Beko CFMD7852X User Manual

CFMD7852X

Please read this manual first!

Dear Customer,

We hope that your product, which has been produced in a 1st-class manufacturing facility and checked under the most meticulous quality control procedures, will provide you with years of good service.

For this, we recommend you to carefully read the entire manual of your product before using it and keep it at hand for future reference.

This manual

•Will help you use your appliance quickly and safely.

•Read the manual before installing and operating your product.

•Follow the instructions, especially those for safety.

•Keep the manual in an easily accessible place as you may need it later.

•Besides, read also the other documents provided with your product. Please note that this manual may be valid for other models as well.

Symbols and their descriptions

This instruction manual contains the following symbols:

C Important information or useful usage tips.

AWarning against dangerous conditions for life and property.

BWarning against electric voltage.

1 EN

1 Refrigerator	3
2 Warnings	4
Electrical requirements.......................	5
Warning! This appliance must be
earthed..............................................	5
Energy saving tips..............................	5
Compliance with WEEE Directive and
Disposing of the Waste Product: .......	6
Compliance with rohs directive:.........	6
Package information..........................	6
Recommendations for the fresh food
compartment.....................................	7
3 Installation	8
Points to be paid attention to when the
relocation of the cooler/freezer...........	8
Before you start the cooler/freezer,.....8
Electrical connection..........................	8
Disposing of the packaging................	9
Disposing of your old cooler/freezer.	..9
Placing and Installation.......................	9
Adjusting the legs...............................	9
Changing the illumination lamp ..........	9
4 Preparation	10

5 Using your refrigerator	11
Indicator Panel.................................	11
Water Dispenser...............................	16
Freezing fresh food...........................	18
Recommendations for preservation of
frozen food.......................................	18
Defrosting........................................	18
Placing the food...............................	18
Deep-freeze information...................	19
Door Open Warning.........................	19
Egg holder.......................................	20
Blue light..........................................	20
Rotary storage container..................	20
Multi Zone Storage Compartment	..21
Telescopic Drawer ...........................	22
Description and cleaning of odor
filter:.................................................	22
6 Maintenance and
cleaning	23
Protection of plastic surfaces ..........	23
7 Troubleshooting	24

2 EN

1 Refrigerator

Congratulations on your choice a BEKO quality Appliance which has been designed to give you service for many years.

	1
11	2
10
9
15
*8
7	*3
	4
14	5
	6

12

13

13

1.	Egg holder	9.	Illumination lens
2.	Fridge compartment shelf	10.	Adjustable glass shelves
3.	Sliding and Rotary storage containers	11.	Fan
4.	Bottle shelf	12.	Ice container
5.	Multizone Compartment's drawer	13.	Separators
6.	Freezer Compartment's drawer	14.	Freezer compartment
7.	Crisper (Snack Compartment)	15.	Fridge compartment
8.	Bottle holder	* OPTIONAL

CFigures that take place in this instruction manual are schematic and may not correspond exactly with your product. If the subject parts are not included in the product you have

purchased, then it is valid for other models.

3 EN

		2	Warnings
	• Do not connect your appliance to the			• To obtain the best possible performance
				and trouble free operation from your
		electricity supply until all packing and
				appliance it is very important to carefully
		transit protectors have been removed.
				read these instructions.
	• If transported horizontally leave to
				• On delivery, check to make sure that
		stand upright for at least 4 hours before
				the product is not damaged and that all
		switching on to allow compressor oil to
				the parts and accessories are in perfect
		settle
				condition.
	• If you are discarding an old refrigerator
				• Ensure that the plug remains readily
		with a lock or latch fitted to the door,
				accessible. Do not use multiple adapter or
		disable the lock/latch, ensure that it is
				extension cable.
		left in a safe condition to prevent the

