QUICK START
BREVILLE GOURMET SINGLE CUP BREWERâ„¢
Installing the Water Filter
The Water Filter provided can significantly reduce substances
that affect the smell and taste of water.
If you choose to install the Water Filter, replace the
Charcoal Filter every 2 months or 60 tank refills.
We suggest not installing the Water Filter if using filtered
water, or if you choose not to replace the Charcoal Filter
as recommended, as the filter may clog and affect the
smell and taste of the water.
NOTE
If you choose not to install the Water Filter, start the One Time
Priming Process.
If you choose to install the Water Filter, follow these steps:
1. Remove the Water Tank from the Brewer by gripping the
handle located on the left side of the Water Tank, then
lift upwards
2. Remove the Water Tank Lid. Rinse the Water Tank with fresh
water and replace back onto the Brewer.
3. Remove the Upper and Lower Filter Holder and Charcoal
Filter from the polybag. Unwrap the Charcoal Filter from its
protective plastic.
4. Soak the Charcoal Filter for 5 minutes then rinse for
30 seconds.
5. Wash the Lower Filter Holder, ensuring the mesh is free
of residue.
6. Insert the Charcoal Filter into the Upper Filter Holder, then
attach the Lower Filter Holder so it locks into place.
.
7. Set the date dial on the Upper Filter Holder 2 months ahead.
This will remind you when the Charcoal Filter will need to
be replaced.
8. Place the assembled Filter Holder into the Water Tank,
aligning so the date dial is visible from outside the
Tank. Push down to clip into place.
9. Your Brewer is ready for the One Time Priming Process.
One Time Priming Process
Priming fills the internal tank with water and cleanses the
brewing system. You cannot use your Brewer until it has been
primed for its first use.
If the Brewer has been exposed to temperatures
below freezing, allow the Brewer at least two hours
to reach room temperature before priming.
NOTE
1. Unwrap the power cord and plug the Brewer into a
grounded outlet.
2. Place a 12 oz. mug on the Drip Tray Plate.
3. If you did not install the Water Filter and the Water Tank is
empty, remove the Water Tank Lid, then gripping the handle
located on the left side of the Water Tank, lift upwards. Rinse
and fill with water until the water has reached the 'MAX'
mark on the water viewing window. Place the Water Tank
back onto the Brewer and replace the Lid.
4.
Press and release the Power Switch located on the lower
back, right side of the Brewer. The Power Switch is spring
loaded and will return to its original position.