CONTENTS |
|
|
GB |
|
|
|
|
INSTALLATION |
PAGE 11 |
||
|
|
|
|
|
|
|
|
ELECTRICAL CONNECTION |
PAGE 12 |
||
|
|
|
|
|
|
|
|
BEFORE USING THE OVEN |
PAGE 13 |
||
|
|
|
|
|
|
|
|
HINTS FOR PROTECTING THE ENVIRONMENT |
PAGE 13 |
||
|
|
|
|
|
|
|
|
PRECAUTIONS AND GENERAL SUGGESTIONS |
PAGE 13 |
||
|
|
|
|
|
|
|
|
OVEN ACCESSORIES |
PAGE 14 |
||
|
|
|
|
|
|
|
|
OVEN COOKING FUNCTIONS |
PAGE 15 |
||
|
|
|
|
|
|
|
|
CLEANING THE OVEN AND ITS ACCESSORIES |
PAGE 16 |
||
|
|
|
|
|
|
|
|
TROUBLE-SHOOTING GUIDE |
PAGE 17 |
||
|
|
|
|
|
|
|
|
AFTER-SALES SERVICE |
PAGE 18 |
||
|
|
|
|
|
|
|
|
EU DECLARATION OF CONFORMITY |
PAGE 18 |
||
|
|
|
|
10
INSTALLATION
Technical information for the installer
•Unpack the oven to make the connections. Rest the oven on the polystyrene base to avoid damaging it.
•Do not lift the oven by the door handle, but hold it at the sides.
•Make sure that the appliance has not been damaged during transport.
•The dimensions of the oven and the unit are given in the picture at the side.
•Units in contact with the oven must be heat resistant (90°C).
•If plastic laminates or the sealing material are not sufficiently heat resistant, bubbles may form, the surface may be deformed or the coating may detach.
•House the oven in the unit cavity, lifting it at the sides and making sure that the supply cable is not trapped.
•To ensure correct ventilation, respect the ventilation openings indicated in the picture (200 cm2 minimum).
•Fasten the oven to the unit with the screws
(A) as shown.
•The oven can also be fitted under a cooktop.
•There must be a gap of at least 5 mm between the upper edge of the oven and the lower edge of the working surface. This gap must never be closed by strips or unit reinforcing pieces. When the oven is installed, make sure that the sides do not touch the front edges of the unit or the adjacent drawers and door (see picture).
*: 590 For D+CH only
*
11
ELECTRICAL CONNECTION
•Do not switch on the oven before connection is complete.
•Make sure that the installation and the electrical connection are made by a qualified engineer according to the manufacturer’s instructions and the local rules in force.
•The installer is responsible for the correct electrical connection and for observance of the safety rules.
•The appliance must be connected to the mains by means of an omnipolar switching device with a contact opening distance of at least 3 mm.
•Earthing of appliances is obligatory by law.
•Do not use multiple sockets or extensions.
•After the installation, the electrical parts must be inaccessible.
•Make sure that the voltage stated on the appliance rating plate is the same as the voltage in your home.
The rating plate is on the front edge of the oven (visible when the door is open).
12