Breville BPM500 Manual

0 (0)
Breville BPM500 Manual

Pasta Emporia

Fresh Pasta Emporia

Instructions

and Recipes

BPM500

Contents

 

Page

Breville recommends safety first

4

Know your Breville Pasta Emporia

6

Assembling and using your Breville Pasta Emporia

7

Disssembling your Breville Pasta Emporia

12

Care, cleaning and storage

13

Trouble shooting guide

14

Recipes

R1

Congratulations

on the purchase of your new Breville Pasta Emporia

Breville recommends safety first

We at Breville are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions:

IMPORTANT SAFEGUARDS FOR YOUR Breville Pasta Emporia

Carefully read all instructions before operating the Pasta Emporia and save for future reference.

Remove and safely discard any packaging material and promotional labels before using the Pasta Emporia for the first time.

To eliminate a choking hazard for young children, remove and safely discard the protective cover fitted over the pins of the power plug when unpacking this Pasta Emporia for the first time.

Do not place the Pasta Emporia near the edge of a bench top, counter or table during operation. Ensure the surface is level, clean and free of water, flour and other substances.

Do not place this Pasta Emporia on or near a hot gas or electric burner, or where it could touch a heated oven.

Do not place any part of the Pasta Emporia in a gas, electric or microwave oven or on a hot gas or electric burner.

The Pasta Emporia is not intended to be operated by means of an external timer or separate remote control system.

Do not use the Pasta Emporia on a sink drain board

Do not leave the Pasta Emporia unattended when in use.

Do not attempt to operate the Pasta Emporia by any method other than those described in this booklet.

Always ensure the Pasta Emporia is completely assembled before operating. The Pasta Emporia will not operate unless properly assembled.

Do not use attachments other than those provided with the Pasta Emporia.

Ensure the on/off switch has been pressed to the off position, and the Pasta Emporia is switched off at the power outlet and unplugged before assembling.

Vibration during operation may cause the Pasta Emporia to move.

Do not push food into the extrusion chamber with your fingers or other utensils.

Do not place hands, fingers or utensils in the mixing bin of the Pasta Emporia unless the motor and mixing paddle have come to a complete stop. Ensure the ON/OFF switch has been pressed to off and the Pasta Emporia

is switched off at the power outlet and unplugged before removing the mixing bin lid from the mixing bin.

Ensure the motor and the mixing paddle have completely stopped before disassembling.

Ensure the ON/OFF switch has been pressed to off and the appliance is switched off at the power outlet and unplugged when not in use, if left unattended and before disassembling, cleaning or storing.

Do not move the Pasta Emporia whilst in operation.

Do not remove the mixing chamber from the motor base whilst in operation.

Ensure care is taken when emptying the mixing chamber and cleaning the mixing chamber.

Do not use harsh abrasive or caustic cleaners when cleaning this Pasta Emporia.

Keep the appliance clean. Follow the cleaning instructions provided in this book (page 13).

Breville recommends safety first continued

IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES

Fully unwind the power cord before use.

Do not let the power cord hang over the edge of a table counter, touch hot surfaces or become knotted.

To protect against electric shock do not immerse power cord, power plug or motor base in water or any other liquid

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure they do not play with the appliance.

It is recommended to regularly inspect the appliance. Do not use the appliance if power cord, power plug or appliance becomes damaged in any way. Return the entire appliance to the nearest authorised Breville Service Centre for examination and/or repair.

Any maintenance other than cleaning should be performed at an authorised Breville Service Centre.

This appliance is for household use only. Do not use this appliance for anything other than its intended use. Do not use in moving vehicles or boats. Do not use outdoors. Misuse may cause injury.

The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice.

During the mixing process, ingredients may stick to the sides of the mixing chamber. To free sticky ingredients from sticking, press the on/off switch to the ‘OFF’ position and switch the power ‘off’ at the power outlet. Unplug the power cord. Remove mixing chamber lid and use a plastic spatula to scrape down the sides of the mixing chamber. Replace lid before recommencing mixing.

Note

If the mixing paddle become stuck, immediately press the on/off switch to the ‘off’ position and switch the power ‘OFF’ at the power outlet and unplug the power cord. Remove the lid and use a plastic spatula to dislodge the food from mixing paddle. Replace lid before recommencing mixing.

Note

Caution: Ensure that Pasta Emporia is switched off before removing it from the motor base.

Caution: Switch off the Pasta Emporia and disconnect from power supply before changing accessories or approaching parts that move in use.

Know your Breville Pasta Emporia

Built-in removable measuring spoon

Transparent viewing window

8 pasta discs plus biscotti disc

Cord storage

Non-slip feet for stability

Pasta disc varieties

Pasta cutting knife

Pasta disc cleaning accessory

Know your Breville Pasta Emporia continued

Mixing paddle - effectively mixes the dough to the correct consistency

Mixing chamber lid with removable measuring spoon

Mixing chamber - removable, large clear chamber which sits inside the motor base

Extrusion chamber - dough enters this chamber once it has reached the correct consistency and the slider has been pulled

Spiral extruding rod - pushes dough through the extrusion chamber

Disc holder - holds the pasta disc in place. Turn clockwise to tighten and counter clockwise to remove

Steel rod - inserted into the mixing paddle

Slider - keeps dough in the mixing chamber until ready to extrude

Assembling and using your Breville Pasta Emporia

Making homemade pasta is easy with the Pasta Emporio but requires a bit of patience on your first few batches.