	entrapment of young children.	• Failure to observe these instructions may
	• This fridge/freezer must only be used for	invalidate your right to free service during
		the guarantee period.
	its intended purpose i.e the storing and
		• Keep ventilation openings, in the
	freezing of edible foodstuff.
	• Do not dispose of the appliance on a	appliance enclosure or in the built-in
		structure, clear of obstruction.
	fire. At BEKO, the care and protection
		• Do not use mechanical devices or other
	of our environment is an ongoing
	commitment. This appliance which is	means to accelerate the defrosting
	among the latest range introduced is	process, other than those recommended
	particularly environment friendly. Your	by the manufacturer.
	appliance contains non CFC / HFC	• Do not damage the refrigerant circuit.
	natural substances in the cooling system	• Do not use electrical appliances inside
	(Called R600a) and in the insulation
		the food storage compartments of the
	(Called cyclopentane) which are potentially
		appliance, unless they are of the type
	flammable if exposed to fire. Therefore,
		recommended by the manufacturer.
	take care not to damage, the cooling
		• We suggest you keep these instructions in
	circuit / pipes of the appliance in
		a safe place for easy reference.
	transportation and in use. In case of
		• This appliance can be used by children
	damage do not expose the appliance
	to fire or potential ignition source and	aged from 8 years and above and
	immediately ventilate the room where the	persons with reduced physical, sensory or
	appliance is situated.	mental capabilities or lack of experience
	• We suggest you contact your local	and knowledge if they have been given
		supervision or instruction concerning
	authority for disposal information and
		use of the appliance in a safe way and
	facilities available.
		understand the hazards involved. Children
	• See Installation Instructions on page 8 for
		shall not play with the appliance. Cleaning
	information on suitable location.
		and user maintenance shall not be made
		by children without supervision.

4 EN

•Children should be supervised to ensure that they do not play with the appliance.

Electrical requirements

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown on the rating plate inside the appliance corresponds to your electricity supply.

Rating label is on the left hand side of fridge inner liner.

We recommend that this appliance be connected to the mains supply via a

suitable switched and fused socket. The appliance must be positioned so that the plug is accessible.

Should the mains lead of the appliance become damaged or should it need

Replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a BEKO authorised service agent.

Warning! This appliance must be earthed

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord could cause a shock hazard if inserted into a socket elsewhere in the house.

The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been fitted.

Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.

Important! Fitting A Different Plug

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: (See diagram).

1.Connect the green-yellow or green (Earth) wire to the terminal in the plug marked ‘E’

or with the symbol or coloured green and yellow or green.

2.Connect the blue (Neutral) wire to the terminal in the plug marked ‘N’ or coloured black.

3.Connect the brown (Live) wire to the terminal in the plug marked ‘L’ or coloured red.

With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or in the main fuse box. If in doubt contact a qualified electrician.

Energy saving tips

1.Ensure your appliance is installed in a well ventilated area.

2.Ensure the time between buying chilled/ frozen food and placing them in your appliance is kept at minimum, particularly in summer. We recommend you use a cool bag or a special carrier bag to carry perishable food.

GREEN &		6mm.
YELLOW
OR		L
GREEN	32mm.
		BROWN	6mm.
N		OR
		RED
		22mm.
BLUE			12mm.
OR	6mm.
BLACK

CORD GRIP

FUSE	FITTED WITH 1362 13A FUSE ALWAYS BS 1362 REPLACEMENT CARTRIDGE FUSE
	BS FIT

5 EN

3.Do not leave the door (s) of your appliance open longer than necessary and ensure they are closed properly after each opening.

4.Defrost frozen food in the fridge compartment, so that frozen food acts as an ice pack to assist cooling in the fridge.

5.Energy consumption of this appliance is measured while freezer compartment is loaded without use of top shelf lid and the drawers except the bottom drawer. It is advised that freezer compartment is loaded without use of drawers except the bottom drawer in order to achieve maximum loading capacity.

Compliance with WEEE Directive and Disposing of the Waste Product:

This product complies with EU WEEE

Directive (2012/19/EU). This

product bears a classification symbol for waste electrical and electronic equipment (WEEE).

This product has been manufactured with high quality parts and materials which can

be reused and are suitable for recycling. Do not dispose of the waste product with normal domestic and other wastes at the end of its service life. Take it to the collection center for the recycling of electrical and electronic equipment. Please consult your local authorities to learn about these collection centers.

Compliance with rohs directive:

The product you have purchased complies with EU RoHS Directive (2011/65/EU). It does not contain harmful and prohibited materials specified in the Directive.

