Invacare MA85, MA80 User Manual

Owner’s Operator and Maintenance Manual

MA80 Series

MA80 True Low Air Loss

System

MA85 Five-Zone Alternating

Pressure and True Low Air

Loss System

DEALER: This manual MUST be given to the user of the product.

USER:

manual and save for future reference.

BEFORE using this product, read this

For more information regarding

Invacare products, parts, and services,

please visit www.invacare.com

SPECIAL NOTES

 WARNING

DO NOT use this product or any available optional equipment without first completely reading and understanding these instructions and any additional instructional material such as owner’s manuals, service manuals or instruction sheets supplied with this product or optional equipment. If you are unable to understand the warnings, cautions or instructions, contact a healthcare professional, dealer or technical personnel before attempting to use this equipment

- otherwise, injury or damage may occur.

Procedures other than those described in this manual must be performed by a qualified technician.

SPECIAL NOTES

Signal words are used in this manual and apply to hazards or unsafe practices which could result in personal injury or property damage. Refer to the table below for definitions of the signal words.

SIGNAL WORD MEANING

DANGER

WARNING

CAUTION

Danger indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

Warning indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

Caution indicates a potentially hazardous situation which, if not avoided, may result in property damage or minor injury or both.

NOTICE

THE INFORMATION CONTAINED IN THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE.

Check all parts for shipping damage and test before using. In case of damage, DO NOT use. Contact Invacare Customer Service Department for further instruction.

 ACCESSORY WARNING

Only use Invacare accessories on Invacare products.

NOTE: Updated versions of this manual are available on www.invacare.com.

MA80 Series 2 Part No 1148138

TABLE OF CONTENTS

SPECIAL NOTES ................................................................................ 2

TYPICAL PRODUCT PARAMETERS .................................................... 5

Electrical Parameters.............................................................................................................................5

Performance Parameters......................................................................................................................5

Mechanical Parameters .........................................................................................................................5

Environmental Parameters...................................................................................................................6

LABEL LOCATION ............................................................................ 7

SECTION 1—GENERAL GUIDELINES ................................................... 8

Contraindications .......................................................................................................................................8

Installation ....................................................................................................................................................8

Entrapment May Occur.............................................................................................................................8

Fire Hazard...................................................................................................................................................9

Smoking ....................................................................................................................................................9

Anesthesia Equipment...........................................................................................................................9

Oxygen .....................................................................................................................................................9

Electrical .......................................................................................................................................................9

SECTION 2—OPERATION ................................................................ 10

Installing the Mattress Replacement System ......................................................................................10

Installing the Side Rails ............................................................................................................................11

Installing the Control Unit......................................................................................................................11

Connecting the Hose...............................................................................................................................12

Connecting the Power Cord .................................................................................................................13

Using the Front Panel ..............................................................................................................................14

Power Button........................................................................................................................................14

Pulse Button (MA80)...........................................................................................................................15

Alternating Pressure Button (MA85) ..............................................................................................15

Adjusting the Minimum Pressure Setting (A/P Low) ..............................................................15

Static Button..........................................................................................................................................16

Firm/Soft Buttons.................................................................................................................................16

Fowler Button.......................................................................................................................................16

Manual Mode ...................................................................................................................................16

Automatic Wireless Mode ...........................................................................................................16

Fowler Transmitter Setup ............................................................................................................16

Max Inflate Button ...............................................................................................................................17

Lock/Alarm Silence Button ................................................................................................................17

Power Fail LED.....................................................................................................................................17

Low Pressure LED...............................................................................................................................17

Powering Up the System ........................................................................................................................18

Placing the Patient on the Mattress......................................................................................................18

Part No 1148138 3 MA80 Series

TABLE OF CONTENTS

Transferring Patient From/To a Gurney .............................................................................................19

Transferring Patient From/To a Wheelchair......................................................................................19

Preparing for CPR Procedure................................................................................................................19

SECTION 3—MAINTENANCE AND TROUBLESHOOTING ................... 21

Cleaning the System.................................................................................................................................21

Storing the System...............................................................................................................................22

Changing the Filter...................................................................................................................................23

Troubleshooting........................................................................................................................................23

LIMITED WARRANTY ..................................................................... 24

REGISTER YOUR PRODUCT

The benefits of registering include:

1. Safeguarding your investment.

2. Ensuring long-term maintenance and servicing of your product.

3. Receiving updates with product information, maintenance tips and industry news.

Please have your model number and purchase date available to complete your registration.

Any registration information you submit will only be used by Invacare Corporation and protected as required by applicable laws and regulations.