Many gourmet recipes can be created using the recipes in this booklet. However, it is recommended to begin by using a basic pasta recipe first to master the pasta making techniques.

It is important to note, that due to the variations of moisture content in different brands of flour, it may be necessary to either add or subtract water from the quantity indicated in the recipe.

Making fresh pasta will not only become easy, it will also become fun and enjoyable.

Buon Appetito!

Push the opposite end onto the back opening of the mixing chamber so that it sits into place.

Insert the thin end of the steel rod into the opening of the mixing paddle. Push the steel rod through until it is fully inserted. You may need to rotate the steel rod slightly in order for it to fit into place.

Before first use

Before using your Breville Pasta Emporia, become familiar with all the parts. Remove and safely discard all packaging materials and promotional labels.

Wash the mixing chamber, chamber lid, pasta discs, mixing paddle, spiral extruding rod, disc holder, steel rod, cleaning tool, knife, measuring spoon and slider in warm, soapy water.

Rinse and dry thoroughly (refer to cleaning, care and storage, page 13).

Step 1

Place the Pasta Emporia on a dry, level work surface.

Step 2 - The mixing chamber

Insert the indented end of the mixing paddle into the front end of the mixing chamber.

Step 3

Guide the mixing chamber into the motor base. Align the steel rod and the clear arrow to the hole at the rear of the motor base.

Twist and slightly lift the mixing paddle until it fits comfortably into the slot. Once correctly inserted, it will “click” into place.

Assembling and using your Breville Pasta Emporia

continued

Step 4 - The spiral extruding rod

Fully insert the steel end of the spiral extruding rod into the opening of the extruding chamber and twist it into place.

When inserted correctly, the spiral extruding rod should not be sticking out of the extruding chamber.

Note

Step 5 - The pasta disc

Select your desired pasta disc and position the disc on the opening of the extrusion chamber so that the grooves of the disc fit comfortably on the three tabs of the extrusion chamber.

Pasta disc will sit firmly in position on the opening of the extrusion chamber when inserted correctly.

Note

Secure the disc holder over the opening of the extrusion chamber by tightening it in a clockwise direction.

Be careful not to over tighten the disc holder.

Note

Step 6 – The slider

Insert the slider (rectangular opening side first) into the slot on the side of the motor base.

Fully push the slider all the way into the motor base. The slider is now in the ‘mixing position’ as labelled on the slider.

Step 7 – Adding ingredients

Insert the power plug into a 230/240 volt power outlet and switch the power outlet on.

Ensure the switch on the motor body is in the ‘OFF’ position before turning the power on at the outlet.

Note

Add flour, egg, oil and/or flavourings (with the exception of water) (using Basic recipe steps 1 and 2). Ensure slider is fully inserted and in the ‘MIXING’ position.

Water should not be added until the mixing process has started and the egg and oil are well combined.

Note

Step 8 - The mixing chamber lid

Ensure the removable measuring spoon is in position.

Insert the chamber lid by tilting it into the slots on the chamber lock. Lock the lid by pushing it down. The lid will ‘click’ into place.

Assembling and using your Breville Pasta Emporia

continued

Measuring spoon can be inserted into the lid at any stage of the assembly process.

Note

The Pasta Emporia has a safety feature so that the appliance will not work unless the mixing chamber and lid have been securely locked into position.

Note

Step 9 - Adding water

Ensure the mixing chamber lid is locked in position and the power outlet is switched on.

Switch the power ‘ON’ using the ON/OFF switch to start the mixing process. Mix for approximately 1 minute.

Warning: The mixing paddles turn extremely fast. Do not place your hands into the mixing chamber until the mixing paddle has completely stopped moving.

Remove the measuring spoon and add water in a slow steady stream using the quantity required in your recipe (see recipe section of this booklet).

Do not add all of the water. Hold about 20% of the water in reserve.

When adding water to the flour mixture, pour water along the entire length of the opening in the lid. This ensures that the water is distributed evenly.

Be sure to replace the removable measuring spoon when you are finished adding ingredients to the mixing chamber. This will prevent ingredients from escaping.

Tip: To prevent ingredients from escaping the mixing chamber while adding water, partially cover the opening with the measuring spoon.

Not all water may need to be added due to varying moisture contents in different flours. Be careful not to add too much water.

Note

Allow the Pasta Emporia to mix and knead the dough for approximately 3 minutes or until the dough resembles small “pea sized” pieces.

It is important to add extra water to the mixing bin slowly so that the correct dough consistency can be achieved. If too much water is added, the dough will begin to stick into a large mass. If this occurs turn the Pasta Emporia to the ‘OFF’ position and push the slider into the closed position so flour cannot enter the chamber. Break the dough up into small pieces, sprinkle it with a little flour and allow the Pasta Emporio to re-mix and knead until it resembles the required “pea sized” pieces of dough (see trouble shooting page 14).

Note

10

Loading...
+ 22 hidden pages