ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ
ENGLISH
PУССКИЙ
Кондиционер (сплит-система) для бытового использования
Внутренний блок
RAS-07, 10, 13, 16EKV
Наружный блок
RAS-07, 10, 13, 16EAV
1110255116
1110255116_EN.indd 1 |
2/13/13 2:47 PM |
PRECAUTIONS FOR SAFETY
|
● Do not install, repair, open or remove the cover. It may |
|
expose you to dangerous voltages. Ask the dealer or the |
|
specialist to do this. |
0 |
● Turning off the power supply will not prevent potential |
electric shock. |
|
DANGER |
● The appliance shall be installed in accordance with |
national wiring regulation. |
|
|
● Means for disconnection from the supply having a |
|
contact separation of at least 3 mm in all poles must be |
|
incorporated in the fixed wiring. |
|
● Do not expose your body directly to cool air for a long |
|
time. |
|
● Do not insert your finger or any article into the air inlet/ |
|
outlet. |
|
● When an abnormality (burning smell, etc.) occurs, stop |
|
the air conditioner and disconnect the power supply or |
|
turn off the breaker. |
|
● This appliance is not intended for use by persons |
0 |
(including children) with reduced physical, sensory or |
mental capabilities, or lack of experience and knowledge, |
|
WARNING |
unless they have been given supervision or instruction |
concerning use of the appliance by a person responsible |
|
|
for their safety. |
|
● Children should be supervised to ensure that they do not |
|
play with the appliance. |
|
● Do not use any refrigerant different from the one specified |
|
for complement or replacement. Otherwise, abnormally |
|
high pressure may be generated in the refrigeration |
|
cycle, which may result in a failure or explosion of the |
|
product or an injury to your body. |
|
● Do not wash the unit with water. It may cause an electric |
|
shock. |
|
● Do not use this air conditioner for other purposes such as |
|
preserving food, breeding animal, etc. |
|
● Do not step or put anything on the indoor/outdoor unit. It |
|
may cause an injury or damage the unit. |
|
● Do not touch aluminium fin because it may cause an |
0 |
injury. |
● Before cleaning the unit, turn off the main switch or the |
|
CAUTION |
circuit breaker. |
● When the unit won’t be used for a long time, turn off the |
|
|
main switch or the circuit breaker. |
|
● It is recommended that maintenance be performed by |
|
a specialist when the unit has been operated for a long |
|
time. |
|
● The manufacturer shall not assume any liability for the |
|
damage caused by not observing the description of this |
|
manual. |
1 INDOOR UNIT DISPLAY
1 TIMER (Yellow)
2 OPERATION (Green)
3 RESET button
2 PREPARATION BEFORE USE
Preparing Filters
1. Open the air inlet grille and remove the air filters.
2. Attach the filters. (see detail in the accessory sheet).
Loading Batteries (when use wireless operation.)
1. Remove the slide cover.
2. Insert 2 new batteries (AAA type) following the (+) and (–) positions.
Remote Control Reset
1. Remove the batteries.
2. Press . 3. Insert the batteries.
3 AIRFLOW DIRECTION
|
|
|
|
|
1 |
Press |
FIX |
: Move the louver in |
|
|
|
|||
|
the desired vertical direction. |
|
||
|
|
|
|
|
|
|
|
|
|
2 |
Press |
SWING |
: Swing the air |
|
|
||||
automatically and press again to |
|
|||
|
stop. |
|
|
|
|
|
|
|
|
3 |
For horizontal direction, adjust |
|
||
manually. |
|
|
|
|
|
|
|
|
|
Note:
●Do not move the louver manually by others.
●The louver may automation positioning by some operation mode.
4 REMOTE CONTROL
1 Infrared signal emitter
2 Start/Stop button
3 Mode select button (MODE)
4 Temperature button (TEMP)
5 Fan speed button (FAN)
6 Swing louver button (SWING)
7 Set louver button (FIX)
8 Off timer button (OFF)
9 High power button (Hi-POWER) ! Economy button (ECO)
" Clear button (CLEAR)
# Check button (CHECK)
|
1 |
|
3 |
4 |
|
2 |
6 |
|
7 |
||
5 |
||
9 |
||
! |
||
8 |
||
" |
||
# |
5 AUTOMATIC OPERATION
To automatically select cooling, heating, or fan only operation
1.Press MODE : Select A.
2.Press : Set the desired temperature.
3.Press FAN : Select AUTO, LOW , LOW+ , MED , MED+ , or HIGH .
6COOLING / HEATING / FAN ONLY OPERATION
1.Press MODE : Select Cool , Heat , or Fan only .
2.Press : Set the desired temperature. Cooling: Min. 17°C, Heating: Max. 30°C, Fan Only: No temperature indication
3.Press FAN : Select AUTO, LOW , LOW+ , MED , MED+ , or HIGH .
7DRY OPERATION
For dehumidification, a moderate cooling performance is controlled automatically.
1.Press MODE : Select Dry .
2.Press : Set the desired temperature.
8 Hi-POWER OPERATION
To automatically control room temperature and airflow for faster cooling or heating operation (except in DRY and FAN ONLY mode)
Press Hi POWER : Start and stop the operation.
1110255116_EN.indd 2 |
2/13/13 2:48 PM |