16" |
|
|
24" |
||||
|
|
|||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
44 1/2"
4" to 20"
Overall Dimensions
(not to scale)
44 15/16"
23 1/2"
29 3/4"
15/16"
• NEVER reuse Data Sheets. Data Sheets are subject to change without |
• Call Dimension Express if you have any questions at (775) 833-3633 • |
notice. Dimension Express is a FREE service bureau and is updated daily, |
• Always refer to a current Code at a Glance or manufacturer directory • |
it makes far more sense to spend the time necessary to request new Data |
• Data Sheet codes change on the first of odd numbered months at 12:01am • |
Sheets for each project, as opposed to the problems, time, costs, and risks |
BN207.5 • A239 • • 011104 • 16220 • 45690 |
associated with reusing old Data Sheets. |
Loading...