Danby DWC310BL User Manual

Model • Modèle • Modelo
CAUTION: Read and follow all safety rules and
PRÉCAUTION: Veuillez lire attentivement les
consignes de sécurité et les instructions d'utilisation avant l'utilisation initiale de ce produit.
PRECAUCIÓN: Lea y observe todas las reglas de
seguridad y las instrucciones de operación antes de usar este producto por primera vez.
WINE COOLER Owner’s Manual . . . . . . . . . . . . . . . . . . . . . . .1-4
• Safety Instructions
• Installation
• Operation
• Care and Maintenance
REFROIDISSEUR DE VIN Manuel d'utilisation . . . . . . . . . . . . . . . . . . . . .5-8
• Consignes de sécurité
• Installation
• Fonctionnement
• Soins et entretien
REFRIGERADOR PARA VINOS Manual del propietario . . . . . . . . . . . . . . . . .9-12
• Instrucciones de seguridad
• Instalación
• Operación
• Cuidado y Mantenimiento
Danby Products Limited, PO Box 1778, Ontario, Canada N1H 6Z9
Danby Products Inc., PO Box 669, Findlay, Ohio, USA 45839-0669
This quality product is warranted to be free from manufacturer’s defects in material and workmanship, provided that the unit is used under the normal operating conditions intended by the manufacturer.
This warranty is available only to the person to whom the unit was originally sold by Danby or by an authorized distributor of Danby, and is non-transferable.
Plastic parts (ie. evaporator door, door rails, covers and trays are warranted for thirty (30) days only from purchase date, with no extensions provided. First Year During the first year (1), any electrical parts of this product found to be defective, including any sealed system units, will be repaired or
replaced, at warrantor’s option, at no charge to the ORIGINAL purchaser. Consumable parts (ie. light bulbs) are not warranted or guaranteed for any length of time.
Second Through During the next four years (4) any part of the sealed system found to be defective (consisting of compressor, condenser, evaporator, Fifth Year dryer and all related tubing) will be replaced without charge. The purchaser shall pay for all labour and return freight during this four year
(4) period for repair or replacement of any sealed system components. Any unit being diagnosed as non-functional due to sealed system failure and warranting an exchange during the existing four (4) years will be subject to an appropriate depreciation or user fee, including any and all freight charges being levied against the consumer.
To obtain Service Danby reserves the right to limit boundaries of “In Home Service” due to the proximity of an Authorized Service Depot. Any appliance
requiring service outside the limited boundaries of “In Home Service”, it will be the customer’s responsibility to transport the appliance to the closest Authorized Service Depot at their own expense. Contact your dealer from whom your unit was purchased, or contact your nearest authorized Danby service depot, where service must be performed by a qualified service technician. If service is performed on the units by anyone other than an authorized service depot, or the unit is used for commercial application, all obligations of Danby under this warranty shall be at an end.
The following clause refers to single and double door refrigerators, supplied with or without a separate freezer section. Nothing within this warranty shall imply that Danby will be responsible or liable for any spoilage or damage to food or other contents of this appliance, whether due to any defect of the appliance, or its use, whether proper or improper.
Save as herein provided, Danby Products Limited (Canada) or Danby Products Inc. (U.S.A.), there are no other warranties, conditions, representations or guarantees, express or implied, made or intended by Danby Products Limited or its authorized distributors and all other warranties, conditions, representations or guarantees, including any warranties, conditions, representations or guarantees under any Sale of Goods Act or like legislation or statue is hereby expressly excluded. Save as herein provided, Danby Products Limited (Canada) or Danby Products Inc. (U.S.A), shall not be responsible for any damages to persons or property, including the unit itself, howsoever caused or any consequential damages arising from the malfunction of the unit and by the purchase of the unit, the purchaser does hereby agree to indemnify and save harmless Danby Products Limited from any claim for damages to persons or property caused by the unit.
No warranty or insurance herein contained or set out shall apply when damage or repair is caused by any of the following:
1) Power Failure.
2) Damage in transit or when moving the appliance.
3) Improper power supply such as low voltage, defective house wiring or inadequate fuses.
4) Accident, alteration, abuse or misuse of the appliance such as inadequate air circulation in the room or abnormal operating conditions,
(extremely high or low room temperature).
5) Use for commercial or industrial purposes.
6) Fire, water damage, theft, war, riot, hostility, acts of God such as hurricanes, floods etc.
7) Service calls resulting in customer education.
Proof of purchase date will be required for warranty claims; so, please retain bills of sale. In the event warranty service is required, present this document to our AUTHORIZED SERVICE DEPOT.
Danby Products Limited PO Box 1778, 5070 Whitelaw Road, Guelph, Ontario, Canada N1H 6Z9 Telephone: (519) 837-0920 FAX: (519) 837-0449
Danby Products Inc.
PO Box 669, 101 Bentley Court,
Findlay, Ohio, U.S.A. 45839-0669
Telephone: (419) 425-8627 FAX: (419) 425-8629
Warranty Service
With-In Canada With-In United State
In Home In Home
Remove the exterior and interior packings, wipe the outside thoroughly with a soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the cabinet in a narrow recess or near any heat source, direct sunlight, or moisture. Let air circulate freely around the cabinet. Keep the rear of the wine cooler 5 inches away from the wall.
1. Select a place with a strong, level floor.
2. Allow 5 inches of space between the back of the wine cooler and any adjacent wall.
3. Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will cause higher electricity consumption.
To avoid vibration, the cabinet must be set level. To start the wine cooler, turn the temperature control to the position corresponding to the desired cooling. The wine cooler temperature will vary depending on the quantity of bottles stored and on the frequency with which the door is opened.
