Release: v1.3 - 2018-04-26
VT-400 HD Installation with FEU
This guide will provide instruction for a VT-400 HD Installation with a FEU (Fleet Expansion Unit)
© 2018 |
Page 1 of 9 |
Release: v1.3 - 2018-04-26
INTRODUCTION
Some parts, ex. diagnostic cable, are vehicle specific. For this installation example we will be using a standard Type 1 9 pin diagnostic cable. While your installation may require a different diagnostic cable, the following installation steps will still apply. We provide separate guides for any exceptions.
Review the link below before installation
Telogis General Best Practices
PARTS:
VT-400 (1)
Diagnostic cable - Vt-400 - HD - Type 1 9 Pin - Standard (1)
© 2018 |
Page 2 of 9 |
Release: v1.3 - 2018-04-26
Step 1 — Part Identification
Vt-400 device
Harness endcap
Diagnostic cable (need to update with correct FEU cable)
This example is a standard type 1 9 pin
FEU (Fleet Expansion Unit)
© 2018 |
Page 3 of 9 |