Hitachi HTS548020M9AT00, HTS548040M9AT00, HTS548060M9AT00, HTS548080M9AT00 Quick Installation Guide

0 (0)
Hitachi HTS548020M9AT00, HTS548040M9AT00, HTS548060M9AT00, HTS548080M9AT00 Quick Installation Guide

Hitachi Global Storage Technologies

Quick installation guide

Hitachi Travelstar 5K80

2.5 inch ATA/IDE hard disk drive

Models: HTS548080M9AT00

HTS548060M9AT00

HTS548040M9AT00

HTS548020M9AT00

Handling precautions

Jumper settings

yWear a grounded wrist strap while handling the drive to prevent damage from Electrostatic Discharge (ESD).

ySet the drive down gently to prevent damage from impact or vibration.

yDo not open the ESD bag containing the drive until needed.

yHandle the drive carefully by the edges. Do not touch the exposed printed circuit board or any electronic components.

yDo not press on the top or bottom of the drive.

yDo not cover the drive’s breather hole.

Quick installation

Installation of this Hitachi Travelstar drive in some notebooks may require use of unique hardware (such as mounting trays, connecting cable, insulating material). If you are uncertain if hardware is needed, consult your notebook manufacturer as this operation may require a qualified technician.

Back up all data before proceeding with installation.

1. Set the jumpers

yMaster drive. No jumper is required if the drive is the only drive in a system or the Master drive in a two-drive system.

ySlave drive. If this is the Slave drive in a system, place a jumper in setting A2. (See the A2 setting in the illustration.)

yCable Select. Setting A3 in the illustration. Consult the system manual to see if your computer supports Cable Select.

A1.

A2.

A3.

A4.

A5.

 

 

 

 

Pin 1

A1. Master A2. Slave A3. Cable Select A4 & A5. Never attach a jumper in these positions!

2. Attach the drive

For assistance on the physical installation of the drive, consult your system manual.

3.Configure the computer

1.Turn on the computer.

2.Enter Setup.

3.Go to Hard Disk Drive Configuration.

4.Select Autodetect if it is available.

5.If Autodetect is not available, set to User and set to appropriate parameters from the table below.

6.Save the settings and exit.

7.Reboot the system from a floppy disk.

Model Number

Cylinders

Heads

Sectors/

Capacity

 

 

 

Track

(GB)

HTS548080M9AT00

16,383

4

63

80

HTS548060M9AT00

16,383

3

63

60

HTS548040M9AT00

16,383

2

63

40

HTS548020M9AT00

16,383

1

63

20

page 1

version 1.0

Loading...
+ 1 hidden pages