Setting The Temperature Control:
The temperature of the wine cooler compartment is controlled by adjusting/setting the thermostat control knob, located on the exterior rear wall of the cabinet.
To start the wine cooler and achieve maximum
cooling quickly;
• Turn the temperature control knob clockwise to the furthest
(maximum) setting on the darker blue (wide) section of the graduated control dial.
• Allow the unit to run at this setting for 3-4 hours.
• When maximum cooling is achieved, turn back the temperature
control knob setting to the 2 o’clock position on the graduated blue control dial. See fig.15.
• To turn off the wine cooler, (no cooling) rotate the control knob
to the “0” (off) position. See fig.14
Turn the control to the “OFF” (0) position to temporarily disconnect the cooling cycle. When the wine cooler is not to be used for a long period of time, disconnect the plug and leave the door partially open.
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electrical shock by providing an escape wire for the electrical current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
WARNING - Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if the doubt exists as to whether the appliance is properly grounded.
Use an exclusive wall outlet. Do not connect your wine cooler to extension cords or together with any other appliance in the same wall outlet. Do not splice the cord.
An empty wine cooler is a very dangerous attraction to children. Remove either the gasket, latches, lids or doors from unused appliances, or take some other action that will guarantee it harmless.
You must remove the bottom door support on the bottom left hand side of the unit before you can open the door. (See Fig. A)
Fig. 14
Fig. 15
NOTE: Wait 3 to 5 minutes before restarting if operation has
been interrupted.
Interior Light The operation of the interior light is "manually"
controlled and does not operate with the opening or closing of the door. To operate the light; manually press the light/toggle switch located on the left side of the light bulb housing located on the ceiling of inner cabinet.
Defrosting Your wine cooler is designed with an “Auto-Cycle”
defrost system. What is Auto Cycle defrost?
The refrigerated surfaces of the fresh food compartment defrost automatically, during the “off” cycle of the cold control. (thermostat) Defrost water from the fresh food compartment is disposed of automatically, by means of being channeled onto a drip tray located on the compressor. Heat transfer from the compressor causes the defrost water to evaporate.
Cleaning To clean the inside, use a soft cloth and a solution of
a tablespoon of baking soda to one quart of water, or a mild soap suds solution, or some mild detergent. Wash glide out shelves in a mild detergent solution, then dry and wipe with a soft cloth. Clean the outside with a soft damp cloth and some mild detergent or appliance cleaner.
Vacation Time
For short vacation periods, leave the control knobs at their usual settings. During longer absences,
(a) remove bottles, (b) disconnect from electrical outlet, (c) clean the wine cooler thoroughly, (d) leave door open to avoid possible formations of condensate,
mold or odors.
Power Failure Most power failures are corrected within an
hour or two and will not affect your wine cooler temperatures. However, you should minimize the number of door openings while the power is off. During power failures of longer duration, take steps to protect your wine.
If Y ou Move Remove or securely fasten down all loose items
inside the wine cooler. To avoid damaging the leveling screws, turn them all the way into the base.
Light Bulb Replacement To replace the interior light bulb;
Remove the screw holding the light bulb cover, remove cover. Unscrew light bulb. Replace light bulb.
NOTE: Light bulb should not exceed 25 watts.
Replace light bulb cover. Re-install screw to secure cover.
Wine Racks (Shelves): This unit is equipped with the
following slide-out shelves;
•5 Full Width Shelves
•1 3/4 Shelf
•1 Lower Shelf (Staggered)
Total Capacity: 35 Bottles
Some Important Rules for the Correct Use of the Wine Cooler
• Beverages should be stored in sealed bottles.
• Don’t overload the cabinet.
• Don’t open the door unless necessary.
• Should the wine cooler be stored without use for long periods
it is suggested, after a careful cleaning, to leave the door ajar to allow the air to circulate inside the cabinet in order to avoid possible formations of condensate, mold or odors.
• DO NOT cover shelves with aluminum foil or any other shelf
covering material which may prevent air circulation.
Recommended Temperatures for Chilling Wine
Dry Wines: 9˚C / 48.2˚F - 14˚C / 57.2˚F Rosé Wines: 10˚C / 50˚F Red Wines: 13˚C / 55.4˚F - 14˚C / 57.2˚F Sparkling Wines: 9˚C / 48.2˚F
Technical and Structural Operation Features
Cabinet bonderized and acrylic-enameled according to the most modern electrostatic spraying techniques. High-density polyurethane thermal insulation. Magnetic door closure gasket.
1. THERMOSTAT DIAL: (Externally mounted rear wall
thermostat) For controlling the temperature inside the wine cooler. Turns the motor (compressor) on /off as soon as the temperature rises/falls above/below the set cooling level.
resistant, rustproof, and removable for easy cleaning.
3. MAGNETIC GASKET: Tight fitting door seal keeps all the
cooling power locked inside. No hooks or latches.
easy interior visibility.
Control Setting Upper-Section Mid-Section
MIN. 12.1˚C / 53.8˚F 11.6˚C / 53˚F 10.7˚C / 51.3˚F MED. 13.2˚C / 55.8˚F 12.2˚C / 54˚F 8.4˚C / 47.2˚F MAX. 4.7˚C / 40.6˚F 1.6˚C / 35˚F 0.8˚C / 30.4˚F
The above temperatures may fluctuate depending on whether or not the interior bulb is “on/off”. If the bulb is continuously operational the cabinet temperatures will be slightly higher.
+ 9 hidden pages