Package information

Packaging materials		of	the product
are	manufactured	from	recyclable

materials in accordance with our National Environment Regulations. Do not dispose of the packaging materials together with the domestic or other wastes. Take them to the packaging material collection points designated by the local authorities.

6 EN

Recommendations for the fresh food compartment

*optional

• Do not allow the food to touch the temperature sensor in fresh food compartment. To allow the fresh food compartment keep its ideal storage temperature, sensor must not be hindered by food.

• Do not place hot foods in the product.

MILK juice etc.

temperature sensor

food	temperature
	sensor

7 EN

3 Installation

BIn case the information which are given in the user manual are not taken into account, manufacturer will not assume any liability for this.

Points to be paid attention to when the relocation of the cooler/freezer

1.Your cooler/freezer should be unplugged. Before transportation of your cooler/ freezer, it should be emptied and cleaned.

2.Before it is re-packaged, shelves, accessories, crisper, etc. inside your cooler/freezer should be fixed with adhesive tape and secured against impacts. Package should be bound with a thick tape or sound ropes and the transportation rules on the package should be strictly observed.

3.Original packaging and foam materials should be kept for future transportations or moving.

Before you start the cooler/ freezer,

Check the following before you start to use your cooler/freezer:

1.Attach 2 plastic wedges as illustrated below. Plastic wedges are intended to keep the distance which will ensure the air circulation between your cooler/freezer and the wall. (The picture is drawn up as a representation and it is not identical with your product.)

2.Clean the interior of the cooler/freezer as recommended in the “Maintenance and cleaning” section.

3.Connect the plug of the cooler/freezer to the wall socket. When the fridge door is opened, fridge internal lamp will turn on.

4.When the compressor starts to operate, a sound will be heard. The liquid and gases sealed within the refrigeration system may also give rise to noise, even if the compressor is not running and this is quite normal.

5.Front edges of the cooler/freezer may feel warm. This is normal. These areas are designed to be warm to avoid condensation.

Electrical connection

Connect your product to a grounded socket which is being protected by a fuse with the appropriate capacity.

Important:

The connection must be in compliance with national regulations.

•The power plug must be easily accessible after installation.

•Electrical safety of your cooler/freezer shall be guaranteed only if the earth system in your house complies with standards.

8 EN

•The voltage stated on the label located at left inner side of your product should be equal to your network voltage.

•Extension cables and multi plugs must not be used for connection.

BA damaged power cable must be replaced by a qualified electrician.

BProduct must not be operated before it is repaired! There is the risk of electric shock!

Disposing of the packaging

The packing materials may be dangerous for children. Keep the packing materials out of the reach of children or dispose of them by classifying them in accordance with the waste instructions stated by your local authorities. Do not throw away with regular house waste, throw away on packaging pick up spots designated by the local authorities.

The packing of your cooler/freezer is produced from recyclable materials.

Disposing of your old cooler/ freezer

Dispose of your old cooler/freezer without giving any harm to the environment.

•You may consult your authorized dealer or waste collection center of your municipality about the disposal of your cooler/freezer.

Before disposing of your cooler/freezer, cut out the electric plug and, if there are any locks on the door, make them inoperable in order to protect children against any danger.

Placing and Installation

A If the entrance door of the room where the cooler/freezer will be installed is not wide enough for the cooler/freezer to pass through, then call the authorized service to have them remove the doors of your cooler/ freezer and pass it sideways through the door.

1.Install your cooler/freezer to a place that allows ease of use.

2.Keep your cooler/freezer away from heat sources, humid places and direct sunlight.

3.There must be appropriate air ventilation around your cooler/freezer in order to achieve an efficient operation. If the cooler/ freezer is to be placed in a recess in the wall, there must be at least 5 cm distance with the ceiling and at least 5 cm with the wall. Do not place your product on the materials such as rug or carpet.

4.Place your cooler/freezer on an even floor surface to prevent jolts.

Adjusting the legs

If your refrigerator is unbalanced;

You can balance your refrigerator by turning its front legs as illustrated in the figure. The corner where the leg exists is lowered when you turn in the direction of black arrow and raised when you turn in the opposite direction. Taking help from someone to slightly lift the refrigerator will facilitate this process.

Changing the illumination lamp

To change the Bulb/LED used for illumination of your refrigerator, call your Authorized Service.

9 EN