Hitachi HTE721010G9SA00, HTE721080G9SA00, HTE721060G9SA00, HTS721010G9SA00, HTS721080G9SA00 Quick Installation Guide

Quick installation guide

Hitachi Travelstar® 7K100 & Travelstar® E7K100

2.5 inch ATA/IDE & SATA hard disk drive

Models:

HTS721010G9AT00 HTE721010G9AT00 HTS721080G9AT00 HTE721080G9AT00 HTS721060G9AT00 HTE721060G9AT00 HTS721010G9SA00 HTE721010G9SA00 HTS721080G9SA00 HTE721080G9SA00 HTS721060G9SA00 HTE721060G9SA00

Handling precautions

yWear a grounded wrist strap while handling the drive to prevent damage from Electrostatic Discharge (ESD).

ySet the drive down gently to prevent damage from impact or vibration.

yDo not open the ESD bag containing the drive until needed.

yHandle the drive carefully by the edges. Do not touch the exposed printed circuit board or any electronic components.

yDo not press on the top or bottom of the drive.

yDo not cover the drive’s breather hole.

Quick installation

Installation of this Hitachi Travelstar drive in some notebooks may require use of unique hardware (such as mounting trays, connecting cable, insulating material). If you are uncertain if hardware is needed, consult your notebook manufacturer as this operation may require a qualified technician.

ySlave drive. If this is the Slave drive in a system, place a jumper in setting A2. (See the A2 setting in the illustration.)

yCable Select. Setting A3 in the illustration. Consult the system manual to see if your computer supports Cable Select.

Jumper settings (ATA/IDE only)

A1.	A2.	A3.	A4.	A5.
				Pin 1

A1. Master A2. Slave A3. Cable Select A4 & A5. Never attach a jumper in these positions!

Back up all data before proceeding with installation.

1. Set the jumpers (ATA/IDE only)

yMaster drive. No jumper is required if the drive is the only drive in a system or the Master drive in a two-drive system.

2. Attach the drive

For assistance on the physical installation of the drive, consult your system manual.

3.Configure the computer

1.Turn on the computer.

2.Enter Setup.

Hitachi Global Storage Technologies

page 1

version 1.0