MA80 Series 4 Part No 1148138

TYPICAL PRODUCT PARAMETERS

Electrical Parameters

MA80/MA85

INPUT VOLTAGE AC: 90 V

INPUT FREQUENCY: 60 Hz

CURRENT: 2 A

MAXIMUM POWER CONSUMPTION: 150 ± 10 W

CIRCUIT PROTECTION: Dual fused,

250 V,

5 A fast blow fuses

MODE OF OPERATION: Continuous

Performance Parameters

MA80 MA85

WEIGHT CAPACITY

STANDARD MATTRESS: BARIATRIC MATTRESS:

PRESSURE ZONE: MAXIMUM FLOW: MAXIMUM PRESSURE: MAXIMUM FLOW TIMER: SUPPORT SURFACE INFLATION TIME:

PATIENT COMFORT CONTROL PRESSURES:

SOFT PRESSURE: FIRM PRESSURE:

CYCLE TIME: 1, 3, 5, 10 minutes 5, 10, 15, 20 minutes

PATIENT CONTACT: Control unit and mattress have

Latex-Free components

350 lbs

1000 lbs

1275 ± 100 LPM

35 ± 5 mmHg

15 minutes

25 - 60 seconds

8 ± 4 mmHg

32 ± 4 mmHg

Mechanical Parameters

MA80/MA85

CONTROL UNIT

DIMENSIONS (LXWXH): WEIGHT: POWER CORD: CONNECTION:

PACKAGING:

10 - 14 Feet Long, Hospital Grade

Triple Flow - Two ½” and One ¼” Single

15” x 6.5” x 11”

15 lbs

Magnetic Quick Coupling

1 piece/box

AIR FILTER: Charcoal Air Filter with Fire Retardant

Part No 1148138 5 MA80 Series

TYPICAL PRODUCT PARAMETERS

Environmental Parameters

OPERATING CONDITIONS

AMBIENT TEMPERATURE: RELATIVE HUMIDITY: ATMOSPHERIC PRESSURE:

STORAGE AND SHIPPING CONDITIONS

AMBIENT TEMPERATURE: RELATIVE HUMIDITY: ATMOSPHERIC PRESSURE:

MA80/MA85

50° - 104° F

30% - 75% Non-Condensing

70 - 106 kPa

-40° - 158° F 10% - 100%

50 - 106 kPa

MA80 Series 6 Part No 1148138

LABEL LOCATION

DANGER-EXPLOSION HAZARD: DO NOT use in the presence of flammable anesthetics.

CAUTION: Equipment should be connected to a properly grounded receptacle (3-prong). Risk of Electrical shock. DO NOT remove back. Disconnect air hose before administering CPR.

NOTE: This label is on the back of

 ATTENTION

Clean Filter Every 5 months and Whenever Dirty. Remove Filter, Wash, Dry & Replace.

the unit and also contains the serial number.

 WARNING

Patient entrapment with bed side rails may cause injury or death. Mattress MUST fit bed frame and side rails snugly to prevent patient entrapment. Follow the manufacturer’s instructions. Monitor patient frequently. Read and understand the Owner’s/Operator’s Manual prior to using this equipment. Invacare product manuals are available at www.invacare.com or your dealer.

Label part number 1150708 Rev A

Part No 1148138 7 MA80 Series

SECTION 1—GENERAL GUIDELINES

 WARNING

SECTION 1 - GENERAL GUIDELINES contains important information for the safe operation and use of this product.

Contraindications

ALWAYS consult the patient’s physician before using the MA80 and MA85 systems.

Installation

The MA80 and MA85 systems MUST be installed on medical bed frames with side rails. The side rails MUST be in the raised position whenever a patient is on the bed.

Controls on the footboard may be obstructed by the control unit on a few bed frames. It may be necessary to relocate the control unit. Refer to Installing the Control Unit on page 11.

Check that air hoses and power cord are clear of moving bed components before placing a patient on the bed. Operate all bed frame motorized functions through their full range of motion to be certain that there is no pulling, interference or pinching.

DO NOT strap the mattress to the bed frame at the head and foot ends. Secure ALL mattress straps. Secure the straps to the bed deck at the head and foot ends and to the frame at the center of the bed. Otherwise damage to the mattress will occur when the head and foot ends are raised. Refer to Installing the Mattress Replacement System on page 10.

Entrapment May Occur

 WARNING

Proper patient assessment and monitoring, and proper maintenance and use of equipment is required to reduce the risk of entrapment. Variations in bed rail dimensions, and mattress thickness, size or density could increase the risk of entrapment. Visit the FDA website at http://www.fda.gov to learn about the risks of entrapment. Review “A Guide to Bed Safety”, published by the Hospital Bed Safety Workgroup, located at www.invacare.com. Use the link located under each bed rail product entry to access this bed safety guide.

Refer to the owner’s manuals for beds and rails for additional product and safety information.

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Assist rails with dimensions different from the original equipment supplied or specified by the bed manufacturer may not be interchangeable and may result in entrapment or other injury.

MA80 Series 8 Part No 1148138

+ 16 hidden pages