Teac SR-L7XI Owner's Manual

Alarm Clock Radio with Dock for iPod

Thanks for buying a TEAC. Read this manual carefully to get the
best performance from this unit.

Safety Considerations

 The apparatus shall not be exposed to dripping or splashing and that no

objects filled with liquids, such as vases, shall be placed on apparatus.

 To be completely disconnect the power input, the mains plug of

apparatus shall be disconnected from the mains.

 The mains plug of apparatus should not be obstructed OR should be

easily accessed during intended use.

 The marking information is located at the bottom of apparatus.

 Battery shall not be exposed to excessive heat such as sunshine, fire or

the like.

 Minimum distances around the apparatus for sufficient ventilation.

 The ventilation should not be impeded by covering the ventilation

openings with items, such as newspapers, table-cloths, curtains, etc;

 No naked flame sources such as lighted candles should be placed on

the apparatus.



Attention should be drawn to environmental aspects of battery disposal;



The use of apparatus in moderate climate.

Electrical Information

Make sure that the voltage of your electricity supply is the same as that indicated on
the rating plate of the power supply unit supplied with your product. It requires a
compatible mains supply. Do not use any other supply.

1

IMPORTANT SAFETY

AC Operation

Your unit requires a mains supply. Please ensure that your mains supply is compatible before use.
Insert the mains cable into the power socket at the rear of the unit, and then insert the main plug into a
main supply socket. Press the POWER Button to ON position to operate the unit.

Use Aux In

Press Power Button to turn on the unit and select the Function Switch to iPod mode,
simply connect an audio cable (not included) from the AUX IN jacks on this unit to
external unit’s LINE OUT jacks and press the Function Button to AUX mode. This will
allow you to broadcast the external unit’s sound through this unit’s speakers.

Warning!

If connecting to the headphone output of an audio source, the source’s volume
controls may need to be adjusted for optimal sound.

Adjusting the Volume Sound

Rotate the Volume Buttons to increase / decrease the volume sound.

Dimmer Function

Slide the Dimmer Switch to HIGH / LOW dimmer to select LED brightness

Battery Operation (DC 9V) – For Clock Backup

The Battery Back-Up will save the clock and program settings in case of power outage.
The display / unit will not be active without AC power (batteries not included).

How to install or remove the battery : Remove the battery compartment cover on the
back of the unit by carefully pushing one lug of the battery cover. The battery cover can
then be lifted away. Fit 9V batteries (not included), referring to the polarity markings
inside the battery compartment.. Finally, replace the cover. For battery operation, switch
off the mains supply and remove the cable from the power socket, battery operation will
be selected automatically.

Warning!

Danger of explosion if batteries are incorrectly replaced.
Replace only with the same equivalent type.

2

POWER SOURCE