Hitachi HTS541212H9AT00, HTS541210H9AT00, HTS541280H9AT00, HTS541260H9AT00, HTS541212H9SA00 Quick Installation Guide

Hitachi Global Storage Technologies

Quick Installation Guide

Hitachi Travelstar™ 5K120

2.5-inch ATA/IDE & SATA Hard Disk Drive

Models:

HTS541212H9AT00 HTS541212H9SA00 HTS541210H9AT00 HTS541210H9SA00 HTS541280H9AT00 HTS541280H9SA00 HTS541260H9AT00 HTS541260H9SA00

Handling precautions

__________________________________________

•Wear a grounded wrist strap while handling the drive to prevent damage from Electrostatic Discharge (ESD).

•Set the drive down gently to prevent damage from impact or vibration.

•Do not open the ESD bag containing the drive until needed.

•Handle the drive carefully by the edges. Do not touch the exposed printed circuit board or any electronic components.

•Do not press on the top or bottom of the drive.

•Do not cover the drive’s breather hole.

Quick installation

__________________________________________

Installation of this Hitachi Travelstar drive in some notebooks may require use of unique hardware (such as mounting trays, connecting cable, insulating material). If you are uncertain if hardware is needed, consult your notebook manufacturer as this operation may require a qualified technician.

Back up all data before proceeding with installation.

1.Set the jumpers (ATA/IDE only)

•Master drive. No jumper is required if the drive is the only drive in a system or the Master drive in a two-drive system.

•Slave drive. If this is the Slave drive in a system, place a jumper in setting A2. (See the A2 setting in the illustration.)

•Cable Select. Setting A3 in the illustration. Consult the system manual to see if your computer supports Cable Select.

Jumper settings (ATA/IDE only)

2. Attach the drive

For assistance on the physical installation of the drive, consult your system manual.

3.Configure the computer

1.Turn on the computer.

2.Enter Setup.

Page 1

Travelstar 5K120 Version 1.1