Vdo dayton CD 2204, CD 2104, CD 2304 MP3 User Manual
User manual
Mode d’emploi
Bedienungsanleitung
Gebruiksaanwijzing
Istruzioni d’uso
Instrucciones de manejo
Modo de emprego
Bruksanvisning
Betjeningsvejledning
Käyttöohje
3140 165 21871.2
www.vdodayton.com
3
A
2
4
11
3
B
C
D
1
7
6
8
9
3
10
10
10
2
13
12
5
12
E
1
3
SETUP
SETUP
LOUND OFF
T V
T FAD -7
EON OFF
START 1
MUTE 0
TEL OFF MUTE-LO
SETCLOCK
CD -2
CDRW ON
LOGIC ON
LED ON
SCAN OFF
PRE SCAN
MWL
LOC TUNE
EDI ON
NOSCROLL*
SERV OFF
KM
k KM
* Depending on version
4
A
A
...
...
...
...
...
...
... ...
...
... ...
...
MANCLOCKRDSCLOCK
...
...
... ...
... ...
CDRW OFF
...
LOGIC OFF
...
...
...
...
...
...
...
...
...
...
...
...
...
... ...
SCR ONCE*
...
...
...
...
- LOW
TAVOL 2OL 0 TAVOL 3
T FAD -6
A
EON LOC
START 2 START 3
MUTE 1
BEEP 1 BEEP 2BEEP OFF BEEP 5BEEP 4BEEP 3
S-VOL 1 S-VOL 2SVOL OFF S-VOL 4S-VOL 3
CLK OFFCLK ON
24HCLOCK12HCLOCK
CD -1 CD +2CD +1CD 0
MP3 -1*MP3 -2* MP3 +2*MP3 +1*MP3 0*
LED OFF
AMERICA ASIAEUROPE
AUTOTUNEMAN. TUNE
RDS OFFRDS ON
REG ON REG OFFREG AUTO
AF OFFAF ON
SCAN 5
FRQ SCAN
MWLW OFFW ON
AM OFFAM ON
NEWS OFFNEWS ON
DX TUNE
EDI OFF
SERV ON
MILE
k MILE
- MID
...
...
...
...
...
...
T FAD -5
A
EON DX
MUTE 2
...
.................................................................
.................................................................
.................................................................
.................................................................
...
...
MUTE-HI
...
... ...
... ...
...
...
SCAN 10
...
OPEL _8 OPEL _10
...
...
...
SCROLL*
- HIGH
SCAN 20
TAVOL 47
T FAD +7
A
START 47
MUTE 16
...
...
...
BEFORE YOU START....
Thank you for purchasing this product which has
been designed and manufactured to the
highest standards and subjected to rigorous
testing.
Kindly familiarise yourself with the product by
reading this user manual. Keep this manual handy
in your car for future reference.
This manual covers the following models:
CD 2104, CD 2204, CD 2304 MP3
This main difference between them are as follows:
MP3 and CD TEXT-for CD 2304MP3 only
ENVIRONMENT
This booklet is printed on low-chlorine recyclable
paper.
IMPORTANT
This device has been designed and produced
according to applicable Safety Regulations. Please
read carefully the instruction manual and use the
device as intended.
PREVENTIVE MAINTENANCE
Cleaning the connectors
To ensure good connection between the set and
the detachable front, it is advisable to clean the
connectors with a cotton swab slightly moistened
with cleaning fluid or alcohol periodically.
CONTENTS PAGE
INSTALLATION ................................................ 5
PREPARATION ................................................ 5
MOUNTING ..................................................... 7
FRONT PANEL PRESENTATION .................... 8
SECURITY ....................................................... 9
AUDIO.............................................................. 9
RADIO............................................................. 10
RADIO DATA SYSTEM (RDS) ON FM ........... 11
CD, MP3* ........................................................ 12
SPECIAL FUNCTIONS ................................... 13
SETUP ............................................................14
TROUBLE SHOOTING ................................... 16
INSTALLATION
If your car is equipped with ISO connectors, simply
insert them in the connectors of the car radio. If
not, you can use an adaptor cable. Ensure all
cables are installed so that they cannot be damaged
by sharp edges or moving parts.
PREPARATION
Voltage and polarity: The set must be connected
to a 12V car battery with negative terminal to earth
(car chassis). Installation in vehicles not fulfilling
these requirements could result in malfunction,
damage or fire.
Warning: To prevent short-circuiting,
disconnect the negative car battery terminal
until the set has been mounted and connected (fig.1 See separate installation card).
CONNECTOR A** (fig. 2)
Power supply connections
• Red wire A7 : Connect to a permanent 12V
supply. This is the main power supply. Ensure
this connection can handle a current of 10A.
•Yellow/red wire A4 : Connect to a switched 12V
supply (switched on/off by car ignition).
• Brown wire A8: Connect to earth (car chassis).
Optional connections (fig. 2)
• SMART Volume
volume control which automatically adjust the
volume depending on your car's speed.
• Connect pin A1 to a signal from the speedometer
of your car. Some cars are already prepared for
it (e.g. certain VW & Vauxhall/Opel cars), please
consult your dealer.
If not, you may need a more detailed installation
requiring extra equipment to enable your car to
become compatible.
* Depending on version
** For this accessory, see your dealer Complies with 21 CFR 1040.10
: Intelligent
5
Loading...